My phone's touch stops working but when I restart the phone it starts working again but again after some time it stops working
friend, maybe you have a small error in the execution of the system or a possible error in the factory screen, how long ago did you buy the mobile? did you reinstall any rom? where did you buy the mobile?
I wait your answer
Related
Ok so i was updating rom from 1.5 something to the new 1.63. However, my touch screen is broke, and now i cant update because i cant tap the screen. So its stuck at windows mobile center setup. For the time being I switched my sim to older phone. When i put my sim back into the Tilt it goes to the same screen after the G3. Im pretty sure that after i get my screen fixed, it will work, im just wondering if this could cause long term damage i.e. file corruption or something similar?
It seems that your ROM upgrade happened successfully, and you just can't finish the phone setup process (like stylus calibration, time, etc.)?
If that's the case then you should be fine once you get your screen fixed. the state your phone is in now is a fully flashed state.
Also, it isn't clear if you were upgrading an official ROM or if you had Hard-SPL installed to unlock your CID. If you have Hard-SPL it is pretty difficult to mess up the flashing process as you can always get back to the bootloader and try again. It's not impossible to brick it however as some have unfortunately found out.
rovanesyan said:
Ok so i was updating rom from 1.5 something to the new 1.63. However, my touch screen is broke, and now i cant update because i cant tap the screen. So its stuck at windows mobile center setup. For the time being I switched my sim to older phone. When i put my sim back into the Tilt it goes to the same screen after the G3. Im pretty sure that after i get my screen fixed, it will work, im just wondering if this could cause long term damage i.e. file corruption or something similar?
Click to expand...
Click to collapse
you should be able to just force the device to lose power, change the screen when you can and bootup and it should load back to the initial setup screen
You can try some of these suggestions I found in other threads. I've never tried them on the Kaiser though it shouldn't hurt anything:
_____________________________________
connect your ppc to AS then may be 2 different ways
1. install SOTI Pocket Controller-Professional
or
1. open device via as and seek file WELCOME.NOT
2. create empty file with same name
3.overwrite existing file with empty file
_____________________________________
You can also try a program called Remote Screen Alignment
http://www.codefactory.es/downloads/mobile_speak_pocket/release/MSP_RemoteAlignment.zip
http://www.codefactory.es/downloads/mobile_speak_pocket/Remote_ScreenAlignment_Manual.doc
Hello guys!
I'm having some trouble with my HTC Touch Diamond. I am running the latest ROM, and the phone has worked perfectly since I've got it!
But one day it suddenly powered itself of during a phonecall and I was not able to power it on again. I removed the battery, put it in again, didn't work. Took out the battery and waited for almost 30 minutes, tried again and now it worked!
Since then the phone locks up in no systematical pattern (when I wake up in the morning it mybe locked itself, sometimes when I listen to the radio or typing an SMS..). Do you have any idea what the problem might be? Can't type in the serial number as I just have managed to turn it on.
What should be mentioned is the behavior when trying to start it. Either the phone gives no respons, or it "buzzez" and the display shows "touch diamond", but the rom version is not appearing down to the right. When it starts, it starts just as it should and no error messages is displayed.
I have not tried doing a hard reset yet, which I must say is considered the last option.
Have anyone experienced something like this? Or does anyone have a suggestion about what might be causing this?
Thanks on beforehand
Edit: have performed a hard reset now (did not format the 4gb). But the problem is not gone.. The phone just died while surfing. Now it locks at the green windows mobile-screen just before the homescreen loads (if it even boots at all...)
Please help anyone!
Hello,
Yesterday my Diamond stopped working.
I started Call of Duty 2 and it hangs up.
So i removed the accu because nothing worked.
i put the accu back in and the phone wont boot.
It shows the Screen where "Touch Diamond" appears where you can see your bootloader version and rom version.
and nothing more happens.
is it possible to do something?
OK...
make MTTY from attach files, flashing any rom sutebl ,its work
evry thing will be right
wow big thx.
my phone is booting
but all sms and contacts are messed up
OH.... so sory for messed up but it is least possbile losses,always keep copies of all them,any way Congratulations to the return of your device to life once again
---------UPDATE------02-03-2011--------------
Today after some time i noticed when playing with the camera a little response to the touch but it seemed random after that i ran the align screen program and after a few tries it seemed to work correctly, this is estrange since i had previously run the program quite a few times without any result.
I will continue the testing and inform you.
------------------------------------------------
Hello guys I just got a xperia-x1 to play with, but when i turn it off the screen is not working when i touch it either with my fingers or the stylus.
My first reaction was a hard reset of the phone which didn't work, then i tried installing android but the rom i installed asked me to touch the screen to start so i was stuck at the same place, after that i have tried flashing using some roms but the screen is still dead.
I think this is a hardware problem but is there anything i can do to verify it?
And what part should i get to fix it?
Unfortunately i don't know if the device has been in any kind of accident.
Thank you for your help.
Hello all,
Its been a minute since ive done any types of mods to my phones.
My phone was running fine.. I got an OTA update for 98.72.189.XT894.Verizon.en.US and then when i try to update it said failed and now my phone doenst function correctly.
I lost functionality to the call log, settings, the top task bar, and a few other things.
when i reset the phone it gets the red eye screen and sits there for almost 20-30 mins
then it finally loads and i missing what i stated above.. Everyone once in a while it will actually load the bar and i can get to the settings until it reboots itself.
I was able to factory reset it and wipe the data but its still not working at all...
I was able to root it but im stuck and i hate trying to load stuff on here because it consumed all day waiting for this to start up with the red eye screen taking 20-30mins each time..
anyone know what i can do to get it to function correctly ??
Sounds as if system files got corrupted. You're going to have to flash the full firmware. Use either RSD lite or the Droid Utility
Sent from my DROID4 using Tapatalk