Database Develop

[Q] stuck in boot loop P1000

Good day everyone...
I have one Galaxy Tab P1000 here stuck in boot loop... I really don't know what happened before it got stuck into this loop but it was working fine, it got battery empty and when done charging, it got stuck in a boot loop already...
I have tried to go into stock recovery but the sad thing is that I can navigate through the menu but I can't press the OK button (the power button) to select anything to do. So I searched through the forum and tried a few things, the most notable would be trying to go back to safe stock in the Overcome thread, still it is in boot loop. I tried to go further by installing the overcome kernel... skipping the part where I'm supposed to go to the settings (because basically I cant go to the settings menu).... still I was able to install the kernel and even the Overcome ROM, sadly even with the MOD ROM its still in the boot loop , one thing to note though, when I go into the recovery mode in Overcome ROM I can press the OK button (power button), I mean it responds now and I can basically navigate through the recovery menu and select things from there... but It is still stuck in a boot loop
need some advice

Stock 3e OK button is actually the capacitive HOME button.
Your tab was responding the same in stock as in overcome.
Can't help you about the looping though.
Have you tired restocking again with pit file?
Sent from my GT-P1000 using xda app-developers app

tried the home button too but still no avail it wasnt responsive... i have made all the reflashing with the specific pit file needed it wont get out of the loop

cike said:
it got battery empty and when done charging, it got stuck in a boot loop already...
when I go into the recovery mode in Overcome ROM I can press the OK button (power button), I mean it responds now and I can basically navigate through the recovery menu and select things from there... but It is still stuck in a boot loop
need some advice
Click to expand...
Click to collapse
Try: - (good luck)
choice_A
steps
in CWM, wipe factory reset, cache, dalvik, everything that you can find.
flash kernel CWM6.0.4.5 (from download mode)
install a new rom.
choice_B
flash kernel TWRP2.3.5 (I think or some version similar) (from download mode)
it has some extra WIPE to delete BOOT, RECOVERY, SYSTEM, etc. WIPE them all. If you can manage this, it doesn't even LOOP.
install a new rom.
problem.
There is a TWRP that can't boot into recovery by VOL+_Power. Only can get in from home screen advanced reboot.
may be some other older TWRP can enter recovery, try to find one. I'm not so sure my self.
choice_C
if somehow you managed to boot into home screen, install apk (bootloader check) by chainfire (I think), I had previously experience some dev uses locked bootloader, which doesn't allow you to flash new rom properly.
btw do you know the 8 seconds power button to get a real shutdown?

thanks cx5 im gonna do try all the choices... real reset meaning a powercycle (8 sec hold of power button)

Good luck,
New advances, TWRP solved, now able to boot from VOL_UP+power. See http://forum.xda-developers.com/showpost.php?p=48418252&postcount=365
Suggest to use @terenceng 's rom too, it has one of the highest free ram 487MB.
Another tip, if you hold power button forever it will boot loop forever.
i.e.
from shutdown
4 seconds will boot up (may be it's 3, anyway)
another 8 seconds will shutdown. (may be it's 7, anyway)
total is 12 seconds.
When I didn't have enough experience in counting the time accurately, I overshoot the 8 seconds shutdown to around 12 seconds and it boots up, and I think it is looping. But in fact it is not. I accidentally made it boot up. Hope you don't fall into this condition.
GT-P1000 are fantastic that it can surely shutdown, as long as the 8 sec rule is properly implemented. no more no less.
Then you can always go to download mode. overcome restock has always save my day. Good luck.
cike said:
thanks cx5 im gonna do try all the choices... real reset meaning a powercycle (8 sec hold of power button)
Click to expand...
Click to collapse
---------- Post added at 11:49 AM ---------- Previous post was at 11:46 AM ----------
I forgot to say, locked bootloaders will STOP overcome restock. It will not allow it. Must use bootloader UNLOCK apk. Happened to me so many times in the past.
cx5 said:
Try: - (good luck)
choice_C
if somehow you managed to boot into home screen, install apk (bootloader check) by chainfire (I think), I had previously experience some dev uses locked bootloader, which doesn't allow you to flash new rom properly.
Click to expand...
Click to collapse

thank you for the help guys but the problem was actually the motherboard

CWM or TWRP Recovery Black Screen

Hi all.
I just tried to switch to CM 12.1 with my Samsung Galaxy S4 Active (GT-i9295) but got stucked at the cwm recovery.
Now it work like this: when I hold the volume up+power+home button, the little short phrase about the recovery appears in the top left corner, but after a while, when it usually started showing the recovery tool, the screen just turns black.
Is there any way to fix this? I tried installing the cwm an twrp again throung Odin, but it did not solve the issue and now it even shows that the installation was unsuccessfull. I am still able to access the original Samsung UI after some time waiting, but I wanted to get rid of that in the first place...
Please help, if you can!
Thanks a lot...

Boot loop after Installing boot animation. Please help (teclast x98 plus ll)

Hello all,
I rooted my teclast x98 plus 2 (c2e3 android only) and everything was perfect. I installed boot animations app and installed a new boot animation. After installling I am get to the animation and it stops and boots again. I did make a backup in twrp but here is my issue. I can hold down the power button and volume down to get to the recovery selector but my power button is unresponsive to select anything. It works to power off and on the tablet though. My options are recovery selector , bios and fast boot dnx. I tried reflashing the official firmware with phone flash tool but fails at 4%. I can also select efi shell ( any commands to recover from there?) any help is so appreciated.

Same problem 100%
But i am with the original files. Didnt flash anything.
Stuck on the boot animition...

SM-T510 BOOT LOOP issue

Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!

Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro

frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
Original firmware I used to fix my sm-t510
Account Suspended

flavarasa said:
Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro
Click to expand...
Click to collapse
I think "restarts" may be confusing. Switch from down to up as soon as the screen turns off.

frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
You can use frija.exe to get the latest stock firmware. To get TWRP you MUST boot to recovery before system. If you allow the tablet to boot to system first, it will overwrite TWRP with the stock recovery. Do this by pressing vol down and power till the screen turns off. As soon as it does, switch from vol down to up while still pressing power and keep holding both till the red warning message appears. You also need to leave the cable attached to the PC while doing this.

Alcatel boot loop, recovery not working.

Greetings fellow nerds. I apologize if this thread is in the wrong forum. I didn't see the model of Alcatel I have within the selections.
So I'm dealing with an Alcatel Calypso that a friend of mine has that is stuck on a boot loop and will not go past the Android Go logo. We have tried to pull the battery and other troubleshooting steps but nothing works. Also, we are not able to boot to recovery to fac reset it. When we get to the menu with the option to select to boot to recovery, it just falls back into the loop.
Pressing the volume UP key, along with the power at startup, brings up the boot select menu but selecting fast boot makes it freeze up while Normal boot and recovery boot send it back to the loop.
This is a stock phone. No CFW or anything done to alter the OS. Just started to loop after a power up one morning. No recent updates or app downloads to speak of either.
Does anyone have any idea of anything we could try?? I also need to mention that my friend is in another location and does not have the ability to use a PC.
Any help is greatly appreciated as this is his only lifeline due to his current job and situation so I really need to fix this for him. Thank you!!