My brother has had a razr i since launch but recently the navbar stopped working and when there is too much data it refuses to pass the intel logo screen..
I tried alomst everything does anyone knows what's going on?
Related
Has anyone ever ran into a situation where the UI locks up after a boot? I keep searching through threads and can't find anything. I'm not sure if it's something I have installed or if there is actually something wrong with the device. I had a nook previously and never encountered this problem but on the new one I just got (ebay refurb) the problem just keeps coming back.
Basically, it boots just fine and starts to show the Launcher but then the screen goes black and leaves the soft buttons at the bottom. The only way to recover is to shut it down and start it back up.
The funny thing is it doesn't do it all the time... sometimes it boots just fine and never locks up while in the OS... it's only on boot it does this.
I've tried multiple different versions of cm7 and am getting the same thing on all versions. I've tried different kernels and stock speeds and it still happens.
Any help or advice would be appreciated!
Hmmm... well after hours of troubleshooting I think I pinpointed it to beautiful widgets
Everything was going fine on my Nexus One (CM 7.1) when 2 days back I dropped it. It wasnt a deadly drop. Just a casual one on the screen though. But nothing seemed to have hurt it badly, internally or externally.
After two hours it started restarting. After restarting it would be at desktop for 5 seconds and reboot again. it happened again and again. I flashed CM 7.1 over it. Same thing kept happening. Then i flashed CM 7.0.3. It worked. But i whenever i make a call the screen goes blank immediately and doesnt show up anything even after call is ended (by other person as i cannot). Even after call, i press all the available buttons but no life to it even though it is on.
I tried OxygeN1 rom. Its working good but the problem after every call continues.
Has anyone faced such a problem and any solution?
I noticed that i continue to face 5 second rebooting problem with CM 7.1 and Bugless Beast (by Peter Alfonso) Roms. Can anyone guess the reason?
My camera has also stopped working since then. Shows as
'Camera Error - cannot connect to camera'
Pls help with this also. Tried all the possibilities such as memory card format and other solutions on
Cannot go to HTC service center due to unlocked bootloader.
Pls help guys..need it badly.
I am facing the same problem.
I guess it has to do with proximity sensor not working.
I flashed MIUI ROM and in the settings there is an option to disable proximity sensor during call.
After this i am not seeing blank screen, but the camera still doesnt work!!
I had a similar problem after a drop.
Camera & flash had stopped working.
Nothing helped until I took it to the HTC Service Center.
They said some flex cable had to be replaced. Camera / flash working great after this.
My phone was an out of warranty Nexus One with an unlocked bootloader. They repaired it without a murmur!
I have a Asus Memopad 7 ME172V model and the issue with the tablet is when using it after i turn it on sometimes i can get a minute or so then it just locks up solid . Then u cannot do anything with it. Except hold the power to turn it off. I have no idea why or how to fix this. The tablets been rooted and i tried the clear user data from asus with sdcard and i tried using a sd stock dump i downloaded on here to restore with but that didnt help either. Anyone???? i just want this tablet to work.
+1
Having a similar problem where during the boot sequence the spinner keeps spinning forever and I never get to the lock screen. Happens maybe 80% of the time now (seems to have gotten worse over time) but occasionally lets me through, not sure why it decides to work vs. not. Would be great if anyone had insights on how to fix, or if the hardware is just giving out, etc.
Is there anyway to flash this tablet and reload android on it .. cuz the restores and using stock and whatever i find on this forum doesnt seem to help any i used 3 different dumps an nothing. still loads and works maybe a few minutes and the its frozen solid happens when i turn the wifi on. If i leave that off it works.
guess nobody has any answers to this must be hardware related i suppose it only locks up solid after i turn the wifi on .. i might work a minute or 2 or 3 maybe nothing more than that before the tablet locks up . Dammm
I have got my Asus ROG Phone II for about 8 months and I have recently got some problems with the software. The phone suddenly turns off on it's own, when I am using it and stucks at the restarting process with Asus Logo and the loading bar on the lower side but doesn't open, even if I wait for a full whole hour. I have to press volume down + power off button to make it work again. I wanted to ask if any of you guys have got the same problem, or any clues how to solve it?
Well I had rooted my phone after a month of it's use and unrooted it. For about 2 Months before, my charging port stopped working and Asus Service Center fixed it, and I guess they somehow flashed my Phone, as I not don't have to download and install the new firmware. It was good in a way but I feel it is getting some lag during the use of certain apps and the problem which I mentioned earlier. I would be thankful and grateful for your replies.
Wishing all to stay safe and healthy
Fantasticooo said:
I have got my Asus ROG Phone II for about 8 months and I have recently got some problems with the software. The phone suddenly turns off on it's own, when I am using it and stucks at the restarting process with Asus Logo and the loading bar on the lower side but doesn't open, even if I wait for a full whole hour. I have to press volume down + power off button to make it work again. I wanted to ask if any of you guys have got the same problem, or any clues how to solve it?
Well I had rooted my phone after a month of it's use and unrooted it. For about 2 Months before, my charging port stopped working and Asus Service Center fixed it, and I guess they somehow flashed my Phone, as I not don't have to download and install the new firmware. It was good in a way but I feel it is getting some lag during the use of certain apps and the problem which I mentioned earlier. I would be thankful and grateful for your replies.
Wishing all to stay safe and healthy
Click to expand...
Click to collapse
Don't know what the problem is, but you've posted this in the wrong section!
I think I am in a similar situation. My phone's problem is that it kind of crash while booting up (stange lines shows on the screen like some glitch) , it doesnt boot up normally and it loops 3 to 4 times until it's left on a black screen. I am not sure of its status at this point for it is not responsive even to force restart (Vol down + Power) but it does work only once in a couple of minutes and proceeds to bootloop and back again to the black screen. I haven't rooted it but i did flash it from CN to WW which was successful and was using it perfectly for 4 months up until this situation. I dont know what exactly is the problem. Can anyone help me?
Same with me bro... Mines already bricked because of flashing it to the original version
Same here
Does anyone watch this thread anymore? I have a question: I replaced the battery in my LG R watch (which I have not used in several years), and charged it up. It boosts to the LG logo screen and hangs there forever. I restarted it and did the 11 to 5 swipe to see the fast boot screen, and select Recover Mode. Same results, it just shows the LG Logo and never gets any further along. Seems, perhaps, that the boot code is bad? If I cannot get into the Android screen, is there a way I can refresh the basic software on this device? Or is this thing dead? FYI: I have not done any hacking on this, it is just stock. But it seems I might have to to get this running again. Suggestions and pointers would be welcomed. Thanks.
Hi watchers. I see no replies, but maybe someone here ha a USB driver that will work on Windows 11?
Ok, I got this to work but had to go back to a Windows 7 machine. Sad that these threads are dead now.
Hello, I have exactly the same problem !
Could you tell me how you did it?
I think I have to flash the firmware, but I have no clue.
Thanks to you, or to those who can help me.
I didnt had this issue so i am sorry that i cant help you there.
I replaced the battery and everything was fine
Thanks
I changed 2x batteries (compatible & genuine) and nothing better :/