Hi i have problem witch Kaiser showing No Service
someone had such problem , and has some solution maybe
sorry for my English
Regards
first thing would be to check if your sim card isn't bad or have been disconnected from your service, so either call your service provider or put your sim card in another device and see if it gets service.
fone_fanatic said:
first thing would be to check if your sim card isn't bad or have been disconnected from your service, so either call your service provider or put your sim card in another device and see if it gets service.
Click to expand...
Click to collapse
Hi im done all this steps before im ask for help thenks for you answer any another solution Regards
check your radio and see if it is compatible with your rom. You can figure that out by looking at the ultimate radio thread which is a sticky in the Kaiser Rom Development forum.
ALso have you used any external antennas that plug into next to the camera?
One time i stuck a copper wire on mine to use it as an antenna and when i took it out i could never get service unless it was plugged in so i think it damaged the antenna on the device.
Related
Hi
I just got on at&T 8925, I put in sim card and it did not ask for unlock code, so I guess it is unlocked, I put in my sim card (Fido Canada,works in other phone) and it show "no service" can not find phone network signal.
I tried
ATT ROM 1.57.502.2 and
RUU_Kaiser_ROGERS_WWE_1.83.631.4_radio_sign_22.51.88.13_1.27.15.32R_Test.exe
radio 1.27.12.11 and 1.27.15.32
all same problem.
Can anyone help me, are these rom combinations not good? or something wrong with the device?
or anything I need to do?
thank you for your help !
Try another known-good SIM card. If you still cannot get service, then you probably have a hardware issue with the phone.
Sounds stupid, but did you make sure you put the SIM in the right way around.
You wouldn't believe how many people have not done this right.
Sounds like it's not unlocked... when I got mine it wasn't unlocked but it only asked for a code once.... just run the unlocker to be sure...
maybe to hard reset?
Hi thanks for everyone's help.
I think I put the sim card the right way , otherwise it will show 'no sim card'
I am keep trying other rom/radio; still no luck, it either keep searching or say 'no service'
I really hope it is not hardware problem.
hope if anyone has the experience and could help me
it really confuse me.
Thanks
alanalan11 said:
Hi thanks for everyone's help.
I think I put the sim card the right way , otherwise it will show 'no sim card'
I am keep trying other rom/radio; still no luck, it either keep searching or say 'no service'
I really hope it is not hardware problem.
hope if anyone has the experience and could help me
it really confuse me.
Thanks
Click to expand...
Click to collapse
welll this might be a little solution i read in another thread...sum times the phone will not read the sim becuz its not making enough contact to the phone...so maybe a little piece of paper on top of the sim then put it in the phone MIGHT help..if it doesnt then ur phone is jacked up =P
or
when i put my tmobile sim in my unlocked 8925 it worked and then a couple our couldnt get n e service... and i checked my brothers phone and dad and they didnt have service too... so maybe sumtimes the network will nto work for a while. or sumthing
If you go in the phone options and do a manual network search, does it find anything?
Thanks brian_v3ntura:
but I tried paper, same thing, maybe not be contact problem.
Thanks kilrah:
I tried that, it shows " cannot read setting from network, try viewing setting later or disconnect data connection and try again."
I did saw something online that maybe because the Fido sim card maybe old (about 3 years), but it did work with sth. like Samsung blackjack II. maybe Kaiser is more complicated.
just wonding if anyone have experience that old sim card may have problem with new phones.
I will keeping trying...
My SIM card is about 4 years old.
I'd bet your Kaiser has a hardware problem.
Hi, guys
I tried a friend's Fido sim card, it works, I don't what's the difference, but it is just like that, maybe I should go get a new card.
Thanks everyone.
good
as one of the boys ur sim might be damaged/old (power failure issues most likely)
alanalan11 said:
Hi, guys
I tried a friend's Fido sim card, it works, I don't what's the difference, but it is just like that, maybe I should go get a new card.
Thanks everyone.
Click to expand...
Click to collapse
yeah, just what confused me is that the sim card still work with my other phones.
Hey guys,
Long time lurker here... and I'm having the same problem.
I have a foreign (Cyprus CytaMobile Vodaphone) SIM in my Kaiser. A couple times over the last few days I was getting the "no service" but if I reset (turn on/off) the device it was fine. Today I cannot get service on it at all. I tried it in an unlocked 1G iPhone and it didn't seem to work either.
I thought maybe the SIM is dead, however when the device it's in starts up, it asks me for the PIN set on the SIM card. I enter the PIN, and it unlocks the SIM. How could the SIM be dead if the PIN authenticates? However, when I put my regular Canadian Rogers SIM in, it works fine.
Where it usually says "Searching.." on the home screen, I once got "Denied, searching.." but I haven't been able to reproduce it.
Any ideas? The provider doesn't have a local roaming agreement, however for the past year it has always registered on the network and allowed me to check balance and send text messages.
Is it most likely a dead SIM or blocked by Rogers? I'm doubting the blocked part, but the successful PIN entry is what has me baffled...
Thanks!
Chris
Ok different SIM card also from Cyprus Cytamobile in a SE w810 does the same thing. Is Rogers seriously all of a sudden blocking these? There is no local roaming agreement, however I would always get the Rogers welcome text's and even be able to check balances. I've been doing this off and on for 4 years...
Anyone ever heard of something like this?
Thanks,
Chris
P.S. Sorry, getting a bit off topic but I thought the initial problem was related!
EDIT: Ok, I can also see all the SIM contacts and SMS messages stored on the SIM.
alanalan11 said:
Hi
I just got on at&T 8925, I put in sim card and it did not ask for unlock code, so I guess it is unlocked, I put in my sim card (Fido Canada,works in other phone) and it show "no service" can not find phone network signal.
I tried
ATT ROM 1.57.502.2 and
RUU_Kaiser_ROGERS_WWE_1.83.631.4_radio_sign_22.51.88.13_1.27.15.32R_Test.exe
radio 1.27.12.11 and 1.27.15.32
all same problem.
Can anyone help me, are these rom combinations not good? or something wrong with the device?
or anything I need to do?
thank you for your help !
Click to expand...
Click to collapse
I also have the same problem with my tytn, I have a bad feeling it is hardware If you manage to find the problem please let me know. I have tried the paper thing and also all new firmware and OS nothing helps
Try setting it to GSM only (disable 3G) and see what happens.
To do that go to Settings->Personal->Phone->Band->Network Type=GSM.
If it works then, you might want to read this thread: http://forum.xda-developers.com/showthread.php?t=419803
Hi I need help with my Tilt. When I place my sim card in it has no service for the current network. The phone has been dropped and I am unable to determine what is wrong with it. Please help. The sim does work on other phones. I have also tried hard reset, firmware upgrade, and others things.
you are pointing to a possible damage in the antenna (radio) component
redenvy20 said:
Hi I need help with my Tilt. When I place my sim card in it has no service for the current network. The phone has been dropped and I am unable to determine what is wrong with it. Please help. The sim does work on other phones. I have also tried hard reset, firmware upgrade, and others things.
Click to expand...
Click to collapse
How do I fix or replace the antenna (radio) component? Thank you.
redenvy5 said:
How do I fix or replace the antenna (radio) component? Thank you.
Click to expand...
Click to collapse
I broke my kaiser and had to get an insurance replacement, they sent me one that the radio was 'broken' in, wouldn't grab the signal for gprs. Then the next one red lighted! finally they sent me a good one hope it works.
I bought new TyTN II, and when I insert my sim card, he doesn't recognize it, in the top of the screen is text NO SERVICE. In the start/settings/connesctions/connection setup, there is no my country to select, or my operater. Does the new cooked ROM may solve my problem? Please help...
buware said:
I bought new TyTN II, and when I insert my sim card, he doesn't recognize it, in the top of the screen is text NO SERVICE. In the start/settings/connesctions/connection setup, there is no my country to select, or my operater. Does the new cooked ROM may solve my problem? Please help...
Click to expand...
Click to collapse
Sounds like its sim locked to me read the WIKI PAGE you will get everthing off there as to what to do
I was trying to find something about sim lock, but there is no free solution, just paying... But, are You sure that my problem is locked sim?
buware said:
I was trying to find something about sim lock, but there is no free solution, just paying... But, are You sure that my problem is locked sim?
Click to expand...
Click to collapse
Does it say no sim card, or just no service. If it doesn't recognize the sim card. then it is probably sim locked. If it recognizes the sim card, but just offers no service, it could just be your connection settings.
buware said:
I was trying to find something about sim lock, but there is no free solution, just paying... But, are You sure that my problem is locked sim?
Click to expand...
Click to collapse
Do as this thread goes it will do all you need
http://forum.xda-developers.com/showthread.php?t=433835
Hello,
I didn't want to start a new thread, because this one is somehow connected with my problem
So here it is:
I've been using my phone for about a month, it used to show full network ect. My friend gave me an anthenna for gsm mobiles (well, sometimes it didnt work properly when I was in the basement i.e.) so i tried it. Worked perfectly, except it was sticking out. So i thought that I don't want to use it and disconected it. Since then it shows no service, sometimes "1 dot" in network display. Tried hard reset - didn't work. When i put the anthenna back, it shows full network again.
Please, tell me, what should I try.
Thank you in advance
I seem to recall reading somewhere here that once you put in an external antenna, something gets tripped and the phone will only work with an external antenna from that point on.
Sorry -- don't recall any details. Try searching.
Hey just got new z1 for my wife.
worked fine in 3 days then suddenly NO SIGNAL from provider.
Took my simcrad in that phone no signal.
put my wifes sim card into my z1 then i got signal
Some thing wrong whit the z1?
Have googled hole day cant find a solution plesae help me?
anybody have the same problem?
Cheers Stian
Go via Warranty.
Well same happened to me at first I though was the sim reader but it was the rom that suddenly stop reading the sim and I don't know why. The solution was to flash a different rom and now I am with kitslim. To check the sim reader I used the app "sim card by gsmdev" such app allows to read the sim information like contacts imei etc so if that app reads that info means that the sim reader is OK and you need to flash a different rom or the same. Hope this help
Sent from my C6903 using XDA Premium 4 mobile app
check "network mode" in "mobile network settings" .....
Arnisen85 said:
Hey just got new z1 for my wife.
worked fine in 3 days then suddenly NO SIGNAL from provider.
Took my simcrad in that phone no signal.
put my wifes sim card into my z1 then i got signal
Some thing wrong whit the z1?
Have googled hole day cant find a solution plesae help me?
anybody have the same problem?
Cheers Stian
Click to expand...
Click to collapse
Check if your imei is intact, perhaps you could flash an FTF file which will replace the OS so back everything up first.
Make sure you are inserting the sim correctly (i know you probably are but it's worth checking) ones the sims in the phone it should reboot, could be that the contacts which hold the sim aren't raised enough, don't bother fixing them just take it back if that's the case, if the sim has been inserted incorrectly then theres a chance that the contacts may be bent and if that's the case then your warranty will be void, but in all fairness it sounds like a dodgy phone rather than any of the above.
I'd still do the FTF flash anyway, it's probably the best shot you've got, oh and i've noticed that some peoples phones will read sims and others won't so the fact that it works in yours and not hers although weird, isn't conclusive. Try another sim too.
Hi, fisrt of all I'm sorry if this is not the right site for this thread, I have a P30 pro VOG-L04 that doesn't detect any sim card, I hope someone can help me to solve this issue, I just bought the phone, the person that sell me the phone already told me from that issue, I already checked the sim board and eveything looks good, thank's in advance.
If the device isn't SIM locked then I suggest you check wether the SIM card is properly touching the gold part on the board. You can add some tape to the top of the SIM to make it bulkier. Good luck
Hi, thanks for the help, I already change the sim reader, but nothing happened, a friend of mine tell me that maybe the modem gone wrong, and that's why the phone don't detect the sim any idea how to repair the modem??
Hi friends, sorry to ask but, did someone have the p30 pro schematics? Or the repair manual, I want to see the movil network diagram, maybe I can repair my phone
i know im late but i had this problem for two days after coming back from vacation from a humid place. it seems that the sim board needed reconnecting. what i did (lil technical background) is i opened the back with a heat gun and unscrewed the bottom right part on the phone where the sim tray is and disconnected and reconnected all the wiring on that section. Shame i didnt do this before i formatted the phone before but i hope this helps someone else coz now everything is working as usual. (nothing needs to be removed, just the connections need to be disconnected and reconnected)