What would cause this problem? - Tilt, TyTN II, MDA Vario III General

I went ahead and installed TouchFlow2d. Before I did I ran a back-up. Well I really did not care for the Touchflow2d so I removed it with MemMaid and went to my backup and reinstalled everything I had. Well the problem I have is sometimes when I press one of the selections on my windows screen, the battery status,speaker status, Internet status and phone signal status shows up. The same one that appears when you hit the little icons at the top on the screen. Then I press my selection again then it goes away and the selected program opens up. So go ahead a hit the battery, speaker etc icon at the top of your screen, and that's the one I am speaking of. I use the SBSH iLauncher and the HTC custom screen. Its happens approx 30% of the time.
Any ideas?

Related

Crashing when opening start menu

Hey I need help. I played with a few settings in PocketToolman and after the soft reset I can't get into my start menu. Everytime I do the screen, majority fo the left side of the screen (the area where the menu would take up) goes black and I pretty much lose all functionality on the phone. The only thing i can do is press Power and go to standby but that's about it.
Anyone have this problem before?! I just got the phoen too so I don't know my way around it that well yet. It's been loaded with wm6.1.

cannot boot device.

hi, i have my htc touch diamond flashed with BElite's ROM and this is the first time it happened, and I can't boot the device. It will act like it's starting up, and past the first "htc touch diamond" that shows on the screen, it'll show hte RGB on the bottom right and go black normally, then show it again but with RGB lines all over the screen. sometimes itll make hte htc sound and show hte htc thing then go back to the rgb lines. when i hit reset, the screen is full of different colored lines up and down
Pikeru said:
hi, i have my htc touch diamond flashed with BElite's ROM and this is the first time it happened, and I can't boot the device. It will act like it's starting up, and past the first "htc touch diamond" that shows on the screen, it'll show hte RGB on the bottom right and go black normally, then show it again but with RGB lines all over the screen. sometimes itll make hte htc sound and show hte htc thing then go back to the rgb lines. when i hit reset, the screen is full of different colored lines up and down
Click to expand...
Click to collapse
Hard reset, and if that fails, reflash?
i hit the reset button on the back, but everytime it turns on, it just shows a messed up screen. sometimes white fuzz, sometimes rgb crazy lines, and i think my d-pad and the back is heating up a bit....sometimes itll show hte initial screen.
Pikeru said:
i hit the reset button on the back, but everytime it turns on, it just shows a messed up screen. sometimes white fuzz, sometimes rgb crazy lines, and i think my d-pad and the back is heating up a bit....sometimes itll show hte initial screen.
Click to expand...
Click to collapse
The reset button only does a soft reset, which doesn't sound like it's helping, try hard reset and see what that does.
i tried the hard reset method, but the message that's supposed to pop up doesn't show and no response. maybe its an overheat problem so im letting it sit. but i don't know. The warranty is obviously voided so sending it in is going to cost a lot of...cha-ching.
Hmm... before you flashed, did you do all the things like install HardSPL? If you connect the device to the computer, does it connect (so you can do another flash)?
yeah I have the HardSPL flashed on it. Everything has been working perfectly until this afternooon when i pulled my phone out of my pocket and the screen was fuzzed. I let it sit for hours and it SEEMED to get better because it showed the "device is preparing for first use" screen but the bottom half was crooked and off to a side. and it froze like that. btw thanks for all your help
I let it sit overnight, then this morning when i tried it. EVERYTHING was perfect, i got the date and time setup and the calibration, but when it started to load windows, it frozen, restarted itself and showed rgb dots around the touch diamond initial screen. Thanks for any help.
new symptom: when i plug it in to charge, both pc and ac, it shows that it's charging and it gets warm but, when i unplug it, it keeps showing the center key flashing in the circle it does when it's charging. and it never finishes charging.

Won't Boot - black screen, top bar, vibrates

This morning I noticed my home button wasn't working, so I rebooted the phone and it comes up with the AT&T screen and the Galaxy S screen. Then the screen goes black with the bar on top with the icons, it vibrates, and the screen goes off, then it happens again with the black screen with top bar and vibrate. It happens over and over, even after a battery pull and taking the SD card and SIM card out. It has Cognition 2.2beta on it with the OCLF which I put on weeks ago and I haven't done anything to it lately other than some apps from the Market. Any ideas how to fix this without restoring it completely? (me being smart hasn't backed my stuff up since I flashed Cog)
And I think I realized what caused the problem, the last app I installed from Itching Thumb, from the Market... time to research that now

Can receive calls, texts, but will not wake from sleep and no home screen.

Hello everyone. I have had my Droid Bionic since day one and I have never had an issue with it. It has been wonderful.
Until today. I am on the stock OS. I had a Live Wallpaper that showed a little Android figure that melts based on the percentage of my battery. I went into my Gallery and clicked on "Set As Wallpaper" on an image I took with my camera on the phone.
At the bottom of the phone, a small popup showed up that said "COMPLETED". When I went to the home screen, there was no wallpaper in the background. It was just black, though the icons were still there and it was responsive. I thought maybe the image was corrupt, so I went and tried another image.
This caused the phone to reboot. When it rebooted, there was a notification bar, the time, the lock screen, and a thing that said No Signal. I tried to unlock it, but the phone was unresponsive.
Then I got a text message, even though I had no signal. The notification light was blinking. I could not unlock the phone. I hit the sleep button, and it went to sleep. I tried hitting it again, and it would not wake up.
I tried pulling the battery and putting it back in, and now it won't properly boot. Right when it boots, it goes to sleep (the little shutdown animation). I texted myself from my sister's phone and the notification light blinks, the phone vibrates, and the screen turns on and shows I have a text on the notification bar. The screen and the buttons are completely unresponsive, however.
I tried calling myself from my home line and I could pick up the call just fine and end the call. I could not, however, go back to the home screen while on the call. The capacitive buttons on the bottom were completely unresponsive. When I hung up the call (by touch), it went to a completely black screen with the notification bar showing that I had some text messages and the time and my service, etc.
I have rebooted the phone five times now by removing the battery and it keeps going to this. I have never rooted the phone (I wouldn't even know how to) and I am concerned because of all of the information that I have saved on the phone.
Yes I have tried removing the SD card. Didn't help.
Any suggestions? :/
UPDATE: Now the phone doesn't even boot, it gets stuck at the Red Eye spinning logo. It vibrates twice and the notification light begins blinking, meaning it is letting me know that I have received text messages... but it isn't actually booting to the Android home screen. Really strange...
You should fxz back to stock
It will wipe your application data but not you're sdcard info or internal storage
Sent from my DROID BIONIC using xda premium
Hard reset using all three external buttons
Try doing a hard reset - it's one of those things they only tell you about at the Verizon store when you're stuck:
Once you have the phone on and at least responsive, press and hold BOTH volume keys, then hold the power button down for 10 seconds (it's really about 6, but 10 will do it for sure). This procedure can also be done to force a reboot when you load a gnarly application that sux and locks your phone up - without having to disassemble everything and pull the battery.
Hopefully with any luck, you're phone will do a back-flip and come up!

[Q] T-mobile OTA update softbrick phone

Hello and thank you for attempting to help me. I have a Nexus 6 from T-mobile. My dentist appointment yesterday brought me clean teeth and a terrible phone problem. While I was there yesterday my phone decided to download the 5.1.1 update OTA. I pressed the okay button and it restarted. On boot up, I get a white window saying it is "optimizing apps x out of 138". It does that every time I boot it up. After that window is finished, I get a black backgrounded lock screen. On the lock screen in the usual place is the time. In the top left it says there is no sim card. In the bottom I get the normal call, unlock, camera buttons. I am able to drag down the top to show the notification information. As far as I know there are no settings changed from the factory Nexus 6 I recieved from T-mobile. Now I have attempted multiple tasks to try to access my phone but all have been in vain. Here is a list of what I have tried.
To unlock the phone normally. The result is a black screen, a little beep, a white window that says Google services have failed. After a second or two the white screen goes away and leaves a empty screen. I am still able to hold the power button to reveal the white power off window and it works. I can also hold down on the volume and the power button to create a screen shot. It even shows the whole minimization of the current screen and fall to the bottom like it would if the phone was working properly.
I tried to swipe the call button and all it does is give me a blank white screen with a blue notification bar at the top. I can once again power off or screen shot but nothing else.
I have not tried to swipe from camera yet.
I can drag down on the top notification bar to show the the notifications, quick setting changes (Wifi, data, airplane modes, brightness) and the setting button to go to the setting menu. I can turn the brightness up and down, and turn all the other things in the quick menu on and off but if I click anything (toogle them or slide the brightness) and put the notifications bar back up I get the black screen with the white google services has crashed window. I can power off and screen shot normally.
If i swipe down on the notification bar and press setting It crashes once again and gives the black screen and white window that says google services has crashed. I can power off and screen shot normally.
I tried holding volume down and the power button then went into recovery mode. Held power then press volume up to get to the next menu and then deleted the cache partition. It has no effect that I have noticed.
As stated above, I do not think I have usb debugging enabled, I assume my boot loader is locked. This phone has not been modded by me.
I do not want to factory reset if I do not have to due to the very important phones and numbers i have.
You didn't make a backup before updating ?
Sent from my Nexus 6 using Tapatalk
Unless there is a previous setting in place that I clicked to automatically update it when ever there is one available, I do not remember picking to update. It downloaded and asked me to reset. I assumed it was a small patch and not something that could screw up my phone. I could of though. But no I did not.
infiniteifrit said:
Unless there is a previous setting in place that I clicked to automatically update it when ever there is one available, I do not remember picking to update. It downloaded and asked me to reset. I assumed it was a small patch and not something that could screw up my phone. I could of though. But no I did not.
Click to expand...
Click to collapse
Well, I'd suggest a factory reset even though you are reluctant. Otherwise, bring it somewhere for repair. But chances are they're going to tell you to factory reset.

Categories

Resources