Hi all,
I have a great problem that alone I can't resolve.
I have read for some days and for many hours the forum and wiki but I havemn't found the solution for my problem or more probably I don't know how to apply the solution.
I have a v1620,
the w2003 work
but no radio and no imei.
I have tried to install only the radio rom, the completely rom, the original rom but
I get always some errors like country id error or connection error(but the connection work fine).
Originally my pda was Ph20B2 now Ph20b(after an upgrade).
Now I am stuck with no radio and no solution.
I've tried to use ba and hauppage.
Someone can help me?
No radio & IMEI
try to press softreset yet? This happen to my BA as well when i take out the battery and open it first time i have to press soft reset 2 time to let the radio and rom version appear on boot screen
I've tried reset
I've tried with hard and soft reset but doese't work my radio.
I think the problem is more difficult to resolve.
I think that I have no radio rom installed.
thanks
Related
Hi all,
I have a Spanish Vodafone P3600. (S300). I've run into problems while updating the radio ROM and several other things.
I've managed to change the SPL, all versions, no problem. Even the hard SPL. The problem arises with almost ALL ROMS and ALL RADIO ROMS. I put the PDA in bootloader mode and I begin the updating process. Well, it stays at 0% all the time, both in PC screen and PDA screen. When I am tired of waiting (more than 30) minutes, then I have to take the battery off. The PDA goes into bootloader and I have to apply the unbrick procedure.
I have only been able to put the FAMAN 3.5 Spanish ROM (WM6) so the PDA works when I unbrick it. However, it does not have RADIO ROM and it shows "no GSM" at boot and obviously I cannot use it as a phone.
Is it broken? Why can't I flash the radio ROM? Somebody with a similar problem?
Thank you all very much in advance.
Best,
Unsolvable problem
Thanks all for the feedback. Pof was kind enough to address the problem.
I ditched the radio bootloader (not the regular bootloader) and a a result I cannot flash the radio. It seems that the phone has to be sent for repair.
"if it works... don't touch it" I should have paid attention to this
i need help with my phone, ive tried almost all, just udpated my cingular sx66 from wm2003 to wm6 through wiki, almost nothing is working perfectly, my wifi has to click many times in order to turn on, bluetooth paired with my jabra, awful, intermitent sound, can't watch youtube, and many times the phone icon turns off and when i turn it on, it says no service, ive tried with many sims but i have to soft reset almost always in order to read the sim, i already unlock it with the unlocker provided here, ive tried searching for the latest radio rom but i have no idea how to update, tried to install extended rom, no idea, did all the instructions in the sx66 standardization project, it is just a folder with a lot of cabs but not even the auto install runs or do anything, please i need help, i cant use the phone, ive searched and couldn't find anything
thanks for the help
mine working fine... try to hard reset again. btw ur flasing who's ROM?
ok the first thing is that whenever u take the battery out from BA u must soft reset it by the stylus.
and radio link is
http://rapidshare.com/files/131754772/BA_RRPT_Radio_11500.rar.html
upgrade procedure is same as u did before.
i just upgraded using the wm6 Ba wiki, no issue with that, i used the same radio rom you posted 10 times but it never updates, it stays, in "updating device, don't disconnect" for more than 8 mins, so I suppose is not working
rom version: 5.60.00
rom date: 03/02/05
Radio version: 1.02.10
protocol version 1337.35
extrom version: 1.40.125
i think that the extrom installed,
this is something wrong with ur device radio cause i hv sucessfully updated my radio using that files. and also given it to other xda-developers.com members for update and they did it sucessfully.
Too Bad, Ive Tried Everything, The Worse Things Is That I Have Three Exact Phones
please visit :
http://wiki.xda-developers.com/index.php?pagename=BA_Radio_1.15_Upgrade
for make sure your upgrade is valid.
and i suggest this rom :
http://forum.xda-developers.com/showthread.php?t=406372
thanks, this new rom worked perfect, the only thing is that i don't see the htc home as I used to see it with the hour, weather, i just see on the bottom, the ultimate launche but is different, i installed all cabs,e xt roms and extra cabs, im i missing something, thanks
After I did a hard reset, a strange problem appeared.
When I press the power button to put the device in sleep, it does, but after 4-5 seconds it automaticly switches back on.
I tried several things such as soft resetting the device, close all running programs and even another hard reset, but it won't work. I didn't install any programs so far...
More information about my ROM version etc.
Official HTC NLD Rom WM 6.1
ROM Version 3.29.404.0
Radio 1.65.17.56
I hope someone knows something I can try...
rubinho93 said:
After I did a hard reset, a strange problem appeared.
When I press the power button to put the device in sleep, it does, but after 4-5 seconds it automaticly switches back on.
I tried several things such as soft resetting the device, close all running programs and even another hard reset, but it won't work. I didn't install any programs so far...
More information about my ROM version etc.
Official HTC NLD Rom WM 6.1
ROM Version 3.29.404.0
Radio 1.65.17.56
I hope someone knows something I can try...
Click to expand...
Click to collapse
i see you have already tried the following but i'm going to write down how i would go about debugging the problem anyway. first, i would try the following steps in the following order to ensure it is not a software issue (it seems you have already eliminated the possibility that this is a software issue):
0. ensure you are using the correct hard SPL for your ROM. if you have never flashed a custom ROM and if you are using the ROM that came with your phone factory installed, you need not worry about this step or step 2 onwards
1. hard reset your phone and check the behavior of the sleep button BEFORE installing ANY of your favorite cabs and software...you have already done this
2. it is recommended to re-download the ROM image and re-flash it to minimize the possibility of a corrupted download or a bad flash
3. it is also recommended to hard reset your phone immediately after flashing the ROM at the point where it says "tap here to begin", i.e. before the screen alignment wizard
4. once again, test the behavior of the sleep button BEFORE installing ANY of your favorite cabs and software
now lets assume it is a hardware issue...here is a nugget of information that might help you. i remember reading a thread here started by a person who described a problem very similar to yours. it involved a "stuck" camera button. you see, the camera button is TWO-stage...and if the half-press stage is "stuck", your phone will never go to sleep properly. search for this thread for more information.
finally, if this is indeed a hardware issue, it seems strange that it appeared only after you did that very first hard reset...but life is full of coincidences !
good luck!
thanks for your suggestions, I will try them and post results.
no success
I tried the things you suggested, but it doesn't work. I also tried the power button when it says "tap your device..." but the device woke up after 4-5 seconds also.
I checked my buttons (especially the camera button, but that one seems to be well... I can feel the two "clicks" and I can take a picture in a normal way)
I'm thinking it might be a ROM problem or something like that... (but my problem is, if I want to go back to the previous official HTC ROM, the 6.0 one, I probably have to use HardSPL, but I don't like that much because of warranty...)
Ok other question... Can I install the Dutch Vodafone ROM on a non-branded HTC device, or could I get VendorID errors or something similar if I want to keep the original SPL?
fixed!
Ok, I fixed it after installing HardSPL 3.29 and flashing the latest WWE ROM...
Now my power button works perfectly!
I just flashed my Diamond with the: RUU_Diamond_HTC_NOR_2.03.409.1_Radio_Signed_Diamond_52.51.25.26_1.09.25.23_Ship.exe
I'm an norwegian that's in the US studying, so they only gave me the norwegian version. Anyways, everything worked fine until flash, but now my phone refuses to register on the network (AT&T)!
Took the sim-card back to the at&t nokia phone, worked the first time...
I really wants to use my Diamond instead of the crappy nokia, but it would be a shame to downgrade to 1.93 (which worked just fine...).
Someone, please have a solution for me?
simply install a new radio....try 1.00.25.07 that seems to be the only quadband radio..
(you have to flash an hspl before)
It's stuck on 0% and won't continue... Tried several roms :-/
no service?????
is there a soution to this no network problem
THERE IS A CROSS IN THE RECEPTION BAR AND WHEN YOU DIAL OUT IT SAYS "OPERATION FAILED"
any replies appreciated
Quite bad if the official RUU more or less bricks the device, at least turns into just a little computer
It screwed up my Diamond aswell The gprs is completely dead, been up all night trying to fix it, several hard resets etc, nothing helps... if it was a cooked rom I could tolerate it but official roms screwing up our phones this easily pisses me off.
Mine worked again, with the old 1.93 rom!!
What the hell did they do to 2.03? I suppose the radio rom is different at least... But I couldn't change to the old radio when I had 2.03, tried using the HardSpl...
Is it possible to flash _once_ with everything from 2.03, but the 1.00.25.05 radio (which is the one from 1.93)? Doing it sequentually doesn't work.
So what I did, as the final solution:
Flash with stock 2.03 rom
HardSPL
Flash with 1.05.25 radio
Works perfect!
Hmm i did the other way round with my o2 XDA Diamond (1.93 Stock)
1. Hard SPL
2. New Radio Rom (1.09.25.23)
3. 2.03 official Ger HTC Rom (without vendor lock)
works great as well
I've seen this issue a couple of times too. With 1.93 as well as with 2.03. Did not figure out what was the cause but never had a chance to bring the device back to life with some uninstallation or radio flash. I always went back to the SPB Backup from the night before it stopped working propperly.
Hi all,
something goes wrong after flashed 1.56.70.11 on my phone, after logged into wm, there is no signal at all!!
I tried to downgrade to offical at&t firmware (GSM and ROM) but not work.
also tried to unlock radio by using cheetahunlocker, but athena unlocker always hangs at the last step.
anyone encountered similiar issue or know how to fix it?
ps. I have hard spl installed.
thank you!
==================Update 5/8 ==============
it looks like I flashed a corrupted radio firmware.... sigh...
even if I re-flash a correct radio firmware, it won't get back to work.
I am now going to send my treo back to repair
I encountered the similiar issue, I tried serveral ways to downgrade the radio including using mtty, but all did not work.
It's very neccessary to find a way to downgrade the radio to lower edition.