I'm using 'Overcome' ROM and I restock it to Samsung Firmware 2.2
Before I moved to 'Overcome' I did a Full Backup with 'ROM Manager'
Now I want to restore it but I keep getting the Samsung 3e Recovery instead CWM
I installed 'Rom Manager' and tried to install the Recovery from there
but when I reboot it still shows the 3e Recovery...
Does anyone know how to switch that 3e Recovery?
Thank you and sorry for my bad English.
Flash the chainfire kernel. Be sure to flash the kernel for froyo roms, not gingerbread roms.
But I think you should follow their guide, and upgrade your tab to overcome, rather than restore.
Related
Hey Guys,
I have an International I9000 Galaxy S.
The problem is that I have installed 2.2 Froyo through Kies, then rooted and attempted to install ClockWorkMod with ROM Manager. Whenever I flash and boot recovery, I'm taken to the 3e Recovery Menu, not the CWM Menu.
I can't understand why it refuses to boot :/
Please help a noob
Anyone? .
hi
ive never used rom manager so cant comment on that but why dont you go into dev forum and check out the roms there and on the OPosts theres directions that are easy to follow
most of the kernals have recovry built in
regards
http://koush.tandtgaming.com/recoveries/recovery-clockwork-2.5.1.2-galaxys.zip
I'm not entirely sure, as I don't use Rom Manager either, but I believe that only flashes it so you're only able to access it using Rom Manager. Is there any option within Rom Manager that allows you to boot into CWM?
In my opinion your best bet would be to flash a kernel with integrated CWM, or ideally a whole new custom rom. Much easier.
icecold601 said:
Hey Guys,
I have an International I9000 Galaxy S.
The problem is that I have installed 2.2 Froyo through Kies, then rooted and attempted to install ClockWorkMod with ROM Manager. Whenever I flash and boot recovery, I'm taken to the 3e Recovery Menu, not the CWM Menu.
I can't understand why it refuses to boot :/
Please help a noob
Click to expand...
Click to collapse
Reason being is because 3e does not work with CWM. Only 2e is supported. Check the CFRoot thread, and if your rom falls into the firmware listed, you're in luck. Otherwise, like myself on Froyo JK4, I need to downgrade to 2.1 via Odin, then reboot into CWM.
stan28 said:
Reason being is because 3e does not work with CWM. Only 2e is supported. Check the CFRoot thread, and if your rom falls into the firmware listed, you're in luck. Otherwise, like myself on Froyo JK4, I need to downgrade to 2.1 via Odin, then reboot into CWM.
Click to expand...
Click to collapse
You do not need to "downgrade" you just need to install a different kernel.
I recommend this one http://forum.xda-developers.com/showthread.php?t=822756
Make sure you read through the thread all the answers your looking for are in there.
hey all,
i have an i9000 that when i reboot to recovery, it ALWAYS goes back to recovery 3e which is a pain. I have to use odin to flash to another kernel temporarily to get 2e back to install a simple update, which then turns into a big complete reset flash when it shouldn't. Anyone know why this happens? I am have attempted with docrom ROMs with both voodoo and speedmod kernels which both include clockwork, but reboot to recovery just goes to 3e again instead of clockwork. do i nede to repartition (using odin and perhaps a PIT) or is this irrelevant and something else is up. My friend has the same phone and never had this problem.
Using Docrom JPJ with speedmod kernel and froyo 2.2.1 atm.
anyone help?
did you find any solutions?
I noticed this with my speed mod kernel.
I found that if you pressed the button combo to go into recovery, let the phone first boot, let all the buttons off and press them again and so on until it boots into cwm recovery.
Worth a try!
Do this when in recorvery:
Install update.zip iy should be on the second slot. If not go to the market and install rom manager. Then there should be a option down the menu that says flash clockwork mod. Do that, boot into recorvery and install update.zip. U may need to install yhe update a few times. Then you should have clockworkmod
Sent from my GT-I9000 using xda premium
I installed ROM manager and flashed clockworkmod recovery but when I hit reboot into recovery it goes into the normal android recovery screen. I also tried doing a backup of my old rom but it just reboots into stock recovery screen and doesn't actually do the backup. I tried installing ROM from SD, same thing. I've tried different recovery versions (2.5.1.1, 2.5.1.2) but they all do the same thing. I'm rooted and it has superuser permissions, so that's not the problem. I have ROM manager premium. I've tried uninstalling and reinstalling ROM manager. Please help.
Try installing it through stock recovery. (reinstall pakages)
What firmware you using?
rom manager is only good for eclair and froyo
there isnt a correct update.zip for the captivate on gingerbread.
if on gingerbread flash a kernel with CWM (clockwork) built in.
if on froyo/eclair you must select *reinstall package* from android recovery TWO TIMES in a row!
except FROYO has recovery3e also.....it will not allow unsigned update.zip files.
Ok. I'm on Froyo 2.2. Stock firmware. Trying to get either Fasty II or Cyan. First time doing all this. All this started with the GPS problem... (I know, I know. There's a thread for that.) Plus, I am interested in other ROMs. Just praying I don't kill my phone in the process.
you need to look at Odin/heimdall a CWM kernel, or fixing your recovery 3e to accept unsigned zips
^That. Fasty II needs Gingerbread bootloaders
OK. Well, really, I think I'd like to go Gingerbread. I dunno. There's too many to choose from. I want to get CWM working first. Where's the forum to install manually? There's so many places to look...
If you are going to GB flash a leaked stock first that contains boot loaders. Does your phone take well to 1 clicks?
Augh! I used Odin to flash the kernel. I had a temporary success. I had cwm up and it backed up my old rom. I rebooted twice into cwm. Third time, it reverted back to old android recovery. Like I said... Augh!
-Typed while driving on my Captivate- []
Flashed it again. Got CWM back up. Now, moving on to figuring out getting gingerbread. Any tips here are greatly appreciated as long as they make sense.
Also, what is 1 clicks?
Odin 1 click that will flash a leaked stock rom like 2.3.3 KF1 or 2.3.4 KH3 or 2.3.5 KI2. If they include Bootloaders you can just flash a cwm kernel and ready to flash any rom you like.
Hi
I rooted my Samsung Captivate by using SuperOneClick, I am I trying to install CM7.
From the Marked I installed the Rom Manager, but it fails to flash ClockworkMod Recovery Samsung Captivate (MTD). It says "Samsung Captivate (MTD) does not have an official supported ClockworkMod Recovery yet. Have you installed a ClockworkMod based Recovery manually? Yes/No"
If I choose 'Yes' and select ClockworkMod 2.x it says "Rom Manager has been set up to use your existing recovery installation."
If I choose 'No' then the message is "Sorry! Until ClockworkMod recovery is availble, ROM Manager will not work with Samsung Captivate (MTD).
I tried to install CM7 from SD Card, it just return the the Samsung reboot menu (3e). And it doesn't have an option to allow me to select "Install zip from sdcard"
HELP Please
Did you even try reading their wiki? Don't use ROM manager.... Ever.... Useless on our SGS devices.....
prbassplayer said:
Did you even try reading their wiki? Don't use ROM manager.... Ever.... Useless on our SGS devices.....
Click to expand...
Click to collapse
I follow this link to install CM7:
http://forum.xda-developers.com/showthread.php?t=978150
Can you show me the page said "Don't use ROM Manager"? so what software I should use to flash my phone?
I am new to this. Please help. Thanks
Ugh bad instruction from devs.... Just flash a kernel with CWM (Boog's, Corn or Samurai) jump on recovery and flash. Before you start make sure 1) your button combos work (if they don't or you want to get GB bootloaders) 2) have ALL the .zips that you will use in your phone before hand. If you flash one of the kernels I mentioned and you are on the wrong version of android it will NOT bootup, but will boot in Recovery (cwm). Once in CWM flash away as on instruction (if you wan't to Nandroid then you need to flash the correct rom/kernel before had)
Can anyone help link me or teach me how to set up my phone to get into Clockwork Mod Recovery mode? whenever i try to reboot into Clockwork, it just boots into 3e recovery. I have an AT&T Samsung Captivate with stock 2.3.5 Gingerbread rooted and i have already flashed the latest version of ClockworkMod Recovery (2.5.1.2)
I want to overclock my captivate but i cant unless i can get ClockworkMod Recovery to work
Try flashing a rom with CWM already baked into it.
And PLEASE DO NOT use ROM Manager. It doesn't work on the Captivate.
Sent from my SGH-I897 using XDA
argonarcel said:
Can anyone help link me or teach me how to set up my phone to get into Clockwork Mod Recovery mode? whenever i try to reboot into Clockwork, it just boots into 3e recovery. I have an AT&T Samsung Captivate with stock 2.3.5 Gingerbread rooted and i have already flashed the latest version of ClockworkMod Recovery (2.5.1.2)
I want to overclock my captivate but i cant unless i can get ClockworkMod Recovery to work
Click to expand...
Click to collapse
FFS... you are using rom manager.. it hasnt supported captivate since 2.1 eclair.
2.5 clockwork is nowhere near the latest. at version 5 now.
and when rom manager used to work, you boot into 3e recovery then select install update.zip TWICE. (every time)
THEN you will boot into CWM.
**but you arent on android 2.1 so it will error out. then you are going to create another thread for a question that has been answered a million times already.
why do you need clockwork to overclock your phone??? (you dont)
might want to learn what stickies are and go read them for a few days before you F%%% up your phone predominantly. read the new user guide while you are at it.
http://forum.xda-developers.com/showthread.php?t=762171
this is what i am trying to do. I just got into ClockworkMod Recovery somehow but now i cant get out. It keeps looping between the at&t screen and CWM
Any suggestions? or should i reflash the stock rom for 2.3
august 2010... do you think that works on gingerbread when it was released before froyo was released??
i told you to read before you **** up your phone. are we going to listen now?
http://forum.xda-developers.com/showthread.php?t=1294477
flash this kernel .tar with odin
or in CWM (now) go to Mounts and Storage > Mount USB > (plug phone into PC)
copy over the .zip kernel from the thread, then unmount > back > flash zip from sdcard > choose corn kernel.zip
In odin, do i flash as PDA, Bootloader, etc?
im a bit new to this, so i dont no all these fancy pancy stuff
argonarcel said:
In odin, do i flash as PDA, Bootloader, etc?
im a bit new to this, so i dont no all these fancy pancy stuff
Click to expand...
Click to collapse
if you are flashing a kernel then it will go in PDA section but if you are flashing stock 2.3 fw then all the files will go to their respective places
Should I use this link for Captivate with 2.3.4?
Hi,
You told a guy who was trying to get clockwordmod recovery on his captivate, to use this:
[KERNEL][KK4][1/28/11] Corn Kernel v7.06 from Source (OC, BLN, Voodoo Sound, etc.)
Should I also take that advice? I want to put AOKP on the phone, but I have to get clockwork on there first and the normal way doesn't work because of the 3e recovery unsigned business. Thank you much for your expertise and for being a great help to everybody.
-Bob
TRusselo said:
http://forum.xda-developers.com/showthread.php?t=1294477
flash this kernel .tar with odin
or in CWM (now) go to Mounts and Storage > Mount USB > (plug phone into PC)
copy over the .zip kernel from the thread, then unmount > back > flash zip from sdcard > choose corn kernel.zip
Click to expand...
Click to collapse