Hey all, I was trying to apply some double sided tape to the bottom of my screen because it was coming a bit loose, and stupidly used metal tweezers to do so. The display turned off for a split second, but turned back on so I thought I was good.
But then, I've noticed that when I turn on the display, horizontal lines sometimes appear. I don't have a 100% repo rate; I can get rid of it by turning the display off and on again (might take a few times though).
However, the right side of my display is always brighter than the left, making a king of ugly brightness gradient on my screen.
Any ideas on how I might be able to fix this without buying a new screen? Thank you!
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I should also mention that I had replaced my screen in the past, although it worked perfectly before.
Unfortunately I have to say this screen is most probably a goner. The panel on this device is more fragile than a potato chip!
I cracked mine when it fell on the carpet with cover and protecting glass on. they didnt break but the panel beneath did!
My best suggestion would be getting a new panel and asking a more professional guy to repair it.
Related
Any way to tighten up the hinge mechanism and slider rails? Yes I've searched and the 4 screws on the hinge will not tighten up the resistance to tilt up/down only if the screen/body wobbles alot.
Today replaced my entire front housing/middle section and thankfully the phone works perfectly so far aside from looking like it was just unboxed. But -- I would have liked to tighten the hinges. Didn't fully disassemble the slider mechanism and totally remove the sim card holder. Read the full HTC SERVICE guide and looked at the photos couldn't see if there is a couple of screws beneath that apply pressure to the hinge plate. Tighting the rails looks like its impossible - ANY INSIGHT to either would be helpful.
UPDATE: Found a fully detailled photo of a slider and it looks like a screw just above the hinge in the photo - is this the screw to apply more pressure? I'm a little hesitant in popping off the sim reader since it looks like its double faced to the slider. Will post the picture tomorrow.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Have done a Hermes multiple times - but the KAISER is a royal pain to strip down and put back together.
I've just noticed the front layer of my One is sliding away form the body below. Imagine the top layer is the screen and speaker grilles, the middle layer the white band and the bottom the layer the body.
The top layer has twisted slightly and you can see the top two layers are not quite in line. In the bottom corner the middle layer is slightly exposed.
Unfortunately, I don't have anything to take pictures to show.
Has anyone heard of this problem before? I'm thinking it can only get worse.
Thanks
Take a picture in the mirror, i would definitely like to see this.
This is weird. Need to see this
Never heard of a phone doing like this
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I don't know exactly what you are talking about, but the phone is held together with adhesives so I don't doubt it. please take pictures.
Sadly, I'm travelling at the moment so can't get the pics everyone is craving . As soon as I found a decent camera, I'll put something up
In for nud..... I mean pics
My Mi 9 have spots/stain under the screen, its visible in dark room with low brightness, especially when displaying on apps with grey/dark backgrounds.
Anyone else have something similar?
call me crazy but i think they could be sensors. the one spot i have is exactly where the in screen fingerprint scanner is, same size and location. but theirs also a small one far top left, don't know what that one is.
I had also spots on the display, I returned that unit and i got already a new replacement that doesn't have any issues.
Even my Mi A1 has spots, but it looks like it's a glass manufacturing issue, not the display
xdarkmario said:
call me crazy but i think they could be sensors. the one spot i have is exactly where the in screen fingerprint scanner is, same size and location. but theirs also a small one far top left, don't know what that one is.
Click to expand...
Click to collapse
the top left one could be the under screen ambient light sensor as pictured in the linked image
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Here's the official "teardown" https://c.mi.com/thread-1856339-1-0.html
It's not any sensors or something like that, it's literally like dirty spots between the glass and the screen. i would guess it's the glue they use.
This is happening when is activated anti-fliker mode to my mi 9 lite.
My Mi 9 Lite fell off display down. Just from 3 feet, but the impact sound was nasty.
There was a tempered glass and a silicon back cover which had a bit high edges. But the cement floor was not perfectly flat. The tempered glass already had cracks from a previous fall months ago. No new cracks observed.
I picked up the phone and pressed the power button. Unlock screen appeared as usual. Did not unlock as it was very dark. Did not try to unlock it and I thought it is fine.
I came back after an hour later, then the screen was gone. Not completely black, though. Top corners show some light. Battery life is displayed with purple / unusual color. Photo attached.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Incoming calls received. Touch screen probably not working.
The displayed area is becoming smaller with time. Couple of minutes ago I saw the whole wi-fi icon, but now it is hardly visible.
What happened?
How can it be fixed?
How can I back-up data into my PC?
Thank you very much!
the same thing happened to me yesterday...
have you managed to backup your data somehow?
I'm not exactly sure how to describe the issue as I do not know the correct terminology.
I have a Samsung Note 5. During disassembly to replace the battery, the corners of the design on the front have peeled away from the inside of the front assembly. That is, the inside of the glass panel of the front.
Before. Note the gold decal of the front screen, the gold design around the display, and especially the corners (pink) to the left and right of the speaker. This is a picture from before the battery was replaced. Looking at the left corner, the decal was already beginning to peel off. Unfortunately, it got worse. The edge indicated by the green line is the screen protector.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
After the replacement of the battery:
and now also the right and bottom corners have begun to peel away from the inside of the screen:
I discovered the issue while reassembling the phone after the replacement and tried to push the decal back against the screen, but whatever made it stick to it isn't working anymore.
I would appreciate advice.