XT1096 leaves priority mode early - X 2014 Q&A, Help & Troubleshooting

I recently factory reset my phone, and now it doesn't properly respect the downtime/priority settings. It's set to go into priority mode at 8:15 pm and exit at 7:15 am. It enters the mode fine, but within a half an hour it's back out of priority mode. I have also used Assist to keep the phone's screen from "breathing" during the same time. Does anyone have any ideas what the problem could be? This didn't happen before the factory reset.

Related

[Q] My phone goes off all the time

HD7 using my every day he turns off alone, without even display "Goodbye".
And this happens whatever the application I use.
I hope you can help me because my phone is almost unusable!
send back for servicing
Provided you are having to turn the phone back on and go through the boot sequence (it is not just going into power save mode and turning off the display) I would agree it is a bad phone.

Screen won't turn on after 0% battery shutdown

So I sideloaded 5.1 and was fine all day long. Was down to 8% then I notoced the 1% warning 30 seconds later. It shut down before I could plug it in. I booted up and everything seemed normal but the screen wouldn't turn on after the boot screen. I could take a screenshot and power it off but that's it. After a few times cycling it, It started going into the boot as it did when I first installed the update. Optimizing apps, I figured that would fix the problem but sa,e black screen. I tried booting into recovery mode. It just shut it down when I chose that option. I can see the time and unlock screen when I wave my hand over it. Unlocking it does nothing. I get red LED when I hit the power button one time.
I ended up doing a system wipe and it's back to normal now. I'd still like to know the solution in case it happens again.
If it happens again try first to reboot by holding power and volume down buttons for 10 seconds and/or wipe cash
I am having the exact same issue. Has anybody had a luck resolving it short of a factory reset?
My phone battery died last night. I plugged my phone in, let it get about 15% charge, then tried to turn it back on. The phone boots like normal, but after the boot animation goes away, the screen is black. Active notifications still seem to work, and I can hold the power button to get the Power Down option. I can boot into the bootloader & access recovery just fine. However, my phone is fully stock (no root, no bootloader unlock, no anything). I can't seem to access ADB when the phone is powered normally (ie, when I'm at this mysterious black screen), but it's possible that USB debugging isn't even enabled.
So far, I've found a bunch people who've said a full factory reset will fix the problem, but I'm looking for another solution, or at least a way to grab my data before I reset. Since my bootloader's still locked, I can't seem to use fastboot boot to boot into TWRP, and I can't find any other way to access my data to copy it off the phone. I've tried wiping the cache using the stock recovery to no avail. Any suggestions?
bjg222 said:
I am having the exact same issue. Has anybody had a luck resolving it short of a factory reset?
My phone battery died last night. I plugged my phone in, let it get about 15% charge, then tried to turn it back on. The phone boots like normal, but after the boot animation goes away, the screen is black. Active notifications still seem to work, and I can hold the power button to get the Power Down option. I can boot into the bootloader & access recovery just fine. However, my phone is fully stock (no root, no bootloader unlock, no anything). I can't seem to access ADB when the phone is powered normally (ie, when I'm at this mysterious black screen), but it's possible that USB debugging isn't even enabled.
So far, I've found a bunch people who've said a full factory reset will fix the problem, but I'm looking for another solution, or at least a way to grab my data before I reset. Since my bootloader's still locked, I can't seem to use fastboot boot to boot into TWRP, and I can't find any other way to access my data to copy it off the phone. I've tried wiping the cache using the stock recovery to no avail. Any suggestions?
Click to expand...
Click to collapse
Please stop bumping up every topic that says black screen with the same copy and paste message. Once was enough!
Sent from my XT1095 using Tapatalk

Black screen on boot

My XT1092 powered down by itself at 4% yesterday, so I plugged it into a power bank and left it on its own for a while. At 24%, I tried to power it on, and the device boots, but gets stuck on the final image of the boot sequence for longer than usual, before booting into a black screen. From here, I can do some things, like Moto Display and Voice still work (I can get it as far as opening the camera, but anything else requires me to unlock my device, even tho I don't have a password), and notifications like WhatsApp and Gmail come in fine and can be seen, but the moment I swipe up from Display to unlock it, I can't do anything. Touchscreen is unresponsive in camera interface when launched, but volume to capture and screenshots work. Moto Gestures don't work, except double twist in camera interface to launch front camera. From a thread on reddit, this is apparently not the first time something like this has happened, but it's incredibly frustrating to get this. I've only had my Moto X for 3 months, since April, and in that time, I've had to factory reset it twice and send it in for repairs once due to a faulty power button. I've connected it to a PC in hopes of backing my stuff up, but while PC recognizes XT1092, it says there is nothing on the phone. Wiped the cache twice in an attempt to fix, and boot through fastboot, but once again, no luck. Running stock 5.1, unrooted, locked. Can access recovery menu, so whatever I can access from there is probably my best bet.
P.S. What does reboot to bootloader and view recovery logs mean?
Same thing here. Happened twice to me also. Not sure what causes it.
http://forum.xda-developers.com/moto-x-2014/help/boot-animation-phone-stuck-t3148085
KB Smoka said:
Same thing here. Happened twice to me also. Not sure what causes it.
http://forum.xda-developers.com/moto-x-2014/help/boot-animation-phone-stuck-t3148085
Click to expand...
Click to collapse
The new boot ipscreen doesn't appear on my device, but WhatsApp has warned me of date and time wrong, set to July 1, through Moto Display.
I am having the exact same issue. Has anybody had a luck resolving it short of a factory reset?
My phone battery died last night. I plugged my phone in, let it get about 15% charge, then tried to turn it back on. The phone boots like normal, but after the boot animation goes away, the screen is black. Active notifications still seem to work, and I can hold the power button to get the Power Down option. I can boot into the bootloader & access recovery just fine. However, my phone is fully stock (no root, no bootloader unlock, no anything). I can't seem to access ADB when the phone is powered normally (ie, when I'm at this mysterious black screen), but it's possible that USB debugging isn't even enabled.
So far, I've found a bunch people who've said a full factory reset will fix the problem, but I'm looking for another solution, or at least a way to grab my data before I reset. Since my bootloader's still locked, I can't seem to use fastboot boot to boot into TWRP, and I can't find any other way to access my data to copy it off the phone. I've tried wiping the cache using the stock recovery to no avail. Any suggestions?

Pure 5.1: Boots, has moto display, but black screen when I unlock

So currently I can boot my phone and it displays the boot screen fine. Once its done loading though I just have black screen. Moto display still works and shows new notifications but if I try to unlock the phone its still just the black screen. I can hold down the power button and the power menu shows up fine. I tried clearing the cache but that didn't help. Before I do a factory reset I thought I might see if any one here had some ideas on solutions.
I have the latest 5.1 OTA update. My phone us unlocked, but not rooted. I tried to hook it up to my computer to see if I could at least grab my files off of it, but while it shows up on my computer I can't access any actual files or directories.
I've tried searching around, but I can't find anyone else with a similar issue. Last night my phone battery ran down to zero (and rather quickly compared to normal usage). I may have ****ed it up by trying to get it to boot and be usable while charging but with the battery only at 1% (I guess with the standard charger an in-use Moto X uses power faster than it can take it from the charger). I tried letting it charge for a few minutes and then letting it boot, but after a couple of minutes of use it would shut down again. I finally gave up and let it charge. I didn't really pay attention to its status, but in the middle of the night when I woke up I booted it before falling back to sleep. Not sure there's a connection to my issue and this or not.
Any ideas on what the cause might be or what I can try to do to remedy the issue without data loss?
Edit: I ended up just doing a factory reset and that worked. Admin can feel free to delete this thread if they want.
This sounds similar to the issue here:
http://forum.xda-developers.com/mot...-screen-to-recover-data-t3168103#post62117413
http://forum.xda-developers.com/moto-x-2014/help/black-screen-boot-t3161110
https://www.reddit.com/r/MotoX/comments/3cf4gr/51_black_screen_after_turning_on/
https://www.reddit.com/r/MotoX/comments/3aqr95/moto_x_2nd_gen_black_screen_after_update/
https://www.reddit.com/r/MotoX/comments/383ej6/black_screen_on_startup/
This is a bug that needs to be reported to Motorola.
I am that guy from the second post, and I wasn't able to recover the phone. Connecting to PC did not do anything. I would like to ask: is it booting with the new boot animation? Or old one? Because mine showed old animation long after the update was sent out, so I'm thinking the update may have tried to apply and failed, thus breaking the phone. Should all efforts fail, your only bet is to boot into recovery (power + volume up when off, volume down, volume up in the option menu (to select recovery), then hold power when Android robot appears, and while holding it down, press the vol up button once to make the list of recovery options appear. Scroll down to wipe data/factory reset, press power to select, then find Yes to confirm. Good luck!
so this just happened
i came back from a trip and took a whoooole lot of photos. when i came back my battery went to zero and device switched off. i charged the phone to 10-20% and switched it on and all i see is blank screen only moto display is working and power off option is showing itself when i hold the power button which is the same problem as yours
havent done any factory reset yet. is there any way to retreive the photos since i dont want to lose them. there are around 600 and all of them are of the trip.
im on 5.1
there are other people too who faced the same problem and all of them are on 5.1 but there is no solution
link :-
https://www.reddit.com/r/MotoX/comme..._after_update/
Mine did this yesterday, although I'm not entirely certain that the battery hit zero percent. The best I could tell from looking through the logs in recovery was that something was trying to update and failed. I suspect that it was a push from Motorola that hosed it. The only way to fix it is to do a factory reset. Once I did that and restored all my apps the battery was draining at a rate of 40% per hour or so. I found that the package access helper was the culprit and rebooted the phone. Post reboot, I immediately noticed that the boot animation and Moto logo had changed from what they had been on 5.0/5.1 (prior to yesterday). I also noticed that some of the widgets I hadn't reconfigured after the reset were now back. Weird indeed.
Anyway, I have to agree with the others that this is a very bad bug, that needs to be fixed. I am cautiously optimistic that the factory reset has cured it but we'll see. Based on my experience with this phone so far and the sale of Moto to Lenovo, this will be my last Moto phone.
I am having the exact same issue. Has anybody had a luck resolving it short of a factory reset?
My phone battery died last night. I plugged my phone in, let it get about 15% charge, then tried to turn it back on. The phone boots like normal, but after the boot animation goes away, the screen is black. Active notifications still seem to work, and I can hold the power button to get the Power Down option. I can boot into the bootloader & access recovery just fine. However, my phone is fully stock (no root, no bootloader unlock, no anything). I can't seem to access ADB when the phone is powered normally (ie, when I'm at this mysterious black screen), but it's possible that USB debugging isn't even enabled.
So far, I've found a bunch people who've said a full factory reset will fix the problem, but I'm looking for another solution, or at least a way to grab my data before I reset. Since my bootloader's still locked, I can't seem to use fastboot boot to boot into TWRP, and I can't find any other way to access my data to copy it off the phone. I've tried wiping the cache using the stock recovery to no avail. Any suggestions?

Screen timeout issue seemingly caused by activating airplane mode

I recently tried activating and deactivating airplane mode on my Galaxy S10 5G to reset my data connection, which was having issues. When I did, the phone's screen timeout somehow set itself to a setting that normally doesn't exist (see attached screen shot). This causes the screen to go black almost immediately when there's no activity. Since happening the first time, my phone keeps defaulting to this setting, usually when charging it overnight. The setting disappears of I select another option and exit the menu, but keeps showing up again whenever it defaults back or I activate airplane mode again. Does anyone have any clue what's happening here?
Welcome to XDA.
Try clearing the system cache first.

Categories

Resources