Database Develop

Very Urgent Help Needed!

Hi,
When I Flashing my ROM (CR86 THD v2.6) it stuck on 88%. What should I do?
Can Someone Help ME Please.
Thanks.

Please HELP HELP HELP!
Now when I tried to flash it again with the cr86 THD v2.5 it said
ERROR 264 : CONNECTION

ERROR [264, 274] : CONNECTION
ERROR [302~318] : UPDATE ERROR
ERROR [320~328] : INVALID COMMAND
These errors seldom occur. However, if one of these errors occur, it could not be recovered and the device had to be sent back to the customer service center. In this case, you have to flash a new ROM code...

I see you have a K-Jam, try this.
Download your original ROM from “HERE” scroll down to K-JAM to find your ROM.
Put the phone in bootloader mode and try flashing the original ROM.

if you can still set your wizard in bootloader mode, try to flash button rom on your device.

[Q] [Defy]A Problem that I never met before:(

I hope you all guys can help me to solve this problem
So firstly Thank you for come in to see my problem
Question refer to
http://forum.xda-developers.com/showthread.php?p=12719063#post12719063
-----------My phone Information---------------
DefyMB525
BootLoader 09.10
Factory Rom HK/TW 2.1 > Flash upgraded to 2.2.1 Orange ver.
----------What's the Problem-----------
(1)Factory setting reset Failed (its show success but only used 1-2sec,too quick, also there are no reset be shown)
v
(2)Recovery Reset Failed (same as [1])
v
(3)Tried to Empty chce (same as [1])
v
(4)Tried to Flash another 2 new rom "UK2.2 ver." , but it show error in "checksum match 32,33,35.........64",Then "In Process" changed to "Failed"
v
(5)Tried to Flash the Factory Rom HK/TW 2.1ver. , but it said "ERROR: Phone[0000]: Error sending JUMP command Device API Error: 0xE0030040 Address...."
-------------------------------------
My defy was alright before I install Task Killer..I Think......
Then problem shown temporary..
"Something can't install"
"If Something Installed, they will disappeared after reboot the phone"
"Factory Reset = No reset"
"Sometimes will Reboot automatically"
Will there any method to solve this problem?
Because i can go to Bootloader mode!
If so, Can you list out how to do it step by step.... cause I'm a newbie in android
Thank you all

Wrong forum: Motorola Droid and Milestone General
This is only for Motorola Milestone/Droid phones

Need help to unroot device (HTC ONE)

Hi everyone,
I have rooted my device and everything is working fine after update to 1.29.1540.16 and my phone start getting error " Unable to charge device". I trying to get it unroot because i believe its software issue.
I download this one "RUU_M7_UL_JB_50_BrightstarUS_WWE_1.29.1540.3" and try to factory reset my phone but it got RUU Error 152 everytime.. and now my phone stuck on htc logo with 4 triangles and i have to " fastboot oem boot " everytime ( .
Anyone please help me about this please.. I want my phone back to original software like before ..
sorry my for my bad english :

[HELP] Note5 N9200 Custom Binary blocked by FRP, baseband unknown, baby photo recover

Dear All,
Originally I have a N9200 which i accidentally deleted 3000+ photos of a 1 years old baby.
Here is what i did...and the problems i faced...
1. Used the software Dr. Fone for Android to try root the device
Result: failed
Problems : the application keep looping and reboot the device, and after 2 hours it tells me failed to root and hence failed to recover photos
What i Did : staff of DrFone tell me my phone is in 6.0.1 mashmallow and hence not supported...
2. OK... if Dr Fone failed to root, then i use CF Auto Root. I got the CF Auto Root , but ...
Result: failed
Problems : when update using Odin , the phone showed that "Custom Binary blocked by FRP"
shxx... i further check in google that i need to check "Allow OEM unlock", but the phone seems still can boot up normally... at this moment i notice now the phone will be rebooted automatically after 2mins...
What i Did : i used the 2mins to check back "Allow OEM unlock" and try again
3. Check Allow OEM unlock and flash CF Auto Root again
Result: failed
Problems: i noticed the CROM lock is still on...
What I Did : i installed CROM Service app, but when it opend it failed to unlock....and i checked that the phone's baseband is "Unknown" now....the phone will still be rebooted automatically after 2mins
4. Use Samsung Kies 3 Emergency Initialization
Result: the update look fine, but when it goes to recovery mode, it showed "Installing Update" , and a yellow triangle appeared with a dead android appear...
After restarted, everything is clean now...However, the phone is still rebooted automatically after 2mins..........
What I want to do is to recover deleted baby photos only:crying::crying::crying:
The deadlock now is... the phone cannot be rooted due to CROM Lock, but CROM app failed to launch due to baseband unknown!!
Anyone have similar situation and hopefully can share together.
Thanks again...

try app disk digger .. but works fine when the phone is rooted

[HELP]Your device is Corrupt msg while Updating. tried all ways showed in XDA

Hello developers,
pls help me to Get ride of this
I got this while Updating automatically from settings....which i got update notification
i tried to Flash stock/factory image, due to Unallow OEM unlock, i cudnt go further
Fone is LOCKED,STOCK ROM,NOT EVEN ROOTED, DEVELOPER OPTIONS OFF
i tried to update Android N via ADB SIDELOAD..............its not even detecting the zip file
it says... " Loading ..zip file " and get stuck PC
after few min, " installation aborted" displays in fone
i donno what to do .......pls help me
any way to solve this
thanks

If you can still get into recovery, download the latest OTA zip from Google's developer page, copy it to your internal storage, and flash it using the recovery. It will wipe your device storage, but at least your device will function again.