Hey... I have the following problem:
https://www.youtube.com/watch?v=X1p8uxZnmA8
Often when I am charging my phone I have this Issue with several adapters, cables and so on. I have tested a lot and already did two RMA... they changed some back cover part and the mainboard. issue is still there and I dont have more ideas.
I already noticed that some others have this problem too. But what could it be?
Now im testing an older Stock ROM (release 02.2017). Someone have any idea? Could this be a Software (kernel) problem?
Related
I have been using GPS on my Tilt for a long time with no issues with different GPS software and everything went fine.
Recently I was driving with GPS running (using iGO) and the batteries gone out so that the device would not turn on until I charged it.
Since then every time any program accesses GPS module the Tilt completely reboots.
I tried reinstalling iGO, installing other GPS applications, taking out batteries for a long period of time. Nothing works.
I haven't tried a hard reset though but I don't want to loose my data.
Anyone experienced similar problems?
Any thoughts of a possible solution?
Thanks!
Did a hard reset. Didn't help.
Seems to be a really bad issue of the device.
Extremely disappointing situation...
Could somebody help with any idea?
this is really basic, but did u fully charge it? it would only restart as you mentioned if the battery is low 0-20%
Yep.
I completely charged it.
It is currently not a problem of batteries low when it restarts.
What happens (as I understand) when any program initializes the GPS (connects to COM port assigned to internal GPS module) the device reboots.
It looks like a hardware bug since even a hard reset didn't help.
I thought it might have been some static electricity left on the GPS module when device turned off because of the batteries but apparently not since I have taken the batteries for some time and it didn't help.
The problem is I don't even know who I can contact to - I bought it from AT&T but they seem not to have a technical support group for the device and seems that HTC does nto support Tilt either :-(
Tought I would share my experience.
I contacted HTC support with this issue and they replied that the device should be returned to repair service.
From the message it seemed to me that they were well aware of the issue but seems not many customers experience it they don't give a sh.. to fixing it and just repair (replace) the device.
I wish it were written in some FAQ etc and I knew about it before the situation and moreover before I bought the device.
I don't understand HTC, if they know about the issue and not going to fix it why they just not report it and tell everybody to prevent such situations...
Very disappointed...
Hi There,
I have an HTC version TYTN 2, which is a great piece of gear.
One issue, when i charge via USB port, say overnight when on a business trip, when i check in the morning the large clock from the HTC screen disappears, and the device seems to lock up.
A soft reset fixes it no problem, however wondering if anyone else is seeing this. I have the original HTC shipped ROM.
Thanks,
Derek
I am having the same issue I think. With the original HTC Rom, this would happen 2 out of 3 charges, since moving to the Dutty 6.1 ROM it seems to happen each time I charge overnight.
When I disconnect the phone from the charger in the morning, the blocks on the top bar (tasks, charge, volume) are corrupt - they display as a garbled full box. If I try to use the phone without reseting, the entire display will become a garbled mess, it seems like its not clearing the screen before it writes more information, so eventually it just becomes full.
A simple reset every morning fixes this, but I would love to know whats causing it
Anyone have any ideas what could be causing this? It doesn't seem like its an issue that effects many people, as searches of this site for all the keywords I can think of produce no other threads on this.
-Mat
I also have the same issue as stated above.
Just as an update, it looks like it was batti that was causing the problem. Once I removed that software, the constant freeze ups on charging stopped.
My tilt recently has been acting rather strange, and I'm not sure if its the radio or not. The phone keeps on gaining and losing signal, and cannot figure out why. At first I thought it might be a software problem, but I updated the rom to the newest official release and that did not fix the problem. Does anyone have a suggestion? The problem isn't reception, I've never had this trouble until recently, has always worked fine in this area regardless of weather / other.
not sure if it's the same issue...
I had the problem few weeks back..
my tytn would be having no signal at times..
I nid to go to Comms Panel and off/on the Phone.
after few days, encountered no SIM Card detected error.
hard reset and changing ROMs, including stock ROM didn't help.
now it's being repaired..
hope to get it back soon.
its horrible that you mention that, my warranty literally ran out about 5 days ago . However, based on the fact that I've done just about everything I could on the software end, I think it might be hardware (even though I haven't really even put this phone through any trauma whatsoever). The radio part of the phone....does anyone know which specific part that is? I don't remember seeing an individual radio in the disassembly, so I assume that it is on one of the boards. Does anyone know which one specifically?
mine was subjected to a few drops on the floor hehe..
but it was ok...
it was only recently that I encountered those issues...
if U can try get hold of the tytn II assembly/dis-assembly pictures, U might be able to remove the antenna pcb/board...
I only cleaned the metal connectors at the antenna board area.. no joy..
I've been searching for internet for weeks and i still coudn't find the solution for this thing ..... my screen scrambles and jumbles everytime i connect to the internet using 3g....3dge.. etc but not wifi
here is my phone's background:
when i purchased it it has no problems at all...
after 1 and half years due to daily use keypad gets hard to press and the screen has a lot of scratches casing too..
so i decided to change the case of the xperia an the tft resistive touchscreen and clean the whole thing..
after putting it all back together it runs fine... checking the landscape camera wifi etc..
i decided to change rom because i think i could make it so new that even the os is changed...
i follow the basic process and it work fine..
after a week i notice that when i connect to the internet 3g... it jumbles the pixels of the screen in the upper part of the x1 even on landscape mode.. it is still there....
i searched the internet and i found old questions never been answered;;
http://www.xperiax1.net/x1-problems-issues/1735-youtube-videos-scrambled.html
http://forum.xda-developers.com/showthread.php?t=735531
somehow related to connecting 3gs..
i never change to 6.1 because of it's lack of features..
ive change 6.5 roms but the problem is still there....
here is a sample picture:
http://www.glowfoto.com/static_image/27-005937L/9102/jpg/11/2010/img6/glowfoto
can somebody... please.... im begging you.... explain these problem with me and how can i solve it....???? PLEASE..... I APPRECIATE YOUR REPLY OR RESPONSE PLEASE!!!! thank you and God Bless!!!
PLEASE THANK YOU.... I REALLY LOVE MY OLD PHONE... I DON'T WANT TO BUY ONE...
dude, seriously. no one answered? it's very common tiling issues. yours just happend due the notification icons animation. most probable cause is vga driver. search for alternative driver.
No idea dude. But you may try to reflash your X1 to other ROM. I had been facing almost similar connection problem, but mine, the WiFi is undetectable. So I try to reflash my ROM with other ROM. Fortunately, it's working back.
this might be some app problem rather than rom/driver issue although some rom/driver handle it better. i just experience the exact issue after installing weather4me app. disabling refresh(update weather) during startup solved mine. maybe there's background app/process that doing something similiar causing it.
I see 3 possible reasons for this behavior:
- the displaydriver of the 6.5-rom is not really compatible to the hardware.
To check this you can flash the original rom and test if everything works.
- the radio interferes the communication between display and board.
This can happen when the device is not reassembled as original
(broken/removed shielding, dust/dirt in connectors while reconnecting,...).
To check this you have to reassemble the phone again.
- damaged hardware thru electrostatic discharge when touching the electronics.
Unfortunately this can not be checked or repaired. You can only guess if this is a possible reason by answering this questions to you:
- did you wear part-synthetic clothes while working on the electronics ?
(this forces electrostatic charge)
- did you discharge "yourself" every some minutes by touching a grounded point ?
- did you lay the electronics on a plastic ground ?
Hey everyone,
I've been lurking around these forums trying to find a solution to a few problems that my HTC One M7 has been having but have yet to find a solution.
It all started with the black screen problem where I could only see the screen on my phone by shinning a bright light on it. I decided to do a factory reset but that didn't fix the problem.
My next step was taking the back housing off my phone to see if any of the flex cable connections were loose. Since I've been tinkering around inside I've gotten some weird versions of different things to happen.
I've gotten the screen to be back to normal brightness without touch controls and I've gotten the phone to be completely working outside of sound. Right now I have all the flex cables and black antenna cable unplugged and decided to let the battery drain completely before I reseat all the cables, recharge, and try from scratch.
Just wondering if anyone has any ideas on some solutions to the problem or things I can try. I've also though about replacing some of the flex cables to see if that helps. Thoughts?