Hey guys, I'm really in a bad spot here.
So I installed CM10 on a GT-i9000, worked fine except for the hardware buttons not working. So from there, I decided to install SlimBean (A foolish mistake that I thought was foolproof). And boom, now I am here, stuck in a CWM bootloop, and I've tried factory resetting and all, still boots the same.
I've tried installing other roms, sometimes it reboots during installation and doesn't complete, and even if it does complete, same problem, it boots into CWM. And I've noticed a new Samsung AnyCall Boot logo every since I tried SlimBean.
I've tried updating the kernel, no luck. I bought a download mode jig, but windows does not detect the Galaxy S in download mode with Kies installed. (I think I disabled USB Debugging in CM10)
Any suggestions? This is really stressing me out. I'm prepared to use odin, but download mode is not recognized on my PC.
slicer91 said:
Hey guys, I'm really in a bad spot here.
So I installed CM10 on a GT-i9000, worked fine except for the hardware buttons not working. So from there, I decided to install SlimBean (A foolish mistake that I thought was foolproof). And boom, now I am here, stuck in a CWM bootloop, and I've tried factory resetting and all, still boots the same.
I've tried installing other roms, sometimes it reboots during installation and doesn't complete, and even if it does complete, same problem, it boots into CWM. And I've noticed a new Samsung AnyCall Boot logo every since I tried SlimBean.
I've tried updating the kernel, no luck. I bought a download mode jig, but windows does not detect the Galaxy S in download mode with Kies installed. (I think I disabled USB Debugging in CM10)
Any suggestions? This is really stressing me out. I'm prepared to use odin, but download mode is not recognized on my PC.
Click to expand...
Click to collapse
You will hadware buttons failure when you flash a i9000 ROM on an Anycall M110S ( Korean Galaxy S) , so I am curious are you sure your phone is not an Anycall M110S? since you also getting Anycall boot screen...sounds odd, that i9000 will do that.
For USB connection problems , just try link on Quick Fixes and Solutions link below
slicer91 said:
Hey guys, I'm really in a bad spot here.
So I installed CM10 on a GT-i9000, worked fine except for the hardware buttons not working. So from there, I decided to install SlimBean (A foolish mistake that I thought was foolproof). And boom, now I am here, stuck in a CWM bootloop, and I've tried factory resetting and all, still boots the same.
I've tried installing other roms, sometimes it reboots during installation and doesn't complete, and even if it does complete, same problem, it boots into CWM. And I've noticed a new Samsung AnyCall Boot logo every since I tried SlimBean.
I've tried updating the kernel, no luck. I bought a download mode jig, but windows does not detect the Galaxy S in download mode with Kies installed. (I think I disabled USB Debugging in CM10)
Any suggestions? This is really stressing me out. I'm prepared to use odin, but download mode is not recognized on my PC.
Click to expand...
Click to collapse
Go back your original firmware...
Any updates to this?
I am having a similar situation. I tried flashing ICS ROM to my Anycall Samsung Galaxy S GT-I9000. It is now stuck in recovery mode. I tried doing factory reset and wiping the cache and dalvik cache and tried reflashing. Everything goes fine but gets stuck in the recovery mode - more correctly in download mode but the download mode logo flashes twices and enters to recovery mode.
Any possible solutions to get me out of this mess?
Thanks,
Sid
your problem will be solved with this post:
http://forum.xda-developers.com/showpost.php?p=24831012&postcount=1330
Edit : above url is for S+ your device is S , sorry .
Thanks, but anything similar for Galaxy S? And remember my download mode does not stay, if flashes twice and runs into recovery mode. So if your solution is something to do in recovery mode it will be helpful (or if your solution is to first make me stay on download mode and then flash something using odin I will be thankful)
Regards,
Sid
sidswami said:
I tried flashing ICS ROM to my Anycall Samsung Galaxy S GT-I9000.
Click to expand...
Click to collapse
Check your Model, Anycal does not make GT I9000, it makes only M110S and firmwares / solutions for them vary.
If you have Anycal M110S visit PIT STOP link below to solve your problems
Check Here to chose your forum/Guide by Version of your phone or you will have more problems by using wrong solutions due to different versions of Galaxy S
you can get a rescue kit from My Android Collections and or a solution from My Android Solutions
But First powerdown, pull out Battery, SIM CARD, and EXT.SD card, press power button for a minute, than powerup without SIM and Ext.SD Card....Do remember to backup your contacts, data, images etc and also your EFS folder before flashing a ROM and make sure you have more than 50% battery charge before you attempt any sort of flashing.
worked for me
Hi..also had the boot loop...
fixed that easily by removing the accu..
removing external SD !!
Thats it !
Worked for me !
Later on I inserted the SD again..and everythings fine
beben3 said:
Hi..also had the boot loop...
fixed that easily by removing the accu..
removing external SD !!
Thats it !
Worked for me !
Later on I inserted the SD again..and everythings fine
Click to expand...
Click to collapse
Glad that worked for you, but I for some reason can't be so lucky. I tried to also flash CWM 10 but after the home key not working I decided to flash Slim Bean and now I am stuck. My phone isn't even recognized by Odin any more and I have tried different USB ports and even my laptop with Heimdall. I don't know what to do at this point, but any kind of suggestions would be great. Usually when I get stuck I just flash back to Stock and start all over with a new ROM or kernel but I have no idea where to go from this point.
hello there fellow xda users,
i currently installed an app that messed my phone up so i went to reinstall the firmware via odin v1.87 and at first it went into a boot loop, i flashed it again with a different base band version and then it does the samsung animation and sticks at the samsung logo and refuses to respond. any help would be appreciated and i can also get into recovery and odin mode if that helps any :'(
remember its an s5830i.
go through this link
http://forum.xda-developers.com/showthread.php?t=1891818
Recently I bought my phone and installed ROM manager which i then proceeded to install CWM recovery and since there was no choice for my phone i chose the first one. It then asked me to reboot and i accepted and then it went all black out. It could not accept any key combination.Then after resurrection it could enter download mode but would end up not flashing but with an error message BML FORMAT FAIL-90220000. I then flashed arm11boot for gt s5570 and it flashed successfully but on restarting it went to another problem-bootloop. I tried re-flashing but it it came up with the bml error again, so i again flashed arm11boot and it went black dead..... it wont enter download mode but can enter recovery because when i press the recovery key combination it installs around 4 drivers but none is odin's. the screen lights up when i switch it on and can charge the battery but whenever i try to flash any rom it gets stuck at setup connection. Please help me ..........
Oh... C'mon ! We already talk about this... No ROM Manager for Mini ! :silly:
NEWBIE & NOOBS don't be such Lazy Buns !
If you want resolve this problem, Go to SSC (Samsung Service Center) and act KNOWN Nothing about flashing, rooting, etc.
hi i really really really need your urgent help :crying: i have a galaxy mini s5570 i rooted it succesfully with upd_1.zip file and then i tried to install the cwm 5.0.2.8 it looked like it actually installed in recovery but when i tried to boot the phone it just stuck at Samsung logo, i tried to open recovery by (power and home buttons) but recover doesn't show up !! only black screen and when i put it to charge it only shows that black screen too
so i put it into download mode and tried to flash stock rom with odin but it never gets completed always gets stuck at (setup connection..)
i tried 3 computers, odin 1.85 and 3.04, 2 usb cables but i didn4t solve this problem !
i managed to solve the problem using Odin4.3 :victory:
Hello everyone I am sure that there is a lot of this thread going.
But I think mine is even worse.
the problem:
I rooted the device, everything worked fine ( did it with card reader - because my pc can not recognize the device had the problem a long time ago, somehow it worked then, but does not now, giving me the code 10 and 43
I think my USB port on the SAMSUNG might be damaged, because it does recharge but wont connect at all, tried kies, tried all the debugging modes, drivers, turning off the computer, rebooting all that stuff..)
The main problem is I flashed the cwm, rebooted, worked fine, then I clicked the do Backup thing and from then I can only go to yellow "downloading" or samsung logo, cannot even use that "Odin" because my USB is apparently damaged.. Any Ideas at all other than taking the phone and throwing it into the dumpster?
it is gt-s5830
my system is Win7-64bit
any help will be deeply appreciated ...
sincerely Fariel2012
Samsung logo freeze, cant recovery, can download mode (cant join to pc)
try with different usb cable
daniga74
Fariel2012 said:
Hello everyone I am sure that there is a lot of this thread going.
But I think mine is even worse.
the problem:
I rooted the device, everything worked fine ( did it with card reader - because my pc can not recognize the device had the problem a long time ago, somehow it worked then, but does not now, giving me the code 10 and 43
I think my USB port on the SAMSUNG might be damaged, because it does recharge but wont connect at all, tried kies, tried all the debugging modes, drivers, turning off the computer, rebooting all that stuff..)
The main problem is I flashed the cwm, rebooted, worked fine, then I clicked the do Backup thing and from then I can only go to yellow "downloading" or samsung logo, cannot even use that "Odin" because my USB is apparently damaged.. Any Ideas at all other than taking the phone and throwing it into the dumpster?
it is gt-s5830
my system is Win7-64bit
any help will be deeply appreciated ...
sincerely Fariel2012
Click to expand...
Click to collapse
Hi there
you will need to give a usb jigg service to your device and then flsah it back to stock using odin
SGA s5830 stuck @ boot logo
I follwed these steps before it stuck @ boot logo
1 rooted phone through root_S5830.zip file
2 then used 6.0.4.6-cooper_fix.zip cwm recovery
3 decided to flash Touchwiz-Resurrected_ROM_V1.0.zip rom
4 followed all steps to flash thrrough CWM recovery
phone reebots samsung.com logo>> samsung boot animation shows up>>samsung name appears again keeps glowing and phone restarts!!!
after it I tried 6-7 different roms then i tried to flash through odin but wasnt able to do so but failed the device showed up in odin but wasnt able to flash stock rom
then i decided to go for Phil touch recovery I installed Philtouch recovery and tried to flash a custom rom now I'm stuck again at boot name GALAXY ACE s5830 nothing goes further!!!
I searched over XDA and some guy quoted this problem is solvable by using odin and putting phone in downloading mode (vol- button+home button + Power on ) I am able to put my phone in downloading mode, but when i conncet it to PC it says USB device not recognized WTF!!!!!???? 10 mins ago i connected my Phone using same cable same port same odin now this ***** appears ???
I swapped PC's, Cables, ports everything nothings working , phone wont start stuck @ boot logo pls help ASAP :crying:
That's it.. You have hard bricked your phone that's dead recovery and dead download mode. Give your phone the usb jigg service which will force it to go to either the download mode or the recovery mode whatever you want.