My captivate audio die it's not the ROM because I flash 5 different ones but the problem is the it comes and goes I have to give it a tap in the back so it could work... But it's more technical then a software issue...
Sent from my SGH-I897 using xda premium
I've read on here on more than one occasion, that the speaker on our phones can come loose, and removing the back cover and pushing firmly in on the speaker will re-seat it. Give it a shot! Hopefully this helps.
Sent from my SAMSUNG-SGH-I897 using XDA
http://forum.xda-developers.com/showthread.php?t=1351278
Sent from my SGH-I897 using XDA
Thanks
Sent from my SGH-I897 using xda premium
It's a consistent issue with cappy's. Looking at the back of the phone with the cover off, the screw on the right side of the speaker is frequently over-tightened during assembly by the manufacturer, thus causing the left side to lift and randomly break connection. If you press to re-seat it and continue to have problems, try backing the screw out about a 1/2 turn (counterclockwise) and try again . Just don't back it out too much or you have the same problem. Good luck!
Sent from my garage using duct tape, empty beer cans, and parts to an old transistor radio.
I will try it in the morning to see how it goes...
Sent from my SGH-I897 using xda premium
Nice it work
Sent from my SGH-I897 using XDA
Glad it worked for you. I use the music player a lot and cannot stand for the speaker to cycle on and off like that. Anyways, enjoy!
Sent from my garage using duct tape, empty beer cans, and parts to an old transistor radio.
Related
So, after recently replacing my phone, I received one with a really noisy battery door. I mean the sliding mechanism to take off the back plate. I've tried to cope with it, but it makes my vibrate unusable due to a huge increase in noise. Also, barely squeezing the slider part makes it creak annoyingly.
Does anybody else have this issue? If so, do you know of any remedies? I'm starting to get really annoyed with this, as it makes my phone feel cheap and I can't stand not having vibrate on during classes.
Sent from my SAMSUNG-SGH-I897 using XDA Premium App
What you can do is put some tape or glue a thin plastic on the inside of the cover to create pressure that should prevent it from moving. It will be on the inside thats way it doesnt look cheap and it will fix both problems. Let me know if it works
Sent from my SAMSUNG-SGH-I897 using XDA Premium App
Gah! Can't believe I didn't think to try this. I put a couple of pieces of card stock under the door and its gone. Thanks!
Sent from my SAMSUNG-SGH-I897 using XDA Premium App
I have to tap/smack lightly on the back of the phone and it will come back in. I assume something has come loose. Is the connection easily accessible on the phone? Or am I going to have to get a different phone?
Pull the battery cover off and firmly press on the speaker assembly...
studacris said:
Pull the battery cover off and firmly press on the speaker assembly...
Click to expand...
Click to collapse
I haven't noticed any problems since I did this. Thanks a bunch!
Mine too
Sent from my SGH-I897 using XDA Premium App
Man there are alot of threads on this subject...
Sent from my SAMSUNG-SGH-I897 using XDA App
Hey I was wondering if anybody else's plastic piece is bulging out on the left side look at the pics below. The first one is the bulged on the left side of the tablet and the second picture is the right non bulged side. Maybe I'm just OCD but now I can't stop looking at it and its driving me crazy.
Sent from my SGH-I777 using xda premium
Mine is like that too. I have the screen lifting problem as well which I fixed using make shift washers.
Sent from my Nexus 7 using xda premium
Responsibility said:
Hey I was wondering if anybody else's plastic piece is bulging out on the left side look at the pics below. The first one is the bulged on the left side of the tablet and the second picture is the right non bulged side. Maybe I'm just OCD but now I can't stop looking at it and its driving me crazy.
Sent from my SGH-I777 using xda premium
Click to expand...
Click to collapse
Your device is just happy to see you...
saadi703 said:
Mine is like that too. I have the screen lifting problem as well which I fixed using make shift washers.
Sent from my Nexus 7 using xda premium
Click to expand...
Click to collapse
Thankfully my screen lifting problem was solved by me just loosening the screws so I'll use that for now until it stops working, but this is bothering me.
Sent from my Nexus 7 using xda premium
Responsibility said:
Thankfully my screen lifting problem was solved by me just loosening the screws so I'll use that for now until it stops working, but this is bothering me.
Sent from my Nexus 7 using xda premium
Click to expand...
Click to collapse
I also fixed mine the way you have done it but that was temp solution and I tried tightening as well and the sponge removing solution but all were temp. This washer solution is permanent one.
Sent from my Nexus 7 using xda premium
saadi703 said:
I also fixed mine the way you have done it but that was temp solution and I tried tightening as well and the sponge removing solution but all were temp. This washer solution is permanent one.
Sent from my Nexus 7 using xda premium
Click to expand...
Click to collapse
Ill have to try it tomorrow, ill need to go to the store and grab some "washers" hahaha
Sent from my SGH-I777 using xda premium
The washers caused the trim bulge for me. Took out the washers and loosened all screws. No more trim bulge and screen lift is resolved, for now.
Sent from my Nexus 7
jweitzel24 said:
The washers caused the trim bulge for me. Took out the washers and loosened all screws. No more trim bulge and screen lift is resolved, for now.
Sent from my Nexus 7
Click to expand...
Click to collapse
Once I get a case this won't even matter because I won't see it but for now I can't stop staring at it.
Sent from my Nexus 7 using xda premium
Did you add in washers, or do you have this bulge without having made any modifications?
Hello, my I9000 is about 4-5 years old, I've been having trouble recently with the audio port.
Some headphones will go in but pop back out, like it's on a spring. Some will go in but my phone struggles to recognise them, when it does the slightest movement will disconnect them.
I've had a look to see if anything is stuck and I can't see anything inside the port.
Anyone have any tips or solutions that may help?
Sent from my GT-I9000 using xda app-developers app
Problem solved.
Inserted a cotton bud (q tip to our American friends) into the audio port and cleaned it out, came out a little dirty. Now it accepts all headphones and even sounds better than before.
Sent from my GT-I9000 using xda app-developers app
I wish I had this phone in 2008 as well >_>
Sent from my GT-I9000 using xda premium
I didn't believe those that said smudges would be problem on this phone, but it definitely is. To top it off, grit is stuck in some of my speaker holes and I've no idea of how to get it out. It sticks out like a sore thumb when the phone is clean...
Sent from my HTCONE using xda app-developers app
Damn that sucks mine has stayed clean for the most part, I don't know what I would do either if mine got like that..The speaker holes are sooo tiny very difficult to get clean..
Sent from my Black HTCONE using xda premium
I find the black quite hard to keep clean aswell I use alcohol and a cloth to combat the grease but I'm a little OCD
Sent from my HTCONE using Tapatalk 2
I have a xtreme full body kit on mine. Completely clear and has 100% clarity. You can't tell there is anything on the front or back. Takes a simple wipe of the phone with a cloth and it shines like new. No case needed.
I have a xtreme full body kit on mine. Completely clear and has 100% clarity. You can't tell there is anything on the front or back. Takes a simple wipe of the phone with a cloth and it shines like new. No case needed.
Click to expand...
Click to collapse
Hey would you mind sharing where you got it from? Would be much appreciated.
Sent from my HTCONE using xda premium
I just throw mine in the dishwasher and it gets clean as a whistle. Top shelf only!
Ahh, finally got some replies.
The body isn't much to wipe off, but in having trouble finding something to maybe poke into the grille holes
Sent from my HTCONE using xda app-developers app
themodafokinley said:
Hey would you mind sharing where you got it from? Would be much appreciated.
Sent from my HTCONE using xda premium
Click to expand...
Click to collapse
Got em off eBay 2 full kits for 8 bucks total and free shipping.
Sent from my skz_tenderloin using xda app-developers app
I just installed xtremegaurd front and back. U can definately tell it's there(as far as the feel). I'm thinking about taking the screen protector off. The back I will leave because I am waiting on my atmosphere case which has a clear back to it so I still can see the back and not worry about debris getting behind and rubbing on the anodization.
Sent from my HTCONE using xda app-developers app
greengoldmello said:
I didn't believe those that said smudges would be problem on this phone, but it definitely is. To top it off, grit is stuck in some of my speaker holes and I've no idea of how to get it out. It sticks out like a sore thumb when the phone is clean...
Sent from my HTCONE using xda app-developers app
Click to expand...
Click to collapse
Toothbrush on the speaker holes
Sent from my Genesis that does what Nintendon't
tuscani1821 said:
Toothbrush on the speaker holes
Sent from my Genesis that does what Nintendon't
Click to expand...
Click to collapse
Piece of tape