I have problem with mobile. My power adapter is melted and mobile doesnt recognise charger. When i plugged out green led constatly blinking after fully charged or orange led if not fully charge. I have other power adapter and i plugged in, mobile is fully charged. After that i plugged out, but green led flashing. When mobile doesnt full charged, orange led 2-3 times flashing and mobile trying to charge and show thunder on battery. After that, everything is ok. Maybe faster drain battery. I change flex usb port, change battery, but problem is the same. What is problem? How can I resolve?
Thanks
Related
Hi all.
I've bought a XDA IIi on eBay, with no cradle (An O2 one from UK, and I live in Spain). I received it with a travel charger, for a SPV E200 model, but with the same connector. The travel charger supplies an output of 4.5-12V and 400 mAh. The XDA did not work, so I supposed I received it with the empty batteries (both main and backup batt), so I put it to charge with the travel charger. After 2-3 hours of charging, it still does not work, does not respond to power button or soft and hard reset attempts. But the XDA shows an orange/red blinking light when charging it. According to the manual, it should be an amber solid led when charging it. The only solid led I've seen is a green one on the charger.
I still don't know if it works. I'm receiving and usb sync/charger cable these days, but I don't know if it will light up the PDA.
I've seen some posts where people talked about much more charging hours, and one post talking about that blinking orange led was caused by a low-power charging, and another where talked about it was a problem with empty backup battery. But after 2-3 hours I think at least the backup battery should be fully charged.
I would like to know if anyone knows what does that blinking led exactly mean, and if I have to charge it 24 hours or more until it responds to power button and does anything else but blinking light. Has it to be a continued charging?.
Thank you.
OK, I've received an usb sync/charge cable and a charger, and after some minutes charging it worked. I've got the next conclusion:
Blinking led means charger not giving power enough. Red led means crytical battery level. (So blinking red means no charging power enough and very low batt). Solid led (no blinking red or amber) means enough charging power. Amber led means no crytical batt level.
I hope this helps anyone who got the same problems I got too.
Hi,
After using my phone all day yesterday it went down to 15% battery so I turned it off and put it on charge using a mains charger. When I switched the plug on the LED went red and I assumed it was charging the phone.
Got up this morning and the led is still red and the phone won't switch on so I am assuming it didn't charge properly, have plugged in the usb charger and am now waiting to see if the light goes green once charged...
Any ideas why the light was red if it wasn't charging, and why it is still red this morning, does it do this when the battery is low and the phone is off?
When the phone is turned off and charging, it will be red. When the battery is enough (not full), it will boot up to a charging state.
All you will see is a battery with a green bar across it.The led will now emit, yellow/red.
Not sure what the problem was but I'm guessing this phone cannot be charged correctly with a mains charger so I will stick to using USB chargers connected to the mains, once I switched to that charger the phone started charging correctly and the led went from red to orange to say it was actually charging
It is not good to leave your phone charging overnight.
http://blogs.tribune.com.pk/story/1...our-cell-phone-battery-life-stop-charging-it/
take a look at this article. I have been following these steps and even till today my iphone 4 battery operates like the day I first got the phone.
Looks like my battery is dying. Its not charging, with both power and USB. Orange light is on, charger is working for other phones but mine. Is it a battery problem or the USB connector problem. On the bootloader while phone is charging it shows error that the voltage is low. Please advice
I have an Xperia T (for fixing) and It seems not charging the battery, every time i plug it in the wall charger the red led notification show up, then blink, then shows up again. the battery is cold and it doesn't charge
the weird thing is that I unplugged the battery off of the phone, connected the phone straight to usb (without battery) and phone turned off of course. suddenly Sony logo appeared then charging icon appeared as it's charging! but there is no battery, also sometimes it shows up even when the battery plugged in but the battery doesn't charge!!
Please anyone familiar with this issue let me know, if its a Hardware or a Software related.. or something to do with the charging circuit or some components in the mainboard?
thanks for any respond!
i appreciated so much!
Hi. I have a very strange problem with my XSP running Vanir. I've been using Vanir for over 2 months now.
The problem is that the phone wouldn't charge, at all. When it was powered on, plugging in the cable through either wall socket/pc would do nothing. PC didn't even recognize the phone.
Currently, the battery is completely drained and there's no way to power it on. When I connect the phone to wall socket, the LED first turns green for about 5 seconds. Then, Sony logo is flashed with LED being red, for 5 seconds again. Then, the offline charging screen would appear, and go off within a couple of seconds. When I press the power button, the offline charging screen flashes and goes off. LED isn't blinking or lit up.
If I connect the phone to PC, the LED glows red constantly. That's it, no charging.
The problem is not with the cable as I tried 3 different ones.
Someone help, please.
May be the micro usb socket is damaged.
http://forum.xda-developers.com/xperia-sp/help/phone-wont-charge-t2846801
try it