I was just playing around with my phone and pushing some buttons and figured this out: You don't need to go into Android and reboot into recovery if your phone is off. You can boot directly to recovery by pressing "Vol+" and "power" at the same time, then when the LG logo appears let them both go.
Thanks, but this procedure is already known.
After upgrading to a newer Rom the tablet stays at the logo SAMSUNG.From there I can't power off
the S2,the logo stays in a blank screen.I went to the download mode (Menu+vol down+power button)
and with odin I downloaded the right ROM for the tablet ,after the <<PASS>> in Odin,the updating stops at 32% and again freezes in a blank screen with the SAMUSUNG. I say again,that I can't power
off the tablet even I can't go to recovery as I did before.I was Root and Installed TWRP 3.2.1
Thanks
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro
frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
Original firmware I used to fix my sm-t510
Account Suspended
flavarasa said:
Timing is the key
Set your finger on position where you gonna restart the device.
Hold power + vol down
After the screen restart switch soon as possible you finger to set to recovery by
Hold vol up + down + insert the USB C cable
Remember timing is the key. I have done this for several tabs that screw on my home so you are welcome bro
Click to expand...
Click to collapse
I think "restarts" may be confusing. Switch from down to up as soon as the screen turns off.
frontchasack said:
Hey guys,
So I'm having issues trying to fix my Samsung Tab A 10.1 ( SM-T510 ).
At first I was trying to install a custom TWRP recovery image, and I had a boot loop where it kept getting stuck at the SAMSUNG splash screen(not the initial samsung boot screen that shows TAB A 10.1). I however overcame that issue by factory reseting and through some additional tinkering.
Now the part I'm starting to regret.
I tried once again to flash the custom TWRP to the tablet, but this time I forgot to tick the "autoreboot" setting off.
So ODIN shows a PASS for the flash, but now when the tablet boots its stuck in the following boot sequence:
START:
Initial Samsung boot screen asking to press power button to continue due to unknown boot image source etc
PRESS POWER
SAME INITIAL SAMSUNG BOOT SCREEN minus the power button prompt, lasts for about 3-5 seconds
REBOOT
Now I have managed to get into download mode with the tablet connected to a computer.
I CANNOT get into recovery mode to factory reset the tablet, which was the solution the last go around.
I am starting to think that the only way I am going to get the tablet back in original working order, or any working order for that matter is to:
A: LOCATE original firmware for my device, I believe it is GTAXLWIFI firmware for my device. However the files I have found don't seem to be accepted in ODIN...
B: Try to continue on with the TWRP process, which I have tried to reflash the TWRP recovery that I have, and it shows pass. But, the issue persists.
Any suggestions or help would be amazing!
Thanks!
Click to expand...
Click to collapse
You can use frija.exe to get the latest stock firmware. To get TWRP you MUST boot to recovery before system. If you allow the tablet to boot to system first, it will overwrite TWRP with the stock recovery. Do this by pressing vol down and power till the screen turns off. As soon as it does, switch from vol down to up while still pressing power and keep holding both till the red warning message appears. You also need to leave the cable attached to the PC while doing this.
I flash via ODIN - it says PASS. I reboot using power and up. I remove the power button as soon as it flashes black, but it keeps going back into my ROM and not recovery. I've tried all combinations. Any suggestions?
Maybe you are releasing the power button too early.
The boot loader must boot with the button combination pressed.
Flashed IodéOS 3.1, everything works fine (S10e - exynos). After while of using I restarted device to recovery (from power menu). Device restarted, showed screen with samsung logo, then whit android logo and then boot screen from ROM shows. But it stuck and do nothing (over 15 minutes). Device was very hot.
So I tried restart with buttons (pw + down) and after turn off immediately tried to boot recovery (TWRP, pw + bixby + down) - it just restarted and stuck on boot logo again. So I tried download mode (pw + bixby + up) and again... it just trying to start regularly, but stuck on boot screen.
So I cannot get to TWRP or download mode by buttons! Turning device off is possible only by plugin to charger, restart, then charging animation shows up and if I unplug, device is off.
Any advices? Thanks.
Hello Shumafuk, why not posted in the subject concerns iodes3.1, your answer may be in the discussion thread.
you must have forgotten to do something, wipe or install the pf4 recovery patch put in post #2.
I'm not sure if that is IodéOS related issue. What do you mean by pf4 recovery patch from post #2? It contains phonesky-magisk and changelog only.
I saw that you posted in the discussion thread, an answer will come later to your concern.
Hopefully. Thanks anyway.