How to force 3G? - Tilt, TyTN II, MDA Vario III General

Is there any way to force 3G connection? I had that option in my Globtrotter UMTS card and it was very good solution to have 3g data transfer instead edge. It was especially valuable if I had weak 3G signal and my UMTS card wanted to change connection from umts to edge. I found something similar in nokia phones: type of connection (Auto, 3G, GSM).

Try bandswitch,commmgrpro or sharps commmgr

Check this thread & this post.

Related

Roaming

is there any way to make the phone roam onto a 3g network over the others...i am in sweden where there is a good 3g network, but i am alsways on H & G, hardly 3G.
Thanks
Mina08 said:
is there any way to make the phone roam onto a 3g network over the others...i am in sweden where there is a good 3g network, but i am alsways on H & G, hardly 3G.
Thanks
Click to expand...
Click to collapse
You should not complain then, since H means HSPDA, which means 3G+ and is faster than 3G.
Regarding G, it is supposed to mean GPRS, which is indeed the slowest one.
Maybe your carrier didn't not bother to maintain the intermediate services such as (E edge, and 3G umts).
You get either the fastest or the slowest.
G means GSM
And yes, HSPDA is better than 3G
i know its HSPDA, and G means gsm or gprs, but with HSPDA meaning hi speed, i cant get video calls or streaming when its on H.....if you get me, but i can use them when i get a 3G connection
just tried again and now it works, strange....

G vs 3G

I can't seem to figure out why sometimes I get a G connection vs a 3G connection based on the radio icon in the notification bar. Does anyone know what the difference is? G seems to be much slower then 3G.
G stands for GPRS which is a 2G connection and doesn't use the 1700MHz spectrum like 3G (HSPA) does. There are several reasons why your phone would switch between GPRS and 3G. Signal strength and 3G coverage area is limited in the US for TMO is the most common. Certain types of electronic equipment can interfere with 3G as well.
Thanks for the info, I wasn't aware of GPRS. Typically I get E (EDGE) or 3G but inside my office I get GPRS, chances are it's the equiptment. Explains why my connection is so slow inside.

3G not working but I've had some H reception

For a while now my 3G connection has not been working but I have full Edge reception and I have had some intermittent H reception. I have flashed the ROM, changed the radio and switched my SIM card but nothing has changed this.
Is the phone made to have 3G and H reception from the same chip, (most posts seem to say this is a hardware issue, that a microchip has burned out on the motherboard)
Maybe someone knows how to get the phone to turn off 3G but retain H reception?
H icon means HSDPA this is part of 3G. So there is no option to disable 3G leaving HSDPA active. But I can be wrong ;d
Wikipedia said:
High-Speed Downlink Packet Access (HSDPA) is an enhanced 3G (third generation) mobile telephony communications protocol in the High-Speed Packet Access (HSPA) family, also coined 3.5G, 3G+ or turbo 3G...
Click to expand...
Click to collapse
http://en.wikipedia.org/wiki/High-Speed_Downlink_Packet_Access
And I had similar problems, but they solved themselves . I think they was caused by lack of range ( I have H under the table, but over Edge only...).
It might help to diable HSDPA using a program like kaiser tweak.

[Q] 3G Roaming

I've been traveling for work lately and I'm frequently in areas where there is no AT&T 3G coverage. My phone will go to the EDGE network when it would be nice to have 3G. I've enabled the Data Roaming checkbox hoping this would fix it but it still stays on EDGE.
My question...Is there a way to force 3G roaming? In other words, make the phone search for 3G towers when its only getting EDGE...
Nevermind....I think I just found the answer.
http://forum.xda-developers.com/archive/index.php/t-536234.html

Disable "3G" while enabling "H" - possible or not?

My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
Unfortunately, it's impossible, you can either choose "H" & "3G" with wcdma/umts or "G" & "E" with GSM in Mobile Networks. You can't choose to leave out 3G when it's doing H, cause both of them are under wcdma mode.
Of cause, if you leave your "Network mode" to auto, it will jump around gsm and wcdma when it see fit. By choosing it to run GSM mode only, will keep your network connect to "E"/"G(gprs)" ONLY; Or WCDMA for "H"/"3G" ONLY.
helo
3Flight said:
My carrier has bad 3G operation, whilst HSDPA works fine. The problem is that phone sometimes switches between 3G and H, and when it does switch to 3G, there is no internet until it swithes back to H or down to E. I'm almost sure that this is caused by carrier, and I can't fix it with firmware. So I would like my Tab to avoid 3G mode at all, while using H and E. Can I set it to do so?
Click to expand...
Click to collapse
im from malaysia also,im using samsung g5..in my opinion its the the phone or tab firmware or rom problems..because im using maxis and digi broadband..both network are having problem..3g and hsdpa both switch on and back 3g h 3g h..not stabil and anoyying..

Categories

Resources