I keep having trouble with my diamond gettting stuck on the numeric keypad. It happens on the standard ones and sometimes PCM keyboard.
I switch to the numeric keypad to enter a number and it wont switch back to letters after that. I have to select another keypad the go back to the one i had to get letters back. It has happened on two diamonds I owned.
Any seen this?
Related
Two gigantic annoyances of my ATT Tilt (with HTC ROM on it) that I simply can't stand anymore.
1.) When I am in a phone call the screen turns off so if I need to use the keypad I have to press a button to see the screen
2.) When I am in a phone call the screen does not show the keypad I usually have to turn on the screen, click the KEYPAD button before I actually get to enter numbers
This is all Fing annoying because I have to go through it everytime I check my voicemail...
I tried using the search but didn't come up with anything...
Also, what do you all use for registry editing on your Kaiser? I still haven't changed that registry entry to get the WM6 keypad on (vs the HTC which was better than the TERRIBLE ATT one)...
Thanks
Kaiser Tweak, a sticky on top of this sub-forum. First issue adressed is just that, Kaiser going to bed mid-call
Seriously, a brilliant tool. Give it a test ride.
PHM Registry is a nice freeware tool for the Kaiser. Alternatively CeRegEditor will allow you to change the registry via activesync on your pc.
Greets,
While the subject line really says it all, I have intermittent luck with getting the little picture of the keyboard at the bottom of the screen to actually bring up a keyboard.
Does anyone know what this may be, and how I can reset it (without a soft reboot). I can get it to bring up the selector (which lists the screen keyboard as active), but I cannot actually bring up the keyboard.
Thanks!
Hhmmm
I say try a hard reset...I know that's a sucky thing to do ....but I think it will fix you problem
The paint on the hard keypad buttons is chipping off between the right soft key and messaging key, it looks terrible when the backlight comes on. I've found where I can order a new keypad but don't know how to replace it. Does anyone know how to replace the front keypad of the TYTN II.
Cephas said:
The paint on the hard keypad buttons is chipping off between the right soft key and messaging key, it looks terrible when the backlight comes on. I've found where I can order a new keypad but don't know how to replace it. Does anyone know how to replace the front keypad of the TYTN II.
Click to expand...
Click to collapse
on the tytn wiki on here, I recall seeing a link to someone who'd completely disassembled one, that should provide a general basis to work off of.
http://mikechannon.net/
Hi,
Since several "experiences", I've lost my phone keypad.
How can I reactivate it ?
Is there any other phone keypad skins ?
Hello all,
I have a really odd problem with my Kaiser, whenever i slide open my keyboard to type i loose SIM card connection. If i close the keyboard and turn off and on the phone connection (not the actual phone) it comes back.
If i use the onscreen keyboard to send messages/ emails/ type its fine..only cuts out when i slide open the keyboard.
As far as i can remember it has not been dropped or played around with in the last 3 days to have caused this.
I have also stripped the phone and checked the cableing inside to see if anything was shorting on the case when slid open and it is all fine.
Just did a factory reset on the phone and still the same, changed sim card for a new one and still does it... any ideas? Its driving me crazy as i keep forgetting.