Hello guys
Last week I changed the battery of my Z1. I did normal charge cycles during this time and I have to say that I really feel the difference with the old battery (that was dying because it did not mantain the charge).
This happened to me today after I put the phone in charge and sometimes during the week I noticed that the system does not always marked correctly the % remaining. In your opinion should I calibrate the battery? (cause i'm gonna change rom )
Thanks in advance,
Best regards
Related
The last couple of days I've got a weird problem. When my battery is fully charged everything seems okay and it drains in normal speed (compared to stock).
But when my phone runs out off battery and i start to charge in the beginning everything seems fine.
But suddenly it can go from 75 to 100% in 1 minute.When i look at the stats in MIUI ROM it seems like it's not at same height as it was the last day of 100%. Maybe only 80%.
Sorry for my bad English, but i hope it makes sense.
I've wiped battery stats in CWM. But is it possible that the phone actually is only 80% charged, even though the indicator shows 100% after wipe?
Because if the ROM think the battery is charged and wipe stats it will afterwards only charge to that point and the battery maximum will decrease over days?
If that's possible, how do i full charge the battery? Just leave it in the charger or?
I hope you can understand what I mean.
Thanks in advance
Hello
Does your phone charge to fx 75% and after that doesnt get higher until after you restart the phone?
Sent from my LG-P990 using XDA App
CescMusta said:
Hello
Does your phone charge to fx 75% and after that doesnt get higher until after you restart the phone?
Sent from my LG-P990 using XDA App
Click to expand...
Click to collapse
Yes excactly. But the numbers differs.
Today it charged to 100% though.
Got the same problem?
Sent from my Optimus 2X using XDA App
have you try calibrate your batt again
yes my friend have this problem too, maybe there is software bug
After flashing Celebration HD 2.0.1b I first used Battery Calibration from market to wipe battery stats. Afterwards the battery indicator problems started.
Yesterday i decided to wipe battery stats manually in CWM and drain to phone to 2% before charging, and afterwards I was able to fully charge the phone.
So maybe the bug in is Battery Calibration app?
I decided to install Juice Plotter to monitor the battery and compare it to one build in in MIUI. Just to get some more data.
Hello again
Yes i had the same problem as you, with my previosly 2 lg optimus 2x, and returned them because of the problem you mentioned. I am on the third op2x and luckily this work good
So if i were in your position i would try to go to the dealer and shift the phone with another lg optimus 2x.
Best regards
Sent from my LG-P990 using XDA App
CescMusta said:
So if i were in your position i would try to go to the dealer and shift the phone with another lg optimus 2x.
Click to expand...
Click to collapse
The user said that he started to have problem after a new rom and wiping battery stats, changing phone for that is not the smartest move at all. Is like changing phone because your rom doesn't work.
I have a similar problem, after you wipe battery stats you don't have a reliable indicator, for me the phone took 3 hours to get from 99 to 100%.
I also noticed that my miui ( 1.8.5 same for 1.7.29) doesn't update battery stats when the screen is off so all those plotter don't work, and i think this messes up with the battery indicator (I guess the phone doesn't have enough data to make a decent estimate)
I think is miui + wipe battery stats that can be problematic
I know that but i am just saying that i also had the same problem with the stock rom.
Best regards
Sent from my LG-P990 using XDA App
How old is the battery? How many cycles does it have?
I know from laptop Li-Ion batteries that the voltage vs. capacity is not linear.
When discharging, the voltage will steadily drop to a "wear-level" where it will jump to an almost depleted level. When charging, this "wear-level" will be at the top.
Why I am telling this? Because if this mapping is kept in SW and you wiped it, Android needs to relearn it again. So at 1st complete charging/discharging you would see a % sudden drop/raise, but at the next cycles it would be linear with time (although the total time will be smaller than a new battery).
When laptop/phone battery tips talk about calibration, it is so whoever monitors the voltage (circuit in battery or SW) to know were the wear drop will be, so your estimates to be better.
As an example, I had a very old Thinkpad that did not have any calibration, and it would discharge to about 40% and drop to 5% within seconds. But when charging, it would raise steadily to 70% (from that 5%) but 70% to 95% in seconds. After years of use, that percentage gap would just increase (40-5 got 60-5, 70-5 on discharging).
PS: my current Thinkpad has 4 years and the battery capacity is 49% with 150 cycles. But this one has a nice feature where if the battery was above a certain percentage, plugging AC would not charge it (and thus save a few cycles). I used it set at 70%.
PS: LiIon batteries have cycle count, heat and time as main enemies. Also don't like prolonged (think storage) low charge.
battery on wallcharger screen of error
CenaDK said:
The last couple of days I've got a weird problem. When my battery is fully charged everything seems okay and it drains in normal speed (compared to stock).
But when my phone runs out off battery and i start to charge in the beginning everything seems fine.
But suddenly it can go from 75 to 100% in 1 minute.When i look at the stats in MIUI ROM it seems like it's not at same height as it was the last day of 100%. Maybe only 80%.
Sorry for my bad English, but i hope it makes sense.
I've wiped battery stats in CWM. But is it possible that the phone actually is only 80% charged, even though the indicator shows 100% after wipe?
Because if the ROM think the battery is charged and wipe stats it will afterwards only charge to that point and the battery maximum will decrease over days?
If that's possible, how do i full charge the battery? Just leave it in the charger or?
I hope you can understand what I mean.
Thanks in advance
Click to expand...
Click to collapse
I have when i turn off my fhone and i charge it it shows a battery icon whit an error in it ics lgp990 please help i dont no what tho do
Hi there
i bet this is the 1290312 thread about batteries but i can't find the one that suits me.
so here is the deal with my alfs06 and gingerdx021 x8: when i am charging my phone, the percentage goes high reeealy fast. when it reaches 99% it stays there for a while (30min) and after that it is completely charged.
i was thinking that i have a problem with battery calibration, but i fully charged my battery and then deleted battery stats in CWM, but still no result. what do you guys suggest?
fact: if my battery display is, let's say 16%, if i reboot my phone it goes to 19%.
after batterystat wipe you must charge the battery 3 4 times to calibrate it. it will takes a while.
thanks for your reply. i will charge it and post after a few days if the issue persists.
hello
i just wanna ask something about my battery life on my x8...here's how it goes first i fully charge my battery up to 100% until it says on status battery full...then i unplugged it..after it i texted for a few minutes...and i check the status of my battery and it says: 28 mins 23s on battery..my battery is on 96%..is this normal.? or somethings draining my battery,?
i use minicm7 2.2
this is normal since battery is heating itself while charging, and when it cools down it shows less percentage of itself... to maximaze your current battery life, calibrate the battery:
1. charge it to 100% no more no less
2. leave the charger PLUGGED IN, and reboot to CWM
3. there you should find somewhere under options or advanced "wipe battery stats", and you press that
4. reboot your device and when it starts up it will show about 91%, charge it to 100% and you have your battery calibrated
NOTE: the charger is always plugged in
ok thanks i'll try it... one question should i drain the battery before calibrating it.?..as in zero percent??
menos_grande said:
ok thanks i'll try it... one question should i drain the battery before calibrating it.?..as in zero percent??
Click to expand...
Click to collapse
Yes , that is recommended.
Also , one advice from me.
Even after calibration , whenever your phone says 100% charged , reboot it while the charger is plugged. You will get the exact battery charge after reboot.
Do it every time your recharge your phone.
Then stop rebooting when you get a 99% or 100% after a fresh reboot. Trust me , it helps.
ok thanks for the advice i'll try that too...
it is normal dude ....mine is giving 1day on heavy use
use zepplinrox's supercharge script...it really made a CONSIDERABLE change to m battery usage time
I have one question: "Why my battery is giving 6-8h. My battery 2 days ago giving 24 and more hour." Sorry for my English, but i am from Poland
what happened 2 days ago? did you install new ROM?
The OP might not have needed to install a new ROM, just an APP or maybe just a combination of APPs running. My phone sometimes canes the battery in a couple of hours from 50% to nothing for no apparent reason. On both stock and custom (actually better battery life on custom) it lasts about a day but sometimes about 6 hours! Not sure what is going on as this happened on both the stock 1.6, 2.1 and the custom 2.3.4!
Hi,
So I bought an Anker 1800mah battery about two months ago, thought that would improve battery life.
Thing is, even though I own the I9000 a very long time, I don't know how battery life should be.
So my question is...
For example, if I have data and GPS on and screen on, is it normal that I get 1% drain every 1.5-2 minutes?
Using ICS CM9.
TheeWolf said:
Hi,
So I bought an Anker 1800mah battery about two months ago, thought that would improve battery life.
Thing is, even though I own the I9000 a very long time, I don't know how battery life should be.
So my question is...
For example, if I have data and GPS on and screen on, is it normal that I get 1% drain every 1.5-2 minutes?
Using ICS CM9.
Click to expand...
Click to collapse
did you try your old battery for comparison ?
maybe its the battery and not the phone
btw what rom are you running on?
TheeWolf said:
Hi,
So I bought an Anker 1800mah battery about two months ago, thought that would improve battery life.
Thing is, even though I own the I9000 a very long time, I don't know how battery life should be.
So my question is...
For example, if I have data and GPS on and screen on, is it normal that I get 1% drain every 1.5-2 minutes?
Using ICS CM9.
Click to expand...
Click to collapse
Turn gps off and set brightness to around 20%. You should then lose 1% roughly every 3:30 - 4:00 minutes.
Weird I lose 1% every 10 min sometimes more
Sent from my Awesome I9000 running Slim Bean
Hi all,
First, from what I remember, my old battery acted somewhat the same. Also, I used it for a year and a half, and have totally destroyed it because of all the calibrations. By a calibration I mean draining the battery to 0%, charging to 100%, doing it about 3-4 times... Only later I have learned that it is not healthy to the battery to do that so many times. That's why I only did this 3 times with my new battery (Manufacturer instructions).
Now, thing is, I gave the example with the data and GPS on and screen on because I used GPS for navigations a lot of times. So, I can't turn off GPS. About the brightness, its set to automatic all the time, so I see no reason to modify it myself.
I'm currently using CM9 Blueberry edition but I'm planning to change to JB in a few days. Even though I doubt it, any chance battery life will improve with JB?
Latrop, with the same settings? Having data + GPS + screen on all the time (10 min)? Are you sure?
Mine did not sure bout yours
Sent from my Awesome I9000 running Slim Bean
Hey guys, its my first post on this forum (or on any forum for that matter) so I apologize if this is in the wrong section . But recently I've been having a problem with my S3 mini and hoped I could get some help on here. So a few days ago I got a 4000mAh - 3.7V extended battery for my phone because my old one had broken. The old battery was the stock battery that came with the phone. Before I bought the new battery I also installed the PacmanROM on my android. But since I got the battery the percentage my android displays has been completely wrong. I'm pretty sure that the battery is fully charged after over 16 hours of charging but the percentage the phone displays is only around 65% and no matter how long I charge it the percentage never reaches 100 and it will stay on a certain value that will randomly fluctuate if I restart the device. So is there anyway to make my phone display the correct percentage? Thanks for your help!
In my opinion, extended batteries are more trouble than they're worth. I have dabbled with them but all have failed at some point (even brand new). If you put the battery on a flat surface and it 'wobbles' at all then its duff. I use stock batteries. Sorry if this is not what you want as an answer but just my experience with extended batteries.
Sent from my GT-I8190N running CandyKat
Thanks for the input anyway! I've never tried any other extended batteries so I ignorantly decided to get one hoping it would work well. But anyways I believe that its not the battery that's at fault since the battery seems fine to me (no bumps showing a faulty battery). I have a feeling that its my old battery that's at fault or the system still possibly assuming its a stock battery. Well I'm no expert .
Awfully I can post the link for fix this..
The APP for fix this 'bug' is "Battery Calibration", it delets a battery file, and after restart the cellphone, that file is remade with correct data.
Well I looked into Battery Calibration and have managed to find a fix! I charged my phone to "full" (which my phone only displayed as ~50% at the time) and once the battery percentage stopped increasing I left the phone to charge for a few hours after that. Then when I was sure that the battery is actually full, I installed a battery calibration app and "calibrated" my battery which deleted the batterystats.bin file. I then waited for my phone to completely run out of charge, which I sped up with an app called "battery discharge", then when I let the phone switch off by itself from an empty battery. Once the phone restarted the battery percentage displayed was correct.
Try Battery calibration
isnt battery callibration a complete myth and placebo? deleting batterystats.bin shouldnt help as it just contains data about what consumed battery juice