Hi.
Some time ago i smashed my m7 so hard it needed a screen replacement. After doing it myself I connected it to charger, LED started blinking red. So, i disconnected phone and tried turning it on, but it only vibrated and LED stopped blinking.
After that and leaving it for whole night charging i got no more blinking or vibrating when i press power button.
Screen never turned on after my fix.
Do any of the XDA magicians have idea what's going on and how i could fix this?
Thanks in advance! :fingers-crossed:
Related
hi!
the green led on my g1 suddenly starts to stay on all the time.. i dont know how to turn it off? can i?
or why does it stay on all the time? last time i check it doesnt.. any help?
....did you forget to remove your charger out?
yup, charger is not connected. i also tried shutting it down then remove the battery. but after hitting the power button to boot the device the green led stays on.
Hey everyone. So today while at work I had my One plugged in and charging, also had an aux cable plugged in listening to music. Out of nowhere I heard the music stop. Went to wake it and nothing but the LED light in red was on. I've held power button for minutes, power+vol + and - for minutes and nothing. I've tried all that with the bright light on the prox sensor as well, NOTNING.
This is driving me insane. I don't get how the red light is constantly on. When I've held the buttons the back and home buttons don't light up at all.
Has anyone had this and been able to fix it? Any help is appreciated!
Thanks guys.
Sounds like phone is dead. Back for warranty!
SaHiLzZ said:
Sounds like phone is dead. Back for warranty!
Click to expand...
Click to collapse
Yeah I've emailed HTC. I'm keeping the phone unplugged. Going to let it die completely. Hoping the led will turn off and then I'll plug it in. We'll see.
Hi !
In advance, sorry for my english.
I have problem with my HTC ONE m7.
I broke my digitizer and I bought a full set(screen + digi.).
I replaced it, and i have a problem.
After turn on the phone, i see the black screen and sound of turning on.
When i push the power button and vol -, the touch buttons blinking.
When I put the phone into charger, in first time after plug in the battery, the notification diode is blinking, and after about 10 sec. the light is red, the same when i normally charging the phone. When I turn the phone on, the charging stopped. And when the phone is switched on, not charging.
The flexes aren't damaged.
Is it possible, that i get a broken screen in shop? - i don't see any damage.
I have an HTC One. I was using it normally today, but got home and it was one percent. I plugged it up to charge and went to check a notification I had, and it turned off. It has happened before, and the charge light was on and it went straight to the screen where it shows the red battery and percent below it. This was normal - like I said, it's happened to me before. Then, it completely turned off instead of charging. A short time later, the orange charging light went off.
I plugged it up into the wall as advised a forum I was looking at for this problem, and apparently it is a common thing with these phones. I've let it charge for about an hour and it still isn't turning on and both the charge light and the red LED light have not come on at all. I tried to trick where I held it under my lamp light and held the power button and both the up and down volume buttons but it still hasn't turned on. Maybe I just haven't left it plugged up long enough?
Any advice? I use my phone a lot, so I really need it!
Hi all,
I have the charging problem with my Xperia T Skyfall phone.
I have read many posts on the net about users who have the same problem.
It ran completely out of battery and I can't turn it on anymore, at the moment I have it charging on the wall charger with the Power and Volume Up buttons pressed, the red light is on and after a few minutes it vibrates and turns to the green light, than the light goes off an it vibrates again and than the same thing again and after that the red light goes on again.. is this a good thing or should I do something else and if this is the proper way how long do I have to let it do this before it turns on or do something?