Hey, I have tried flashing a GSI ROM but got an error after attempting these two commands :
MrScarl3t said:
./fastboot erase system
./fastboot flash system Gsi.img
Click to expand...
Click to collapse
The "system" partition could not be found and after reading some of your comments I figured I had to reboot into fastbootd and not fastboot. Therefore I rebooted my phone but I am now stuck into a bootloop without being able to reach fastboot whatsoever. Holding down the volume down key does not seem to have any effect.
A few more details:
- adb does not detect my device anymore.
- I was previously on a stock ROM.
- I only managed to flash the vbmeta.img before the bootloop happened.
- Upon holding the volume up button, my phone briefly connects to my PC (for about 2 seconds) then disconnects and restarts again.
What could I do to be able to reach fastboot and flash the stock ROM again?
Thanks for reading
Hold power button + volume down button for 30 second if fails then drain the battery then repeat the process.
My battery is drained and no matter how long I hold the two buttons I can't get out the bootloop unfortunately...
-let the cable connected to pc and press (+ and power) when the splatch screen appears wait 3 secondes and release the power button keeping + button only.
-if not, try with an OTG disk inserted and do the same as above.
-if not, type on pc terminal: adb reboot recovery before connecting your phone.
Good luck.
Hey, thanks a lot for your reply
I have tried all the steps you've described me and I unfortunately can't reach recovery.
It seems as if the phone is reacting to it though as a black screen screen is displayed much longer than usual, although a few seconds later, the MI splash screen appears once again. Also, I can hear the beep from the pc when the phone connects but it keeps disconnecting 1 second later and proceeds to reboot. Seems like recovery is corrupted or something...
The phone does not show up under adb devices throughout the whole process. My pc only recognizes the usb port being connected (when the beeps are triggered) but does not identify the device as an android device.
Related
Hello there. Me was given a Razr i XT890. If i turn on there only the "Warning Bootloader unlocked". I try to get in Fastboot mode or any other mode but i only stuck in this window or nothing. I dont even get a Batterylogo if i load with the wall charger. I put it on my PC but nothing happens. No new Device. No ADB. Nothing. Can i rescue the phone or is it only a paperweight?
Most likely a brick. U could try to do something with the xfstk flasher. Search it up, get the right files and hope it works
It's recoverable!
Gindler said:
Hello there. Me was given a Razr i XT890. If i turn on there only the "Warning Bootloader unlocked". I try to get in Fastboot mode or any other mode but i only stuck in this window or nothing. I dont even get a Batterylogo if i load with the wall charger. I put it on my PC but nothing happens. No new Device. No ADB. Nothing. Can i rescue the phone or is it only a paperweight?
Click to expand...
Click to collapse
The first thing you should do is to see this video (https://www.youtube.com/watch?v=OTzaiwj-bGw) to install libusb on your computer (if you are using Win 8 or 10 you will need to remove the signing imposition on driver installation - search for it).
The second action is to download the programs provided in this other topic of the community:
Download -> https://forum.xda-developers.com/attachment.php?attachmentid=1795067&d=1362945847
Topic Forum - >https://forum.xda-developers.com/showthread.php?t=2184877
Then follow the instructions:
1 - With the cellphone turned off, connect it to the pc by the USB cable holding the camera button, when vibrate, release. (The green light should be on).
2 - Run xFSTK-SoC-Driver-Setup-1.0.3.exe and follow the instructions. (Your cellphone will probably turn on and will be locked on the bootloader unlock warning screen).
3 - If the phone has turned on, it will remain locked, then press and hold the camera buttons + volume down + power button. (It should vibrate, then release the buttons, if all goes well it will turn green).
4 - Run the unbrick.bat, when you start the prompt keep holding down the volume button of your cell phone. (If all goes well it will restart, continue with the down volume button pressed, when on it should enter fastboot mode.
If you get here and he gets into fastboot mode, CONGRATULATIONS you got it. Now just install the rom via RSD Lite. (Look up if you do not know)
Remember that your cell phone must have the bootloader unlocked for installation of the factory rom.
I do not guarantee origin, be aware that it is at your own risk
I hope I have helped!
Great! People from everywhere thanks you a lot.
brun0_csa said:
It's recoverable!
The first thing you should do is to see this video (
) to install libusb on your computer (if you are using Win 8 or 10 you will need to remove the signing imposition on driver installation - search for it).
The second action is to download the programs provided in this other topic of the community:
Download -> https://forum.xda-developers.com/attachment.php?attachmentid=1795067&d=1362945847
Topic Forum - >https://forum.xda-developers.com/showthread.php?t=2184877
Then follow the instructions:
1 - With the cellphone turned off, connect it to the pc by the USB cable holding the camera button, when vibrate, release. (The green light should be on).
2 - Run xFSTK-SoC-Driver-Setup-1.0.3.exe and follow the instructions. (Your cellphone will probably turn on and will be locked on the bootloader unlock warning screen).
3 - If the phone has turned on, it will remain locked, then press and hold the camera buttons + volume down + power button. (It should vibrate, then release the buttons, if all goes well it will turn green).
4 - Run the unbrick.bat, when you start the prompt keep holding down the volume button of your cell phone. (If all goes well it will restart, continue with the down volume button pressed, when on it should enter fastboot mode.
If you get here and he gets into fastboot mode, CONGRATULATIONS you got it. Now just install the rom via RSD Lite. (Look up if you do not know)
Remember that your cell phone must have the bootloader unlocked for installation of the factory rom.
I do not guarantee origin, be aware that it is at your own risk
I hope I have helped!
Click to expand...
Click to collapse
Hey, Bruno! You prolly don't open this forum anymore, but I'm trying to unbrick a moto razri that has this exact problem. I'm trying to follow the steps you sent, but it's pretty confusing, since some of these files are from 2009 or from some other windows like XP, Vista, or 7, and I'm trying to do all of this on my Windows 10 machine. Can you please try to update these steps? Thanks!
Good, after having installed the twrp 3.0 in my zte axon mini, overwriting and flashing the recovery twrp and vuala, my surprise is that I could no longer access the recovery mode ...
The phone loads and my pc detects it as adb android, but unauthorized ... and I can also put it in fastboot mode but it does not let me fklashear the recovery by fastyboot since it tells me that FAILED UNKNOWN COMMAND.
Can somebody help me? I do not know what to do
kevin_23 said:
Good, after having installed the twrp 3.0 in my zte axon mini, overwriting and flashing the recovery twrp and vuala, my surprise is that I could no longer access the recovery mode ...
The phone loads and my pc detects it as adb android, but unauthorized ... and I can also put it in fastboot mode but it does not let me fklashear the recovery by fastyboot since it tells me that FAILED UNKNOWN COMMAND.
Can somebody help me? I do not know what to do
Click to expand...
Click to collapse
Disconnect the USB cable, if connected. Tighten the power button and hold. The first time the phone will reboot in 10 seconds, continue to hold the button. More about 10 seconds will be the second restart, the button does not let go. When, after 5 seconds the screen switches off for the third time, quickly release the button. Phone off. From the off state to enter the rekaveri you can turn on your phone while holding the volume up button.
Hello,
i think I've broken my phone, I hope you can help me.
I followed this tutorial that you can download here : (I can't post the link because I'm a new user)
I've tried to unlock the boot loader with success, then the installer tried to install a recovery (as the text in the command window said) and the progress stopped, I have waited a couple of minutes but nothing happend and I disconected the phone from my computer (I know that was a bad idea).
Know my phone won't start, not even in the recovery mode. I can hold the Vol +, Vol - button and the power button but only the huawei logo appears, then turns the screen black and nothing more happens. I have also disconnected the battery for some minutes but this didn't change anything.
The only positiv thing is, that Fastboot still recognizes the phone when it's connected to my PC, but I still can't enter the fastboot mode.
I hope you can help me and save my phone,
thankfull Robin
Flash twrp in it, and than install persona's B602 rom.
D1stRU3T0R said:
Flash twrp in it, and than install persona's B602 rom.
Click to expand...
Click to collapse
First of all thank you for your reply. But I can't put my phone with my computer and minimal ADB in fastboot mode. The device is found with the command "adb devices" but it has only recovery status. When I type in "adb reboot bootloader" then Huawei logo flashes up and then it goes back to blackscreen.
I fixed it
I fixed the phone by myself. I'm not an expert at all and this is for the people with the same problem.
I think the problem was, that the phone won't leave the recovery mode, because it was listed with "apd devices" as "recovery" for the whole time.
So I tried to install a stock ROM via SD Card with a tool named au_temp.cfg and the phone actually did more then just turning back off when i pressed the Vol+, Vol- and Power key. So the phone actually entered the bootloader but I got the wrong stock image, but this didn't mattered because after one try the phone got back to normal mode and booted quite fine. So I think the main problem was, that my phone was stuck in a recovery mode and needed help to exit it.
1A) Accidentally relocked the BL while on custom recovery and rom. Bricked, only turns on to blank black screen w/ solid blue LED.
1B) Able to go QFil Q9008 mode but all attempts result in errors, mostly Saharas. Unable to get into Fastboot
2A) Out of nowhere, days later. From OFF state, Vol+ and Vol- and plug I get the initial screen to scroll to select Reboot, Recovery, Fastboot, Reboot options.
2B) Was able to get into Fastboot and recognized by All-In-One Tool by Mauronofrio but I could not unlock the BL because I could not get a successful unlock file download.
2C) Also was able to get into EDL and what looked like my first successful download/flash in QFil 9008 mode. All previous attempts For the first time I saw progress bars and it was complete, okay/closed.
3A) Nothing happened for a long time so I unplugged and power cycle. Now its still bricked but in a different way. Button combos yield a quick vibration, green LED flicker once, back to all black screen, over and over.
3B) I am assuming I am in a worst brick than before? Now I am unable to get into Fastboot, EDL, computer doesn't even prompt driver issue when its off. Where now?
Hi,
I had the q9008 issue too after flashing the ZUI ROM with QFIL.
Phone turned off itself and then, nothing but a vibration after 15s on power button, and PC recognized it as Q9008 port. No screen, no LED.
I tried to plug it to PC after battery died, and had the red LED. Tried to charge it, and it went alive again. Now it's on AEX and everything is fine.
You can try that way, or follow this guide (I would do that if it would not be alive):
https://redirect.viglink.com/?forma...ww.zukfans.it/2016/07/06/gui...terminali-zuk/
Hi, same problem here.
Did you solve it? How?
So i followed this guide to root my Mi A2 "theandroidsoul (insert dot here) com/xiaomi-mi-a2-root/"
It went all fine but the phone was still not rooted. So i thought maybe get the newest Magisk.zip wich i put on the phone.
So I went back to step 11. to install the new version with TWRP but it didnt go to TWRP although i held the volume up butten and then used the command "fastboot reboot" and then it weent into bootloop
so i Guess i am stuck on my Partition A (in my case) where i installed TWRP but i cant shut the phone dont to get into fastboot and ADB says Error: no device Found".
I Need Help plssss :crying:
If you cant go to fastboot then you need open up phone and use testpoint to force edl mode
But before that hold volume down and power for 10-15 sec to force fastboot
The battery is drained now, i tried to plug it in to the wall and boot into fastboot right away, i saw the fastboot screen for a splitsec but it cut off because it had not enough charge, so i left it plugged in and tried to go to fastboot constantly till the phone had enough charge to hold the boot, i was in fastboot for about 1 minute or so (my plan was to charge it in fastboot mode, leave it like that and then go to the pc to change the active partition back, but the pc didnt recognise the phone) but after that it startet bootlooping again while it was in fastboot.
Could i try to got to TWRP with "volume up + power button" ? and change the active partition in there?
Facing almost similar problem like you yesterday.
Try method I post here
https://forum.xda-developers.com/mi-a2/how-to/ota-v9-6-5-0-odimife-t3823445/page24
1. Have phone in fastboot mode
2. Launch adb cmd (NOT your pc usual cmd)
3. Connect to pc, type 'fastboot devices'