My diamond was working fine till this morning. G-sensor games stopped working the way they should so I did a softreset. My screen went upside down. Hardreset, few roms, calibration utility, no change. Had to turn off g-sensor app just to have the screen the way it should be. Calibration app shows that the vertical sensor is stuck on one side.
Any idea how to fix this?
Related
Got my diamond yesterday and everything seemed fine but the g sensor doesnt appear to be working correctly.
I noticed it earlier while trying to play teeter for the first time. when i tilt my diamond from side to side the ball moves fine but tilting it length ways (top to bottom and bottom to top) does absolutely nothing. have installed the g sensor calibrater but still no change.
Has anyone else experienced this problem?
Any help would be greatly appreciated.
Regards
Jamzi
Also just noticed that when im viewing pictures, before i turn the phone round into landscape mode the picture is upside down?!
have i bought a dud diamond?!
Jamzi
Try doing a hard reset and see if that solves the issue....
If this does not I would suggest checking that you have a recent ROM, and then perhaps updating same...this may do the trick also...
If these fail then it may very well be that you have a hardware issue, return for warranty repair!!!
The best way to test your G sensor is with the pictures in album mode. Here you can rotate the phone in any direction and vertical and horizontal motions also. IF your picture rotates every time your good, if not then it's a hardware problem, and if that's so then take it in for a repair/replacement as previously stated.
I recently upgraded my kaiser with a cooked ROM (shifu 10) radio 3.34 i guess. It worked good. After some days it started giving problem with touch. The right soft key was working continuously without even pressing it. When this happens the power button also stops responding , so i have to pull out the battery to turn of the phone. Then i loaded it with original HTC ROM WM 6.1 radio 3.28/3.29. it worked fine for some hours then the problem re appeared. then after some hours the lcd stopped responding to touch , it responds sometimes.. The keyboard worked fine. Then i went to HTC customer care center. They said LCD needs to be replaced. After getting the LCD replaced the problem persisted. what could be the problem???? Please help...
Have you tried...
Have you tried realigning the screen found in setting/ screen/ align screen?
I had an issue similiar at one time, my stylus really wasnt working well at all i was having to push hard with my fat fingers for touch to work. realigning solved my problem. Worth a try.
When i re installed ROM, i couldn't align the screen properly as it was not responding to touch. I'm sure it's not screen alignment problem. Why didn't touch work properly even after LCD REPLACEMENT?
Check this out. I believe this is your problem.
http://forums.wireless.att.com/cng/board/message?board.id=cingular&thread.id=116836
My kaiser's touch screen suddenly has aquired an attitude. Some time it works, some it doesn't. When I touch nothing happens. Also when I slide open the keyboard, it works, but as soon as I close the keyboard, it stops working again. When I reboot, the screen works, but it stops after some time. Then it works if I open the keyboard. I have done hard reset, but that hasn't solved the problem.
Is there any thing I can do to fix it.
Now the touch works only if keyboard is open and doesn't work when closed. Any tips (already did hard reset twice).
With more research, the touch screen works but only when pressed very tightly at the point shown in figure (See red circle). Is there any solution to this ?
Will this get fixed if Change LCD ? Or can it be fixed by tightening some screws ?
Hello,
I have a Diamond Touch phone, but there's a problem with the g-sensor.
example: at the game Teeter the bal wil stay left on the top. when I move my phone it stays in the corner. So is the sensor broke or is it the software?
Thanx.
You can try to calibrate your sensor with the G-sensor calibration app (its somewhere in settings).
If that doesnt work I dont know.
I don't know what I did (maybe install something) but now my proximity sensor on my HD7 is out of whack. When I do a call it almost instantly goes to black even if it isn't next to my face or anything else. And it won't go back to the regular screen until after the call is over. (Yes I've tried pushign the button on the top of the phone). The phone has worked for months just fine, but a couple weeks ago I noticed this new behavior.
I've tried finding the right ## code to get to these settings but I can't find the one that works with the HD7.
I've tried calling T-Mobile support too, all they said is to hard reset my phone. Which I'd rather not do. Especially if it is a simple setting that can be adjusted.
Thanks
htc hd 7 proximity sensor problem
Hii, l have the same problem but l have not solve it yet.did you solve your problem? Can you help me about this topic.thanks...
I had it number of times in my case hardware issue.
To fix. Take battery out, clean the two sensors on top of screen left to htc logo. Clean properly with washing up liquid as water or finger did not work. Dry it up with phone off for about 1h and presto.
I always trigger the fault on hot day or rainy day.
http://forum.xda-developers.com/showthread.php?t=864311
sensor fix
I FIXED IT HERE watch it on the TUBE at /watch?v=XKk_4sXqqLA[/url] or youube look for proximity sensor fix by DAVERUKY