Hi, I'm using the rom "topogiggi 1.9", which is in the ext4 format. If I had to use the CyanogenMod, I can do it without problems, or do I have to convert to ext3?
CM7 is also using ext4 so you shouldn't have problems going from topogiggi rom to cyanogenmod.
rasmusx said:
CM7 is also using ext4 so you shouldn't have problems going from topogiggi rom to cyanogenmod.
Click to expand...
Click to collapse
Oh, I thought CM7 was ext3.. but I think is fine , the new topogigi rom v 1.9 included with full wipe and partitioning..
It was EXT3 up until CWM v5 was released, then it switched to EXT4.
When I use firmware 2.3.6 +Kernel Abysus (I can use my sdcard in NTFS format)
Today, after update to 4.0.3 my Galaxy Note can't read sdcard with NTFS format.
Help me. Thanks
mathuatden said:
When I use firmware 2.3.6 +Kernel Abysus (I can use my sdcard in NTFS format)
Today, after update to 4.0.3 my Galaxy Note can't read sdcard with NTFS format.
Help me. Thanks
Click to expand...
Click to collapse
Because Abysus kernel enables it..
Wait for a custom ICS kernel to support NTFS
And finally.. WRONG SECTION!!
benthian89 said:
Because Abysus kernel enables it..
Wait for a custom ICS kernel to support NTFS
And finally.. WRONG SECTION!!
Click to expand...
Click to collapse
THANKS
Thread moved
Questions DO NOT belong in Development.
Hi, Do you know a kernel that doesn't convert the partition in ext4 for miui or cm7? I think i have problem with my partition in ext4!
luis1987 said:
Hi, Do you know a kernel that doesn't convert the partition in ext4 for miui or cm7? I think i have problem with my partition in ext4!
Click to expand...
Click to collapse
I think Vadonka's 2.6.32.y kernel is in ext3, but i don't have any idea for 3.0.x version : http://forum.xda-developers.com/showthread.php?t=1427646
PSN>> MEMORY-MOD-v2 SwapAll-v3.0 KERNEL MODDER
USE THIS AT YOUR OWN RISK
INFO:
MEMORY-MOD
SD-EXT partition (/dev/block/mmcblk0p2) on phone's memory card is mounted as /data instead of original internal data partition(stl13)
SWAPALL v3.0
Original Internal Storage (/dev/stl13 on stock GB & /dev/block/stl13 on AOSP) is formatted to be used as swap partition entirely so as to fully take advantage of fast internal data partition and relieving read/write load on memory card.
The third swap partition on memory card created using CWM or MiniTool or Gparted (/dev/block/mmcblk0p3) IF FOUND is used as swap space, with lower priority . So it will be used for swapping only when above mentioned swap partiton on internal data storage is full.
Swappiness set at 30.
Q.) WHATS NEW WITH MEMORY-MOD v2 IN THIS "KERNEL PATCHER" ???
A.) It simply patches an existing flashed kernel on phone
It extracts an existing flashed kernel from the phone
Then it extracts ramdisk from the kernel
Then it patches the required files on ramdisk
Then it builds back ramdisk and compiles back boot.img
Then it flashes the modded boot.img on phone to the phone
REFERENCE Threads: (my ACE threads)
http://forum.xda-developers.com/showthread.php?t=1883211 Memory modded ACE Stock kernels
http://forum.xda-developers.com/showthread.php?t=1960652 Memory modded ACE CM7 kernels
http://forum.xda-developers.com/showthread.php?t=1959779 Memory modded ACE ICS/JB kernels
http://forum.xda-developers.com/showthread.php?t=2184189 SIMILAR KERNEL PATCHER for ACE
PREREQUISITES:
1: Custom kernel to be flashed before installing this script (STOCK based/AOSP/AOKP with ext4 support and init.d support but not Mem-Modded)
2: SD-EXT partition on sdcard formatted to ext4 (u can use this tool PSN_EXT4_Recovery_based_SD-EXT_ONLY_Format_Tool-signed.zip)
3: SWAP support implemented in kernel
4: Atleast 2.1 MB of free space available in /system
5: An SDCARD of CLASS 6 or more (class 4 users please dont report of phone crawling slow!)
NOTE:
1: for fresh install only; user data on original /data will not be moved on /sd-ext; after flashing this script you will have to setup ur phone again.
1: after flashing this you wont be able to directly do a nandroid backup in cwm; so wipe(format) "/data" in recovery before attempting nandroid backup.
2: do not use any int.d script to expand memory using /sd-ext like S2E or a2sd or cronmod or a2sdx etc with this mod else your phone will not boot
3: your phone will boot always as first boot with this script if no memory-card inserted or memory-card inserted without a sd-ext partition
4: Memory-Mod v2 will delete the init.d scrips of adrenaline engine which when unmodified is not compatible with Memory-Mods
5: if your rom has Adrenaline Engine 4.3 or 4.4 which has not been modified by for compatibility with Memory-Mod then you can reflash a compatible Adrenaline Engine 4.4 by flashing this(STOCK version / CM version) AFTER flashing the MEMORY-MOD script.
6: to reflash newer fixed versions of this mod you have to reflash ur non-patched kernel or rom and then flash this kernel patcher in recovery.
Some info:
PSN_STOCK-GB_MEM-MOD-v2_SWAPALLv3.0 : coming soon (provide me with stock-based custom kernel link or boot.img)
PSN_CM7.2-GB-official_MEM-MOD-v2_SWAPALLv3.0 : will work on kernels on official cm7.2 roms
PSN_CM10.1-JB_MEM-MOD-v2_SWAPALLv3.0 : will work on unofficial cm10.1 kernels in roms like Rohans CM10.1 builds
ICS users can try JB version... its almost same .. should work... report if it doesnt work for u
UNINSTALL METHOD: (to get back to old-school 150MB internal data)
1: flash your original non-modded kernel or custom rom
2: flash PSN_factory_reset_EXT4_Recovery_based_Format_Tool-signed.zip
3: you need to setup your phone all over again for old-school 150MB internal data.
CHANGELOGS
Memory-Mod v2
boot.img extracted from bml8 partition on phone
it is split into kernel zImage and ramdisk
it extracts ramdisk and patches required files
it packs the modded ramdisk and builds back boot.img ready to be flashed back to phone
it flashes the boot.img to phone !!
hello psn..nice to see u in mini section
will try it out and report..thanks
edit = maybe u can build us ur kernel with battery extender modules ? just a suggestion..
Nice work.. nice to see an Indian, Maharashtrian from Aamchi Mumbai..!!
A chemical engineer n still interest in android...!! I need to contact u.. for some tips for my future studies..
Awesome I had this idea and googled around but nothing for Jellybean 4.2 or like that. Everyone nays for that SD wear.
The Alchemist said:
hello psn..nice to see u in mini section
will try it out and report..thanks
edit = maybe u can build us ur kernel with battery extender modules ? just a suggestion..
Click to expand...
Click to collapse
possible
Sent from I9300 Jellybam v6.7 4.2.2 (CM10.1+AOKP+PAC) + Yank Kernel v1.5 with latest Mali 400MP driver support.
psndna88 said:
possible
Sent from I9300 Jellybam v6.7 4.2.2 (CM10.1+AOKP+PAC) + Yank Kernel v1.5 with latest Mali 400MP driver support.
Click to expand...
Click to collapse
Can I install this in rohan builds?
Enviado desde mi GT-P3110 usando Tapatalk 2
moliverac8 said:
Can I install this in rohan builds?
Enviado desde mi GT-P3110 usando Tapatalk 2
Click to expand...
Click to collapse
thats a cm10.1 JB ... provide me with its boot.img in its zip and ill upload a JB version too
Sent from I9300 Jellybam v6.7 4.2.2 (CM10.1+AOKP+PAC) + Yank Kernel v1.5 with latest Mali 400MP driver support.
psndna88 said:
thats a cm10.1 JB ... provide me with its boot.img in its zip and ill upload a JB version too
Sent from I9300 Jellybam v6.7 4.2.2 (CM10.1+AOKP+PAC) + Yank Kernel v1.5 with latest Mali 400MP driver support.
Click to expand...
Click to collapse
Here you are https://www.dropbox.com/s/5seqed4y318uvp9/boot.img
Enviado desde mi GT-P3110 usando Tapatalk 2
JB support available
PSN_CM10.1-JB_MEM-MOD-v2_SWAPALLv3.0 : will work on unofficial cm10.1 kernels in roms like Rohans CM10.1 builds
feedback !!!
Didn't work for both AOKP and CM10.1 Tried various things that might have went wrong from my side. I am using CWMR 6.0.2.7. Other than that no script. Stock roms. Ur patch runs fine. Phone boots fine. But no SD-Ext mounted nor Internal Mem is mounted as swap.
Tried with 5.0.2.8 Again nothing on both roms.
ill recheck..
Sent from I9300 Jellybam v6.7 4.2.2 (CM10.1+AOKP+PAC) + Yank Kernel v1.5 with latest Mali 400MP driver support.
can you do it for cm10 link to boot.img
https://www.dropbox.com/s/6g3ozr6lbep7nb3/boot.img
prafiles said:
Didn't work for both AOKP and CM10.1 Tried various things that might have went wrong from my side. I am using CWMR 6.0.2.7. Other than that no script. Stock roms. Ur patch runs fine. Phone boots fine. But no SD-Ext mounted nor Internal Mem is mounted as swap.
Click to expand...
Click to collapse
Confirmed.
not working on Cm 10.1 build 20130310
prafiles said:
Didn't work for both AOKP and CM10.1 Tried various things that might have went wrong from my side. I am using CWMR 6.0.2.7. Other than that no script. Stock roms. Ur patch runs fine. Phone boots fine. But no SD-Ext mounted nor Internal Mem is mounted as swap.
Click to expand...
Click to collapse
prafiles said:
Tried with 5.0.2.8 Again nothing on both roms.
Click to expand...
Click to collapse
darkshadow1997 said:
can you do it for cm10 link to boot.img
https://www.dropbox.com/s/6g3ozr6lbep7nb3/boot.img
Click to expand...
Click to collapse
ic92 said:
Confirmed.
not working on Cm 10.1 build 20130310
Click to expand...
Click to collapse
uploaded another reworked CM10.1 kernel patcher... try it...
psndna88 said:
uploaded another reworked CM10.1 kernel patcher... try it...
Click to expand...
Click to collapse
Still not working. Same results as before.
tried this on CM7, booted but no ext4 partition
Don't working on CM10.1
Enviado desde mi GT-S5570 usando Tapatalk 2
hi i flashing CronMod Unofficial but not worked help me intrnal be full :| i can flashin this scrip on rafael bugies kernel and working
but not working bieltv3 :|
partition on SD card EXT4
ROM : CM 7.2 RC4
kernel : bieltv3 v 3.0 #7 > suport EXT4
pls help me
4550286 said:
hi i flashing CronMod Unofficial but not worked help me intrnal be full :| i can flashin this scrip on rafael bugies kernel and working
but not working bieltv3 :|
partition on SD card EXT4
ROM : CM 7.2 RC4
kernel : bieltv3 v 3.0 #7 > suport EXT4
pls help me
Click to expand...
Click to collapse
First of all it is not the correct section, next time use GT-S5830i Q&A Thread
BTW look at this thread
forum.xda-developers.com/showthread.php?t=2468740