I just replace the screen for my XT1058 Moto X.
When I put all together, it dont turn on.
With the charger connected, the green led turn it on, but the phone dont. Already tryed uses stronger chargers, with 1 and 2 amps in 5v, and nothing happens.
Open again and use multimeter to check the Bat... Zero volts. In the charger terminals, I got 1.5/1.6v when the bat not pluged. With the bat, turn to 0.7v.
The battery dies ? Any help ?
Thanks.
Related
Hi all.
I've bought a XDA IIi on eBay, with no cradle (An O2 one from UK, and I live in Spain). I received it with a travel charger, for a SPV E200 model, but with the same connector. The travel charger supplies an output of 4.5-12V and 400 mAh. The XDA did not work, so I supposed I received it with the empty batteries (both main and backup batt), so I put it to charge with the travel charger. After 2-3 hours of charging, it still does not work, does not respond to power button or soft and hard reset attempts. But the XDA shows an orange/red blinking light when charging it. According to the manual, it should be an amber solid led when charging it. The only solid led I've seen is a green one on the charger.
I still don't know if it works. I'm receiving and usb sync/charger cable these days, but I don't know if it will light up the PDA.
I've seen some posts where people talked about much more charging hours, and one post talking about that blinking orange led was caused by a low-power charging, and another where talked about it was a problem with empty backup battery. But after 2-3 hours I think at least the backup battery should be fully charged.
I would like to know if anyone knows what does that blinking led exactly mean, and if I have to charge it 24 hours or more until it responds to power button and does anything else but blinking light. Has it to be a continued charging?.
Thank you.
OK, I've received an usb sync/charge cable and a charger, and after some minutes charging it worked. I've got the next conclusion:
Blinking led means charger not giving power enough. Red led means crytical battery level. (So blinking red means no charging power enough and very low batt). Solid led (no blinking red or amber) means enough charging power. Amber led means no crytical batt level.
I hope this helps anyone who got the same problems I got too.
I was just listening to music from TF3D and all of a sudden the screen turned off, music stopped, and the power button at the top was glowing red for a few seconds. I tried turning it back on, removing and reinserting the battery, but nothing happens. I can't turn it back on at all!
One thing I do notice is if I remove the battery, and plug in the usb cable connected to my computer, the power button glows red, but I can't turn it on. If I insert the battery, and then plug in the USB, the button doesn't glow red.
How would I recover the phone?
dinan said:
I was just listening to music from TF3D and all of a sudden the screen turned off, music stopped, and the power button at the top was glowing red for a few seconds. I tried turning it back on, removing and reinserting the battery, but nothing happens. I can't turn it back on at all!
One thing I do notice is if I remove the battery, and plug in the usb cable connected to my computer, the power button glows red, but I can't turn it on. If I insert the battery, and then plug in the USB, the button doesn't glow red.
How would I recover the phone?
Click to expand...
Click to collapse
Try charging your phone for about an hour. The red light under the power button happened to me when i had used up all of my juice.
yeah i had the same problem and i had been very frightened of it...
just charge it...
Ah ok. Weird! Because when I was listening to music I had just taken it off the charger and it said 90% battery! And I had only listened to one song. I guess the battery meter was telling me false info =(
Thanks all
well maybe your battery was still kinda "new" so it wasnt showing correct data
a red light?
cool ... is this a phone or a light-generator?
it was the first pda with making so much noises by optical... but is good ...
Can anyone explain me how is the red light under the power button? The light doesn't come out from the illumination light, does it? I wanna see how is the light. Screenshot will be better.
It doesnt come out form the illumination light. It's by the power button. Usually it blinks when your battery is at 5% or close to total drained.
It´s a light that´s gives you battery error. I spent 2 days trying to figure it out because my phone wasn´t turning on and the red light was continuissly showin off, at the end it was because of a cheap wall charger (5V and 500ma, when SE uses 5v with 700ma) I just charged with SE wall charger and everything went back to normal.
In your case maybe one of you battery cells broke and that´s why it´s was at 90% giving you that hateful red light.
Here is a post conserning your problem:
http://forum.xda-developers.com/showthread.php?t=452402&highlight=red+light,+button
i think the battery is low quality fake..
i found out that the fasted way to charge your empty battery is:
1. remove your battery
2. insert you mini usb charger (NOT usb>mini-usb from your computer)
3. watch if the red light is on. (underneath your power button)
4. insert your battery.
5. after 5/10 minutes your X1 is working again.
you can do it by just plugging your charger on when it's empty but then it can take up to 2 days (YES, i have experienced it) to make your X1 working again.
another way is, just plug the wall charger to your x1 then leave it there. the x1 do not wake up that quick because the charge voltage goes up grandually/slowly for protect your battery and phone after the battery voltage same as charge voltage, then it can be charge normally*
Thank god that I read this topic yesterday. Otherwise I would have pissed my trousers because I had the same light today.
Hello, I have a problem with my HTC Kaiser. It is almost 2 years old and also a little bit battered, so I don't think, I have chance to get a warranty repair.
So, my Kaiser stopped recharging it's battery. When I plug AC adapter or USB cable, it is not charging, although USB is working (ActiveSync is synchronizing, internet sharing is working ...).
There are three scenarios: If the phone is ON and I plug in the cable, the display backlight switch into on-external-power mode, but the orange "charging diode" is not lighting.
If I turn off the phone and connect cable, charging diode starts lighting for about 20 seconds and then switch into blinking mode.
But when I quickly press power button, the diode stops blinking and starts permanently lighting, when I wait for a hour and then turn on the phone, the battery is still not charged (not even by a 1%..).
Do you have any ideas, where is the catch? I don't have second battery, so I am not able to test, whether the problem is in battery, or in the cellphone.
Uh, sorry, I forgot some details:
R 1.71.09.01
G 25.75.40.02
D 3.5.ROMeOS
Ehm. Yep. I bought new battery and now it is OK.
Hello guys, sometimes I leave my phone fully discharged and when I connect it to my laptop to charge it, a small light appears next to the USB port, but I don't know the meaning of this light, because I try to turn on the phone but it doesn't, so I have to use a wall charger to charge the phone.
So, what's the meaning of this light ? do you think my phone is really charging when this small light is turned on ?
Thanks for your help guys.
melequicho said:
Hello guys, sometimes I leave my phone fully discharged and when I connect it to my laptop to charge it, a small light appears next to the USB port, but I don't know the meaning of this light, because I try to turn on the phone but it doesn't, so I have to use a wall charger to charge the phone.
So, what's the meaning of this light ? do you think my phone is really charging when this small light is turned on ?
Thanks for your help guys.
Click to expand...
Click to collapse
A usb charger has a low charging rate and you would have to leave it on the usb charge for a while to get it charged up enough to boot. If the white light is on it is charging. My phone will act the same way if I plugged it into the usb on my computer and the phone is dead
Sent from my DROID3 using XDA
The few times the light came on for me, it was when I let it go flat, then put it on a charger, but it didn't yet have enough juice to power back up. Once the battery had a few % back in it, the light went off. I think it's just there to let you know that even though it won't turn on yet, it's still charging.
yes, the white LED is there to say something like "hey, i'm not dead, i'm just really, really, really tired, so don't worry and don't send me to assistance!" more or less
I have a C6003 running 4.4 Stock with an unlocked BL and am rooted. The phone screen is cracked at the top third (not smashed, just 2 long cracks) and that third of the screen does not receive touch input, but still displays. Anyway, the phone is currently out of battery, when I try to power it on, I get either a flash of the Sony logo then 3 blinks of the red LED or just straight to the LED, which is normal. I plug it in to charge (tried several USB cable / wall plug combos, up to 2.1A etc.) and the red LED glows solid as it should. Even hours later it still will not power on and gives me the blinking LEDs...It was charging for a total of at least 7 hours and is still not turning on. I have had several battery issues recently but this is the most serious. I am sending my phone in for repair under insurance for the screen but need to back it up first! Any help is appreciated.
EDIT: Quick edit to add the fact that this same issue occurred yesterday as well but it eventually powered on with 15% battery, I used it and it would not charge and so that is why it is run down again. Even when powered on it would not charge, the LED did light and it charged for 5 seconds each time the cable was inserted, but after the 5 the LED would stop and it would stop charging. The phone knew the cable was there though as when it was inserted Stamina mode was disabled (as it should) even though it was not charging?
Roscobigfoot said:
I have a C6003 running 4.4 Stock with an unlocked BL and am rooted. The phone screen is cracked at the top third (not smashed, just 2 long cracks) and that third of the screen does not receive touch input, but still displays. Anyway, the phone is currently out of battery, when I try to power it on, I get either a flash of the Sony logo then 3 blinks of the red LED or just straight to the LED, which is normal. I plug it in to charge (tried several USB cable / wall plug combos, up to 2.1A etc.) and the red LED glows solid as it should. Even hours later it still will not power on and gives me the blinking LEDs...It was charging for a total of at least 7 hours and is still not turning on. I have had several battery issues recently but this is the most serious. I am sending my phone in for repair under insurance for the screen but need to back it up first! Any help is appreciated.
EDIT: Quick edit to add the fact that this same issue occurred yesterday as well but it eventually powered on with 15% battery, I used it and it would not charge and so that is why it is run down again. Even when powered on it would not charge, the LED did light and it charged for 5 seconds each time the cable was inserted, but after the 5 the LED would stop and it would stop charging. The phone knew the cable was there though as when it was inserted Stamina mode was disabled (as it should) even though it was not charging?
Click to expand...
Click to collapse
Check this thread out, it might just resolve your issue credits to @AhmedZadjali