Impossible to enable the phone ringtone !!! - Tilt, TyTN II, MDA Vario III General

Hello,
for now a couple of days, my phone only vibrates when receiving calls.
So I increase the ringtone volume, but when I go back to my ringtone volume preferences, the cursor is down ! So I can't increase the ringtone volume, it remains down to 0 ...
Does anyone else have this problem ?
I'm using the official HTC 6.1 ROM, with Manilla 2D.

Related

ROM to raise volume or add speakerphone?

I just got a PDA2K and, like my iPAQ 6315, I hate the low ringer! It's running WM2003SE, if I upgrade to 2005 will my volume be louder?
Also, I do not see a speakerphone option. Is there one? If not, will upgrading add this functionality?
The ring tone is the same as WM2003SE as it dependant on hardware. But I'm quite sure it is possible to write a software to boost the tones up.
As for speakerphone, the only way to activate it in WM2005 without addon software is by pressing the green button for about 3 seconds during a call.
There are programs already that can activate via software. Do a search in this forum under development and hacking section.
To add to your question, has anyone realised that when we go under Add A Ring Tone section and preview the ring tone there, it is very loud. But when the phone actually rings, it is much softer. Any idea why and how we can ensure the ringing is as loud as the preview?
Hello,
There is 3 cabs file posted which solves 3 sec delay and low rington problem on wm5 Just search .It is basically a registry hack
http://forum.xda-developers.com/googleidx.php?t=43532

sometimes no sound when switch profile

hello,
i have the manufacters rom and futher nothing extra on my htc.
when i switch profile's from silence to ringtone the phone does not always give a signal when i'm called.
when i touch the speaker icon on the startscreen the volume is up,but still no sound.
when i look in my config the ringtone is set to standard,strange because i use another one.
is this a common problem??
and how can i solve it.
thanks

Help:: How to increase incoming volume...?

just wondering if any 1 has come accross this problem?
volume is set to max. when i get incoming call volume very low, cant hear ringing and then one the last ring its loud.
tried win 6.1 and 6.5
thanks

Ringtone problem

Hi,
I have been having this problem for the last couple of days, for some reason the volume of my ringer has dramatically decreased to the point where i can't hear the phone ring when it's in my pocket (wasn't the case before). When i try to play the ring tone (it's a wave file by the way) using the media player the volume is normal and very loud, the same applies to when i play it from the settings->sounds&notifications the volume on the ring tone is perfect, but when i receive a phone call the ringer volume is cut down by more than half, i checked the ringer volume and it's set to the max, I also did a hard reset then restored my files using the sprint backup but the problem didn't get fixed, I tried using a different ring tones and the same happens. any help would be greatly appreciated.
There are three volume controls: System, Ring and In call Volume.
Have you checked the System Volume?
If you press up on the hard volume key, you'll see arrow on the top right to switch to the next vol control. Check there.
HTH
ringtone problem
yea all 3 volumes are set to the max level
ringtone volume problem
the phone has the original stock rom from rogers (canada) hope this helps in any way
Have you got any profile managers installed (G-profile, Phoneweaver etc)?
ringtone volume problem
no i dont have a profile managers installed... so i just noticed that when the phone start ringing and i dont pick up, a second before the phone stops ringing the volume of the ringtone increases to the normal level (then stops ringing), the increase of the ringtone volume happens for like a split second after the caller hangs up and the phone stops ringing. hope this helps in any way. Thank you
Sounds like you have a Ringtone delay problem, there are a couple of solutions.
1. Disable HTC dialer (and use the Winmo one instead), can be done using Advanced Configurator 3.3.
2. Try the CAB I've attached, remember to only use WAV as ringtone though.
I would also recommend adjusting Call Forwarding timing to 30seconds. Settings/Phone/Services/Call Forwarding and get settings.
Disabling the HTC dialer is probably going to be the best solution as the HTC dialer is a hungry resource eating monster but I would just try the CAB and adjusting Call Forwarding time. There are some other REG setting as well but I never found them useful.

[Q] Ringtone volumne

has anyone had any problems with the ringtone volumne on the HD7, and if so were you able to increase the volumne
There is a problem in that the volume is quite low. The way I got around it was to put on my own ringtones, which I recorded at a higher volume, using chevron ringtone manager. Did the same for some alerts and alarms and now I can hear my phone in nearly all noisy environments.
Hi,
I have the same problems. Mine is very quiet, barely audible. The rest is OK. Maybe there is software problem but I do not thing so. After change ROM nothing has improved.
I've tried chevron but it doesnt work. i cant get ringtones

Categories

Resources