hi i am stuck now i think i hav destroyed bootloader of magician. i hav tried to upgrade bootloader 1.0 to 1.02 using pnewbootloader.exe. but i failed in that and got message protection found. now i cant reset and cant go into bootloader. magician is working perfectly in windows. no problem in connectiong to pc but reset and hard resents r not working. when i try to rest it just goes dead than i hav to take battery out for few mins and insert it back. cant go into serial mode.
is there any method to change the rom when i try to install new rom it never turns on after first reset from upgarde proggrame and than i get conbnection error. sd card methos is not working becoze no bootloader. it is under waranty but cant send it back to orange because i hav t mobile rom in it. plz help me to sort this out.
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
jjmorris100 said:
Hello all,
first let me apologize for the long post, and my noobiness. I'm new to the smartphone world, I've sucessfully flashed my Kaiser (from work). Also, I would like to thank everyone who is cooking!
I have the HTC Mteor, which I'm trying to Flash to WM6.1.
When I got it (used), I did a hard reset, and it went back to WM5 in Russian.
I believe I successfully unlocked it, and can now get to the tri-color screen.
It reads:
BBEE100
IPL-0.90
BREE100
SPL-2.05
Every ROM (including the original from HTC) opens, forces the phone to the tri-color screen, and then dies. Error 260, 262, etc.
I've searched the forums, and read that the SPL should be 1.10, but I can't get that to install either.
Any help/suggestions?
Thanks,
Jeff
Click to expand...
Click to collapse
install this official rom from HTC
http://rapidshare.com/files/66085556/RUU_BREE100_1.34.261.1_1.38.00.10_HTCRUS_SHIP.exe
Its for RUS QTEK_AO7.
Then you will have SPL 1.10
I have similar problem
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
hi, can any1 send me a link for a ger version of wm6.0pro ?
Wigo said:
I had ROM 6.1 from Futureshock...still problem with radio (my phone couldn´t accessble but signal icon shows good signal, radio version 1.38.0000), so I decided flash some original ROM. Aftet that my booting stuck on HTC logo or Windows Mobile logo. So I can´t use normal way to flashing. Only from SD card or first turn on phone to boot loader mode and than attach usb cable and start flashing. From SD card (where is renamed ROM BREEIMG.NBH) after enter into bootloader mode start loading and than just turn to trhreecolour menu where is BREE100 - IPL-0.90 and BREE100-1.10.0000 and doesn´t want continue. If I flash ROM via USB cable (first go to threecolour mode, than attach cable) than run ROMUpdateUtility.exe and flash process is being started but always die on 2%, than autoreboot and again stuck on HTC logo.
I tried soft reset, I tried lot of ROM versions HTCRUS, HTCEUR, QTEKEUR, FUTURESHOCK but still same problem during flash ROM stop on 2%...
Any ideas how to back life to my MTeoR?
Can I use application like MTTY? Could me help this program?
Thanks for any help...
Click to expand...
Click to collapse
I'm not sure that I understand well, but if you flash from SD, it finish in 100% and than go to three color boot screen? ....
Hi alebo caf Vašek ;-)
My problem is that always stuck on boot image HTC or Windows Mobile blue screen. I can´t use way copy necesseary files to root of phone memmory and than run sspl etc...I have to turn manualy to three-color mode, than connect USB cable and run upgrade utility but still froze instalation on 2%, If I use SD card methode with BREEIMG file uploading doesn´t start....
p.s.: Ak by si mal dáku radu tak možno lepšie vysvetliť po česky ;-). Moje ICQ 208-393-971
Dík
CZ Rom
I would like to install new ROM into my Mteor, but I have no experience doing it. I do not know which version to try, all I need is to be able to enter czech letters on HW keyboard as with original ROM. Any sugestion? I preffer personal answer in czech language ([email protected])
iv had the elegance rom on my p3600 running perfect so try'd to unlock the phone to half way through it disconected from usb and rebooted but will only go as far as start up i love this phone and want it back the way it was any help please
havent u installed hard spl first?
if not...that could be a problem!
if u did just press the camera+power+soft reset buttons to enter the bootloader and install everithing again...see if that works!
(if i am wrong just correct it)
do have boot loder or spl-9.99.cp?????
whatever i put on just gets stuck on boot loader screen ???
--------------------------------------------------------------------------------
i think i have totaly broke my phone? - i downloaded haykuros spl and flashed it via the anons recovers flash image from sd card, and now i can no longer get in to the recover menu? and no fast boot please please help me !
its just stuck on the g1 screen
If you can't get into anything (recovery, fastboot, normal boot) You have a brick my friend. Check out the JTAG thread for help on unbricking your phone.
hi guys , this morning i installed the new OFFICIAL update for my HTC Desire 626g thats comes up with a notification , but the installation failed and now the phone wont boot , it takes me to recovery mode with the android logo error and a text that say "no command"
I tryed to data/factory reset and cache partition reset with the recovery mode but the problem is still there , how can i make it work again?
If i connect it to the pc it doesnt work please help
ps:sorry for my bad english
whozz said:
hi guys , this morning i installed the new OFFICIAL update for my HTC Desire 626g thats comes up with a notification , but the installation failed and now the phone wont boot , it takes me to recovery mode with the android logo error and a text that say "no command"
I tryed to data/factory reset and cache partition reset with the recovery mode but the problem is still there , how can i make it work again?
If i connect it to the pc it doesnt work please help
ps:sorry for my bad english
Click to expand...
Click to collapse
I have a same problem , I see "No Command" text when I start the phone .
Anyone help us ?
Thanks
Same problem
With software upgrade released today, I've the same problem, loop on recovery.
By holding volume down button on start, the phone will start but lock on HTC log. No solution?
Same problem here on HTC 626g+.
Really angry that HTC would roll out an OTA without thoroughly testing it and thus bricking many many phones.
Any help would be seriously appreciated. Thanks
P.S: Phone is stuck on "No command" screen.
whozz said:
hi guys , this morning i installed the new OFFICIAL update for my HTC Desire 626g thats comes up with a notification , but the installation failed and now the phone wont boot , it takes me to recovery mode with the android logo error and a text that say "no command"
I tryed to data/factory reset and cache partition reset with the recovery mode but the problem is still there , how can i make it work again?
If i connect it to the pc it doesnt work please help
ps:sorry for my bad english
Click to expand...
Click to collapse
Help me to im stuck on htc security warning