HI! My D5833 was with cyanogenmod but I want the stock rom, so flashed with flashtool and everything went fine but the phone now is stuck in a loop with three red light blinks (dead battery, but I flash with 100% battery) any ideas how can I use the phone again??
When that happens flashing stock with flashtool usually fixes the problem. Considered your are writing in the wrong forum, are you sure you flashed the correct firmware? Also if you have a backup check wipe userdata in flashtool when flashing
Related
I found my old Xperia X8 and thought why wouldn't I try to get it running again.
Back in the day, I flashed a ROM which enabled Multitouch, and a few days later it fried my Motherboard.
Sent it to Service, they repaired it and a few days later it 'died' again.
At least that's what I thought. Now years later I've been thinking. It cannot be dead if it still vibrates now and then and if the LED is still flashing.
I went from 3 red LED flashes to constant red LED while charging, then constant yellow LED and finally it went to green LED.
However, the screen is not showing anything, so I assume it's a software issue or bootloop and need to re-flash it.
Now that I have the green LED my PC is installing drivers whenever I connect it. PCC doesn't recognize it, so I tried to boot into Flash Mode and the drivers wouldn't install.
I didn't try FlashTool yet as it won't run on the PC I am on curently, some .dll issues.
According to the information about the current state of my phone, are these signs good or bad (because I don't remember what certain LEDs mean as I didn't use that phone for years) and would it be worth flashing it? If yes, what stable Build would you recommend for my X8?
I flashed a stock firmware and tried flashing two different basebands.
I believe 06 attempted to boot once and turned off, the other baseband (a different number) is stuck on a endless bootloop without anything displayed on the screen (no logo or anything, just the background light going on and off).
Which stock ROM should I use together with a specified baseband? The model is E15i.
Hi, I know there were many similar topics but this case looks different. I've tried to update my xperia Z using PcCompanion (to newest available kitkat) during flashing i got an error and all I saw after turning it on was grey triangle with warning. PC companion see my phone but cannot repair it (I got error 100), during flashing three different OFW in flashtool it always stucks on kernel or system flashing (excluding them in installation make possible for flashtool to finish the job) It gives constant blue light in fastbot mode but when i'm connecting it in flash mode it only blinks green and then red for a second each and remains black. I can make force shutdown only when it's in charger and being in charger it only blinks with red light and when I want to turn it on it only vibrate once and do and show nothing. It was not rooted, has locked bootloader and battery over 60 % full. Now after a long fight it has unlocked bootloader, custom kernel with recovery acces and installed (i think) custom rom, but when i turn the phone on (what happens only when it's connected to charger) i see grey warning triangle and I'm stuck. Does anyone can help ?
So phone wont boot. All that happens is i either get sony xperia boot screen display for a few seconds or battery charging to display.
fastboot still works but flashmode does not.
I have downloaded a stock ftf, from xperi firm - within flashtool (C6603_10.7.A.0.222_1271-2150_R2E.ftf) and flashed the firmware via fastboot from flashtool. now i get the stock blue bootloader animation but then it just goes back to charging so not sure what to do now?
The phone has never been rooted as far as i am aware and not sure if there is anything else i can do? do i need to flash boot image or is just flashing ftf fine? its been a long time since ive had to go through this stuff...any help would be appreciated.
If anyone could help,
I decided to flash a stock lollipop rom for AIO-ROW. Using SP Flash Tool, I formatted the WHOLE FLASH. After that, I flashed the stock rom (with scatter file) using the DOWNLOAD ONLY option. The flash was successful and the phone boots now (Because when I formatted the WHOLE FLASH before, the phone doesn't boot and led doesn't work when plugged to electricity), but I only get GRAY SCREEN and I can't do anything. The phone still charges because the led indicator lights up when plugged to power. Is there a fix for this? How can I fix this? Please help me and thank you
check out this thread
http://forum.gsmhosting.com/vbb/f95...-white-screen-after-flash-2061785/index2.html
while using phone yesterday it went automatically switched off and afterwards while powering on only sony logo screen comes then repate only that. tried flashing firmware with flashtool it flashes successfully but problem still here.
my bootloader locked unrooted stock rom
any way to turn it back to life.
waiting for experts suggestions.