Just yesterday I was trying to install a 4.3 Rom for my HTC One. Little did I know, they weren't compatible with the Sprint versions so I technically bricked my phone. I spent all of last night trying to put a stock version back on the phone but even if i'm successful I get a black screen. It would let me go through the "add Wi-fi" screen and set up my phone but after a certain time, it reboots and throws me into a black screen with a toolbar that have no signal, the battery and the time. I currently have the 1.31 version and apparently there are no RUU to help fix the problem. Any suggestions?
I'll PM you when I get home or you can look here
http://forum.xda-developers.com/showthread.php?t=2461414
Related
Guys,
I'm in front of a peculiar problem in my HTC Touch diamond; it started around 2 weeks back when I powered on the device it got stuck up at the point where it displays "Touch Diamond" in white fonts in black background...normally, after this point the version details flash in red font at the bottom right corner... But in this case it's getting stuck up at this point not displaying the version details like R 1.09.25.23 …. etc.
assuming that the battery charge is low, I put the device on charging, then after flashing the centre (round) button white light twice or thrice, the device start reboot again and again got stuck up at the "Touch diamond" point, if I continue to charge the set, this cycle starts repeating endlessly.
Then, to check, I got the battery charged in an external charger for 24 hours, and also procured a thick battery (Model. DIAM171, Rating: 3.7 V DC & 1340 mAh) too, and kept the device open for 48 hours or so. The device started smoothly and was functioning well for next ten days.
Then this insect called "new ROM" started biting my brain (?), and at first I had flashed an unsigned hardSPL v1.40 Olinex. Then Radio 1.09.25.23 and then the Sone wwe 2.1. All the flashes were done individually, and successfully.
And by the way, I'm no monkey to this flashing thing too, of course, the courtesy and credit goes to the whiz kids of XDA-Developers for the learning imparted on me. Earlier I'd flashed i mate KJam, then HTC ARTEMIS successfully too.
But, alas, after running the new rom nicely for a few calls, and after one more soft reset, it has come back to square one. That is, "when I powered on the device it got stuck up at the point where it displays "Touch Diamond" in white fonts in black background...normally after this point the version details flash in red font at the bottom right corner... But in this case it's getting stuck up at this point not displaying the version ......"
Please help...friends.... plzzzzzzzzzzzz...help....
By the way, the device is going to the Bootloader smoothly on pressing the volume down button while soft reset.
I tried hard reset the device by pressing the round button and the volume down button while soft reset the device and did hard reset it successfully. Still the problem remains.. plz buddy, plz help...
Yep, found your post...after replaying to ur PM
But I'll post here my answer in case that anyone else could also been interested in it:
"Sorry to hear this issue, although I haven't seen this post in the forum...
Ok. based on your story I think that this issue has nothing to do with the cooked rom you've flashed.
It seems more like an SPL problem. I'd suggest to flash the latest HSPL, the 1.93 one.
Till now none complained about such kinda issue... They bricked the phone or they didn't...But such kind of intermediate behavior never heard...
An other suggestion, try to flash with a branded ROM (try downloading the latest official for ur device).
Waiting for ur feedback.
Good luck!"
at last my Diamond is working again...
Warm regards to Shaks1979 & SeatOne for ur kind and quick response... anyway, my diamond is working again......Yeterday... I had started flashing the Radio... earlier the Radio version was 1.00.25.03 (that came with my phone from the factory) which was upgraded to 1.09.25.23 as the ROM Cooker i.e. Seatone is too using this radio ( SONE v.2.1 WWE by SeatOne)
Yesterday, I flashed the Radio version 1.00.25.05 and the phone started working again.
Guys, as soon as the phone started working, I had flashed two more roms, just to understand what went wrong, & the ROMs are (v6.4FullHDTFl by christonge) and (XBMOD_V2 by xboxmod). The flashings went smoothly. At this moment my phone is on XBMOD_V2 Rom & Radio 1.00.25.05.
After seating back, I tried to understand what went wrong, why the phone was not going beyond "Touch Diamond" display point (in white font) and getting stuck up at that point before the R.... G..... etc version details appear on the screen with font colour red and background black.
The problem was with the Radio 1.09.25.23; but the mechanism of the problem went tangentially above my head, I'm in total darkness. Guys, can anyone of you genius can throw some light.
I shall wait for your inputs in the matter.
I have the same problem. After rebooting ok it goes to start up and gets stuck at the touch diamond screen with info about the radio and stuff in red. It won't turn on for me to re-flash it.
So you just fully charged it and left it a while without the battery in then tried again and it worked
Any help would be great... 8-s
My screen has been unresponsive for a full day. It was fine when I went to bed last night, and today it's completely unresponsive. I flashed to a different rom, and even to the original sprint rom hoping that would change something - it hasn't.
I'm hoping to relock my phone so I can take it in to a sprint store tomorrow. I downloaded the Securelock.exe file I found in the WIKI but I'm unable to execute it since I can't get past the "align screen"
Does anybody have any suggestions, or anybody run into this problem before have any helpful advice?
I know some of my questions were probably covered in other threads. But I would like to go ahead and explain my case and see if anybody could help me. Any help will be appreciate it.
I recently moved and I was having problems with the reception at my new place. I tried different things. I contacted at&t and they said it could be my SIM card. I replaced it 2 times and that didn't fix the problem. I have always used the stock radio. I got so frustrated I starting flashing new radios to see if I can get an improvement on the signal. I flashed all the radios I found available for my phone. Basically anything older than my current radio will just give me 1 to 2 bars the most. Any radio newer than mine will give me full bars but will not be stable. The bars will fluctuate from 0 to 4 in a matter of minutes without me moving my phone. I had always used EnergyRom until a few months ago, when I started using PrimeV. I never had any problem with any of these ROMs. After flashing radios I realized there was an extra splash screen on my phone. A black screen with while letters: "Touch Diamond2" and at the bottom the radio number. I had never seen this screen before and I tried to remove it by flashing different ROMs, but it didn't go away. I then decided to flash my phone back to stock and flashed both the stock radio and stock ROM. After doing so, I noticed 4 screens will show up before my phone will display my home screen. The first screen is my carrier screen, white screen with at&t logo on it. The second screen is the radio screen, black screen with the Touch Diamond2 letters on it. The third screen is a HTC white screen. The last screen is a black windows mobile screen.
Here is my question. How can I restore my phone back to manufacture? I know how to restore the SPL and flash the stock ROM. I just can't figure out how to flash the stock radio without having that extra splash screen with the Touch Diamond2 letters on. I found a few threads that show you how to flash your own splash screen or change your current one. But I just want them gone. Except for the ones that the phone came with.
I want my phone to be back exactly as when I bought it so I can use the warranty.
Thank you in advance.
just flash it with the stock rom and the black screen will disapeared.
I already flashed at&t's stock room and the black screen didn't go away.
I have CM6 running and love it. Props to the Cyanogenmod XDA crews for making a non-techie such as myself about to stumble through the process. It took some bouncing around between websites but I was able to get it done.
However, I did have a blackout week over the holidays and did drop my phone a few times. Long story short, my smart phone is no longer so smart looking.
I need to get it back to stock just to make sure I don't have any warranty/insurance issues. When I take it in to get replaced.
I tried running the RUU from htc.com and that didn't work. It doesn't get past the Bootloader phase. Something about the phone isn't connected to the USB (even though it is & the comp recognizes it as a android device). This happens when the black screen comes on with the silver HTC letters.
I thought maybe it was the fact that I had a different baseband version (necessary to get Cyanogenmod on there) and when I try to boot into recovery mode to flash the official radio it gets stuck at the white screen with green htc letters on it.
Some things I just noticed as well, I am unable to have the PC HTC Sync software recognize my phone.
Thanks for the help.
I figured it out, don't worry about it
seminerd said:
I figured it out, don't worry about it
Click to expand...
Click to collapse
What was wrong with it?
please state what you did to fix the bootloader screen cause im stuck there too
Hey guys, i've had a look around and i'm in a hurry as im heading to melbourne in an hour or so.
My phone went flat last night and now does nothing..
if i take the battery out for a few seconds sometimes the amber light comes on for about 3 seconds then goes off.
other times it will flash on/off for about 10 seconds then stop.
i cant get into anything, hboot, or even a white htc screen.
Also the weird part is the touch buttons down the bottom vibrate when i press them, however nothing happens?
so ive come to the conclusion of
1. screen is dead? (no liquid damage and no cracks)
2. bricked ( i used the stock ics rooted ruu)
3. battery is dead?
basically i need to work out if i can get it back to stock or what im to do?
maybe someone knows a shop in melb that can do warranty jobs (if warranty will work) any tips would be great right now as i have no phone!
Also how am i going to backup my stuff????
finally got into hboot and did a factory reset. will see what happens
factory reset didnt work so now im trying to get back into hboot
Get into HBOOT and try to RUU it.
Have you installed a custom recovery/ROM? If you have and can get to HBOOT, boot into recovery and reflash your ROM.
I got int hboot once but can't seem to do it again will try again when I get home hopefully I can I have installed the custom ics stock rom that's rooted
took into telstra and tested it there, with a new battery it worked, so now i have to wait a week for them to get a new battery for me. at least it wasnt the phone!!
WinterKnights said:
took into telstra and tested it there, with a new battery it worked, so now i have to wait a week for them to get a new battery for me. at least it wasnt the phone!!
Click to expand...
Click to collapse
i have the same problem right now, phone was half charged i was taking a video at a concert and it froze, i took out the battery and get stuck at the logo! going today to see if its the battery