I am unable to connect the O2 to my PC,
I can boot to the NVFLASH "Disaster" mode, and also the smartflash mode but windows 7 64 does not see the phone.
When I connect the usb lead the "USB mode screen" does not appear but just when I am switching the phone off the screen appears to connect.
Im using a stock rom.
Try also sorts of drivers but not getting anywhere tried on a win7 64 machine and also a xp machine and still having issues.
any advise welcome
Related
Hey All.
I am on vacation, and just brougth a new notebook (lovely Medion Akoya), and i want to sync with my diamond. However, i downloaded the active sync from the ms homepage, and i get the "Unrecognized device" error all the time.
Yes, i tried to use different cables, yes i tried to deactivate the advanced network, however, i doesnt seem to recognize it at all.
Even if i do a softreset + volume down, i just get the SPL1-40 screen, but eventhou my phone is plugged in the USB, it doesnt say that, only "serial" when i disconnect.
I've been searching this forum the entire day, and i cant seem to find a solution. So, i kindly ask the gurus help me
Diamond running 0.95 bePe and pc running xp sp3.
Kind regards, Heien.
Try to flash a stock ROM and check if you run into the same problem.
In order to sync, you must be running the handset normally, don't enter bootloader mode.
Did the system prompt you for drivers the first time you connected it to the PC? Activesync 4.5 provides the rndis drivers.
the problem is, i cant even flash my device, i tried to flash it, but i get a connection error with the tool.
I know about the bootloadermode, and that i am not able to sync in that state, but i just wanted my pc/diamond to recognize the connection between them. The system did not prompt me for drivers, it just went straigth to unrecognized device. i even tried to point the the driverupdate tool to the drivers folder with the rndis drivers in the as folder.
-i also tried to hardreset my device.
Try doing the same on a fresh stock XP install, without firewall or anything similar.
We need to figure out if it's a problem with the handset itself or your OS/PC.
Try another USB port (DON'T use hubs).
Enter bootloader mode. When you connect it to the USB, it should at least toggle from serial to usb.
If that's the case, at least your USb is working well.
Hello all, I am turning to the Forums since I have spent 5 hours trying to resolve my problem.
Earlier today I installed Kies Mini on my computer in anticipation of the official AT&T Froyo. However, now my computer no longer recognizes my phone at all. It does not show up in the Device Manager, or anywhere.
I tried Uninstalling Kies Mini, Uninstalling the Drivers, Rebooting my phone. etc, etc. But Windows still will not recognize the phone as attached. It worked in the past and I would like for it to work again.
I am currently running Windows 7 64 bit. My Captivate is running Cog 3.4.
Try this:
Uninstall Kies Mini and all Drivers
Reinstall Kies Mini
Once installed turn on USB debugging on your phone and then plug it in, let it install all of the drivers.
Unplug your phone and shut it down
Once shut down activate download mode (hold up and down volume and plug in the USB) again it will install more drivers.
Once this is done unplug your phone, remove the battery and turn it back on, then restart your computer.
Uninstalled Kies Mini, and Samsung Drivers. Reboot
Installed Kies Mini.
Attached Phone to Computer. Nothing.
Also, Tried to Just boot my phone into Recovery Mode. But only boots into Clockwork Recovery. Can't Log into Stock Recovery
Update: Tried hooking up the phone to my XP machine. No Joy. XP did not recognize the device or try to install drivers.
Did you enable debugging?
Sent from my SAMSUNG-SGH-I897 using XDA App
Yes, I placed it in Debug mode. When I plug in my Phone my Title Bar Shows the USB Debugging Android indicating that USB Debugging connected, the USB icon that says Copy files to From Computer. If I click on USB, it gives me the Green Connect Android, then the Orange One. But none of my computers recognize a USB device as connected.
I have tried it with Three different cables. I'm thinking that somehow the phone is not sending some message to Windows saying "Hey, I'm connected"
Did you use the correct drivers for the phone? Can't recall of the top of my head if I can use the standard captivate drivers for windows if your on cognition..
Sent from my SAMSUNG-SGH-I897 using XDA App
I am having this exact same issue - only I updated from JH7 to Official 2.2 (for ****s n giggles) and now pc no longer recognizes phone. Went through the uninstall and reinstall and reboot.... no luck. I've never had this issue before...... ever.
I have tried almost everything i can think of. Anyone have any suggestions?
Sent from my SAMSUNG-SGH-I897 using XDA App
Not in device manager
I have what appears to be a soft brick. I was running the i9000 drivers. I was trying to install the i897. At first Odin recognized my phone and I began to download. The Odin bootloader flash failed. No my computer (Win 7 64 bit) does not even see my phone. Nothing in device manager, not even an unrecognized device.
I can get my phone into download mode. Does anyone have an idea how I can get windows to see me again?
From my experience as long as you are in download mode and have odin opened up it when you connect it, odin should find the phone no problem for you to be able to flash something new to it.
davncari said:
I have what appears to be a soft brick. I was running the i9000 drivers. I was trying to install the i897. At first Odin recognized my phone and I began to download. The Odin bootloader flash failed. No my computer (Win 7 64 bit) does not even see my phone. Nothing in device manager, not even an unrecognized device.
I can get my phone into download mode. Does anyone have an idea how I can get windows to see me again?
Click to expand...
Click to collapse
Have you rebooted the PC? Try to reinstall the drivers again. I had to reinstall the nexus s drivers but I have read some need to reinstall kies to get the drivers to work. Just keep at it. Try other USB ports. My phone wouldn't be recognized for about two weeks with trying everything. I tried new USB cables, drivers and all. Then finally it kind of worked and I went from download mode with a jig to phone!PC and then it took another reboot of the laptop and phone was able to get flashed again via the phone!PC screen. Just keep trying is all I can say.
Sent from My KickAss Captivated CM7 OC'd 1.5Ghz/Undervolted
So I was messing about with Cyanogen Gingerbread, didn't like it and tried to restore a Froyo backup. The backup failed (kernals don't match right?) and now I cannot get past the AT&T screen on a normal power up or when trying to enter recovery. I tried to go back to stock using ODIN, but no com port is opened when I enter download mode and the phone is showing up as an unknown device in device manager. I have installed the x64 USB drivers, but I still cannot get ODIN to recognize the phone. Any suggestions?
When you say you are using x64 drivers, I'm assuming you are running either Vista or Windows 7 64-bit. I have heard there have been issues with 64 bit Windows drivers and getting the computer to recognize your phone properly.
I would recommend uninstalling the drivers, re-download a fresh set of drivers from Samsung and try again. Also, did you try to reboot your computer and attempt to get it to recognize your phone? Try different USB ports also. If it is possible, try a different USB cable. Finally, if you have a 32-bit OS handy, I'd try that.
Hope this helps and good luck!!
i run windows 7 64 and have no problems at all. make sure to uninstall samsung keis.
and reinstall the samsung drivers alone.
Hi..
I am facing an issue with Odin v4.43 .
My Laptop specs are :
USB3.0
HP-pavilion dv6 - 7023Tx (intel i7 3610QM)
OS : Windows 8 -64 bit
.
When i run this application and connect my samsung galaxy S plus device through USB cable, It don't detect Comport nor even displayed "Added" in Message box.
I even installed its 64 bit USB driver but still not. Why?
==================================================================
Whenever i run this application through my old laptop (P4, OS is Windows 7 32 bit and USB2.0 ).
It works and detect the comports and display added in message box.
How could i solve this issue in my new Laptop because i 'll have to leave my old laptop.
Did you already try this:
http://forum.xda-developers.com/showpost.php?p=35227656&postcount=1
hi Gripping,
I installed the same driver on my new laptop but didn't follow the step as mentioned in your refered article.
I try with it then 'll share my experience .
Or this
http://blog.vacs.fr/index.php?post/...ot-detected-problem-on-Android-Samsung-phones
thanks everyone but unfortunately didn't work.
empnetsol said:
thanks everyone but unfortunately didn't work.
Click to expand...
Click to collapse
I was having same problem when I tried to flash with odin (not 4.43). I managed to install the drivers using Heimdall suite 1.3.1. Heimdall comes with drivers folder and a application called zadig inside the drivers folder. It did not work right away but after trail and error it finally showed up as samsung usb driver. sometimes you have to restart your phone to be recognised by your computer. I did on windows 7 too and also I have i9000M. Hopefully will work for you too.
Thanks osterizerble, i have tried many times with different approaches but didn't work.
This is an issue with this machine or might be with 64 bit OS to install its accurate driver completely.
It works smoothly in my old machine without any effort.
It seems Odin V4.43 have the capability to operate through 32-bit systems too.
Thats' the restrictions , i think so.
I have Windows 8 x 64 bit too and I have already successfully flashed a stock Rom to my SGS using Odin.
I used an older version of Odin, I think it's version 1.3.
But my phone wasn't recognized immediately by the PC.
I think it took 2 or 3 times re-starting and re-booting my phone & PC before my phone was finally recognized by Odin.
I used the USB drivers from SamHaLeKe's thread:
http://forum.xda-developers.com/showpost.php?p=11498043&postcount=1
Thansk Gripping and everyone for putting an effort of resolution.
Gripping I am pretty sure,Odin 4.43 will not work.
because i have been tried too mauch with every USB driver with Samsung Kies and after uninstalling it too.
I used SAMSUNG USB Drivers for Mobile Phones (x86 & x64) v1.5.16.0 driver too but it couldn't worked.
Yes Old , I think Odin 3 V1.8 detect Comports and display a message "Added" in Message box.
But i have tried it too, it start flashing and then stuck in no limit of time.
Moreover, i 'll make another try today night again. Hope this may help but i have already tired with it .
It's a good thing nothing happened to your phone when it got stuck in the middle of flashing.
It happened to me twice already, during flashing via Odin, it got stucked and won't continue running. (In my old Windows 7 and recently with Windows 8)
I have no choice but to close Odin and disconnect my phone.
After disconnection, my phone became "hard-bricked". No buttons responding whatsoever.
I was lucky (twice already) to revive my phone and brought it to download mode by doing the following:
1. remove the battery for a few minutes
2. connect the phone to PC via USB cable
3 press the vol down - home button - power buttons and at the same time insert the battery.
After reviving my phone, flashing via Odin became smooth already.
My computer is still giving a same message.
USB drive not recognized and when i come into the device manager, it display 3 wrong things in Other devices.
-> PCI Device
-> Unknown device.
->Unknown device.
empnetsol said:
My computer is still giving a same message.
USB drive not recognized and when i come into the device manager, it display 3 wrong things in Other devices.
-> PCI Device
-> Unknown device.
->Unknown device.
Click to expand...
Click to collapse
Try this may be
http://forum.xda-developers.com/showthread.php?t=2038555
i have already tried with it.
As i Gripping suggest in his first post.
My computer is not recognizing this device.
Moreover, i have tried with solution again but same response.
It says "The best software for your device is already installed".
but i connect my phone, it add three more devices with error as i mentioned in above post.
It shows in device manager "SAMSUNG USB Composite Device".
and when i see the device status
it displays
This device cannot start. Code 10
A request for the USB BOS descriptor failed.
I have the d415 and I have been running the latest version of the UberSlimOS ROM, for two months without any major problems. The only problem I do have is that I am unable to connect the phone to the computer. When I plug it in, nothing shows up on the computer or the phone (I have tried this under both Windows 10 and Ubuntu 14.03 & 15.10). I have installed and uninstalled the LG drivers on Windows. I have tried installing another rom (OrionLP) with a clean wipe. Neither of these work. The phone shows up when I plug it in when it is booted in recovery mode, but in regular phone mode I get nothing.
What should I do