Hello,
I have a bricked HTC desire 626G dual sim I tried to flash a rom to fix it (it kept giving me a message saying no command and loading only android recovery mode ),
But it gave me an error so I changed the option to Format ALL+Download and the phone now doesn't even turn on not even to recovery mode or any sign of life
I tried to download all roms but It gives me an error message saying:
BROM ERROR:S_DL_GET_DRAM_SETTING_FAIL(0x138BE)
[EMI] Obtain DRAM Failed!
[HINT]:
Please check your load matches to your target which is to be downloaded.
Related
Hi,
When I Flashing my ROM (CR86 THD v2.6) it stuck on 88%. What should I do?
Can Someone Help ME Please.
Thanks.
Please HELP HELP HELP!
Now when I tried to flash it again with the cr86 THD v2.5 it said
ERROR 264 : CONNECTION
ERROR [264, 274] : CONNECTION
ERROR [302~318] : UPDATE ERROR
ERROR [320~328] : INVALID COMMAND
These errors seldom occur. However, if one of these errors occur, it could not be recovered and the device had to be sent back to the customer service center. In this case, you have to flash a new ROM code...
I see you have a K-Jam, try this.
Download your original ROM from “HERE” scroll down to K-JAM to find your ROM.
Put the phone in bootloader mode and try flashing the original ROM.
if you can still set your wizard in bootloader mode, try to flash button rom on your device.
I try to put in on my Moto G 2014 recovery TWRP through an application called flashify, and agrochemical it no turn on nor load, have tried to make the rom procedure stock \ root \ hard reset (bootloader n no way do as n have access to the phone via USB, it n is found to provide the code where I would use it to make the bootloader)
None of the forward, from getting desperate to try to get my phone without spending a bundle
warnings in Fastboot:
hab check failed for boot
Failed to verify hab boot image
failed to validate boot image
Fastboot Reason: Fall-through from the normal boot mode
you mean the device only start on bootlader?
Hi guys, I buyed a phone used phone with this problem. The original owner tryed to flash a custom rom and at the middle of the progress the phone shut down because low battery. Then, when they turned on the phone, it only boot in fastboot mode. In fastboot mode, Recovery option wont open, Normal boot wont open too. The bootloader is unlocked. Then, i tryed to flsah a 5.0.2 stock rom but the console show me up an error like "FAILED" or "bootloader FAILED" The phone shows "recovery downgrade" in purple. I tryed 6.0.0 too and Kit Kat for the XT1064 USA version. I cant flash nothing, always the same error. i installed Motorola drivers, ADB, etc. Any help?
Bootloader version is: 48.07. I serarched this number in google and it shows a 5.1.1 custom rom. Propably this rom was the same that he tryed to flash before, i dont know. Unlocked status also is 3.
Edit 1: When a choose "Normal boot" it says: Invalid boot Image Header! Fastboot reason: Fall-Through from recovery boot mode.
When i choose "Recovery" it says: Invalid boot Image Header
boot up failed
When i choose "Factory": The phone just restarts into fastboot again...
Checking Motorola Device Update, the firmware inside this phone is: 21.11.17.titan.retuaws.retuaws.en.us what it means, it have android 5.0.2 Lollipop, right?
Hope you can help me
Thanks.
Hello I have a VTR-L09 (Australian) with stock Pie on it. I unlocked the bootloader with the code from Huawei. Then I installed the openkirin AOSP 10 Preview 2 on it which led me to not being to connect to the internet and only occasionally being able to make calls, so that was junk...
Then I tried to install TWRP and FutureROM, but something must have gone wrong (pos user error) and now I can't even use the erecovery as it, after getting the last firmware, throws a "can't verify" error. I since tried to install TWRP via fastboot, but even though it reports success, when I try to boot into TWRP recovery all I get is a screen similar to the fastboot screen only with the below message
ERROR MODE
Attention!
Please update system again
Error!
Func NO: 11 (recovery image)
Error NO: 2 (load failed!)
When I try to boot iut just gets me to the FASTBOOT&RESCUE MODE screen
Is the phone bricked? Where to from here to get it back on stock ROM?
Thank you kindly!!!
Perhaps the device cannot verify the recovery image.
If bootloader is still unlocked, try to flash stock recovery and see what happens.
OK so I have this PRA-LX1, long story short after a dload tonight to go back to stock ROM I ended up with softbricked phone, I can only enter Fastboot/Rescue mode.
Anything else ends up either in error 8 (ROM) or error 11 (Recovery) error.
- I have access to fastboot via adb/fastboot in a PC terminal
- I have FRP Lock, Phone Locked
- Nearly any fastboot command I send ends up in FAILED (remote: command not allowed!)
- I have my bootloader unlock code, but can't unlock because no botting ROM to check OEM unlock in developer options
- Can't flash any recovery (fastboot "not allowed" error)
- Can't seem to launch a new Dload with Vol+&Vol-&Power. Gives black screen "error mode: please update system again - Error Func NO 11 (recovery image)"
I'll try to let the blank screen drain the battery to get a new try to the Dload method... tomorrow