The USB micro slot doesnt work anymore, i have a generic uk rom but i havent reverted the hard spl, will it matter?
if hardreset don't do anything I would suspect a hardware issue
I had exactly the same issue:
http://forum.xda-developers.com/showthread.php?t=553478
http://forum.xda-developers.com/showthread.php?t=561070
Send it to SE they eventually gave me a replacement through Vodafone, I advise not to go through the main dealer just go DIRECT to SE.
First off, unless you have an X2 try using a Mini-USB cable instead ... .
That's true, based on Jasand's case check if you are able to connect through USB and see if it is detected.
If not try a different cable (if you have one) and a different USB port + rebooting the computer - all just incase.
By the way, does a red light come up under the power button when it is plugged in?
If this doesn't help contact SE or your carrier for warranty support. If you have no warranty support, or while waiting, you could charge your phone with a generic Li-Ion/Polymer charger such as this: Universal USB Lithium-Ion Battery Charger (~$2 USD) and transmit data (if needed) via bluetooth (there are $3 USD USB dongles out there if you need it).
Hope that helps,
Peter
Related
hi
i lost my USB for PC cable for jabra bt 8010.
please help me, show me what cable i can buy to replace it,
it seems that it can use some other cable to replace.
could you help me
so thanks
could i use the USB for PC cable for BT330/BT500/BT800/JX10/BT 8040 for BT8010.
or could i use universal usb cable which has the same size for this one?
because I tried to find out cable but failed, no one sells that.
please help me to answer this question.
thanks so much
hi, just like you i also need usb cable for my 8010. ive googled high & low but to no avaiL? especially as im in the Philippines . . maybe by this time you have new info? pls help & thanks
Its just a usb-to-micro-usb cable.
thanks, but the micro usb's available on ebay are for motorola & looking at the pics -> - > they look different . .
Micro usb is micro usb. Its a standard.
usb may be a standard, but ...
... apparently the cable ends are not. I've have three different Jabra headsets in the past several years, all of which used a usb charging cable and none of the usb cable ends on the headset side were compatible with each other. I made the mistake of ordering off ebay and the cables I received did not fit my 8010. My advice: Don't buy a usb cable unless the seller can confirm that the cable works with your particular headset.
@kihoalu
thanks very much. if you get wind of a supplier, pls post. im sure there are others who also need this cable
I wish I knew why yours are all different, my 8010 came with a standard micro-USB port. The charger and the computer sync cable are quite normal.
Just bought a Kaiser and there was no sync cable, can I use any old mini USB to USB to flash HardSPL, unlock etc?
yes you can
Thank you amigo!
There are cheaper cables which will only charge the unit and not create a data connection to your pc.
I tried 3 of these cheaper cables until I got fed up and got a quality cable.
So just in case this happens to you... if you got a problem its 99% most likely to be poor cable.
I used my cable and it was fine, flashed HardSPL, and a cooked ROM, I'm getting an original cable anyway just to have it
i have diamond from altell,....i can charging with my cable usb, but i cannot use it for upgrade ROM,....i know this is usb connector problem because i cant even syncronise my diamond with my pc with activesync.
is there any way to upgrade rom/unlock this diamond without usb cable ??? pls help me
If you are trying to install a custom ROM you are out of luck as the SPL unlocker requires a custom SPL afaik. If you are trying to update an official ROM you can just get the .nbh file and rename it as DIAMIMG.NBH in the root of your SD card and hold Vol down and Back key (I think) while turning the phone on until you see the tricolor recovery screen.
One thing to check is to use a different cable. Some cables are charge only and do not carry data signal, or the one you have is bad. Check device manager to see if the PC sees the device at all.
-- Starfox
Is there any chance you used a dock charger with your phone? Mine did the same thing you described (checked cables/USB ports/computers and it is indeed the USB port on the phone), and the only thing I can figure is I used a USB dock for a while with my phone. The phone would connect via USB without any trouble before using the dock, but sometime after using it, I noticed the USB stopped working.
Just curious...
The internal flex cable that goes from the mainboard to the usb port/microphone was damaged, so when I plug my phone in, nothing happens (no charging, no device recognition, etc). Does anyone know where I can find one in the US, so I don't have to wait a month to have it shipped in from China? Thanks,
Hello,
I I get the mi11 5G 8 month ago and everything was ok since yesterday.
My phone didn't want to charge anymore with any cable (official 65w charger included) i try 3 different cable and adapter USB type C and the charge is not coming up.
I connect the phone on computer and i get this message also : usb error "The devices is unknow need more power "
The wireless charge is working hopefully. Since my phone is under warranty i just want your advice before to conlude to send for rma.
Any advice?
-already try :
cable change
adapter change
pc or different power outlet
clean the usb type c of the phone with toothpick
Thank you
This sounds more like a hardware failure, such as usb type-c failure or cable failure.
Since your mi11 5G is still under warranty, it is recommended to contact a nearby customer service.
Thanks ! yes i will and also think that is hardware issue