Helpme Please My HTC Kais130 (AT&T Tilt) NO RUN , IS DEAD, only power on and ( smart mobility in display black) and no more
helpme please
Hello there, we all understand youre frustration. But for beeing able to assist you everyone need to know what exactly happend here? Where you flashing? Did it fell out of youre pocket? What where you doing last on it and so on. Take 5 minutts or more and provide as much info you can then edit youre post. That is AFTER you have searched and digged trought this board using google aswell for keywords on youre issue.
didnt flash, it was working well suddenly is dead, plug in cable usb,and is the same but on screen appear "smart mobility" vibe and then off
hanster said:
didnt flash, it was working well suddenly is dead, plug in cable usb,and is the same but on screen appear "smart mobility" vibe and then off
Click to expand...
Click to collapse
did u try hard reset?
No , i didnt do it, i dont kwon how to do it?
hanster said:
didnt flash, it was working well suddenly is dead, plug in cable usb,and is the same but on screen appear "smart mobility" vibe and then off
Click to expand...
Click to collapse
I know this is a abiouse question but I have to ask, mate.. You are not running flat on batteries? If you havent flashed youre device, and it wount boot and you got power on it you should check youre waranty on the device. Try to charge it for 10 minuts or so (check that you have charging light on) then try to start it again.
I understand you correctly that you havent HardSPL youre device at all or?
hanster said:
No , i didnt do it, i dont kwon how to do it?
Click to expand...
Click to collapse
u should do a hard reset.
Here is a step by step for u:
http://wiki.xda-developers.com/index.php?pagename=Kaiser_Resets
Remember after performing a hardreset, u will loose all your data on your phome(not on SDcard).
Kaiser_Resets
Back to Kaiser Wiki
--------------------------------------------------------------------------------
Soft Reset
Using a stylus, press the soft reset button at the bottom of the phone
Hard Reset **NB** This cannot be performed while the device is connected/charging!**
Press and hold both soft keys
Using a stylus, press and hold the soft reset button at the bottom of the phone
Keep all three buttons pressed until the keypad lights turn off and then flash
Release the soft reset button while still pressing the soft keys
Let go of the two soft keys once the message "This operation will delete all your personal data, to manufacturer default" appears on screen
Finally, press the green call button to perform the hard reset, or press other key to cancel
Bootloader
Press and hold the Camera button
Using a stylus, press and hold the soft reset button at the bottom of the phone
Release both buttons once the bootloader screen appears
did u do it?
this is my phone
this is my phone where is it the soft key
Press and hold both soft keys
I have currently disabled pics so I cant see the pics of your phone.DOnt u have kaiser?
The soft buttons are the ones next to gren and red phone buttons and above messaging and internet buttons.
im doiin that but dont do anything, dont show a message for reset phone what more can i do, can i repair with any software, any test mode , any flash
hanster said:
im doiin that but dont do anything, dont show a message for reset phone what more can i do, can i repair with any software, any test mode , any flash
Click to expand...
Click to collapse
just be sure u are doing the hardreset right. Some guys had problems, cause they had big fonger and they were pushing not just the soft buttons but also a buttons that are around them.
Hold these two soft buttons, then stick the stylus to the hole and hold it there antil a white screen appears where is the message shown. Then push the green phine button.
http://www.mediafire.com/?rc3vbcqdtbh
here you go a video
http://www.mediafire.com/?lrgmtzy4mat
here you go a video of problem the my HTC
hanster said:
http://www.mediafire.com/?lrgmtzy4mat
here you go a video of problem the my HTC
Click to expand...
Click to collapse
Ok, I have seen the videos. Did u try the reset with the kaiser closed?
I remember a thread with similar problem, will try o find it and post back.
PS: In the first video, u have three hands!!
OK, I found this one:
http://forum.xda-developers.com/showthread.php?t=374388&page=3
Similar problem, does your kaiser reboot continuosly or the screen just flashes.
Your best bet is to read the whole thread, try to learn something about mtty and contact gsleon.
Hi everyone,
My HTC Touch Diamond phone appears to be stuck on the TouchFlo screen. I can use the hard-buttons to move around the screen and do the essentials, but I somehow cannot use the touch-screen at all.
Strange thing however is that while I am in certain screens (ie: Call History), whenever I touch the screen, I can see the OK button in the top-right corner show up and go away whenever I remove my finger from the screen.
I've attempted several soft resets and removed the battery for a few minutes, yet still at no avail. Anyone have a clue what could be wrong? I am desperate and don't want to do a hard-reset and lose all my data and settings.
Looking forward to your suggestions!
nobody any ideas?
My personal thought on it is that you probably just need to recalibrate your screen... but I can not figure out a way to get to that option without using the screen. If there was a start button it would be easy, but since we have a sleek phone it doesn't have one.
wizardlizard111 said:
My personal thought on it is that you probably just need to recalibrate your screen... but I can not figure out a way to get to that option without using the screen. If there was a start button it would be easy, but since we have a sleek phone it doesn't have one.
Click to expand...
Click to collapse
It may or may not help but a shortcut to align screen is to hold Enter/Action and press Volume Up.
I only know this because my friend is looking for a way to disable this combo for gaming purposes.
The symptoms sounds like you have installed SensorLock.
When i have it activated i can press the hardbuttons and the upper right corner of the screen.
Try flip your phone and see if it unlocks?
All great suggestions guys! Especially the Enter + VolUp was the one I wouldve wanted to try! In the end, I decided to go to HTC Support and they checked the device. Turned out it was a hardware problem: the connector was loose! After pressing a bit around the lower edge of the screen, the connector worked properly again!
Thanks again for the help guys!
Can anyone tell me what the screens says once you pressed R to reset it. Do I just have to turn it off / on or is further input required? It was running on batteries when I was resetting it - but with 100%.
Background:
Hey there! Since some days my Xperia X1 had a weird error. It worked very well until you opened the Keyboard - then the screen got messy and stayed black even if you closed the keyboard again. Getting it into "Standby" by pushing the Powerbutton for a sec and an 2nd time to "wake it up" everything was fine again (the screen was ok).
It stayed ok until you slide the Keyboard out - even if just a tiny bit, the screen got messy and once fully opened it got dark and stayed dark, until it was closed again and sent into Standby and Back...
Sending it into Standby while the Keyboard was open did not work, it hat to be closed...
I hoped that I could solve this error by a Hard Reset - so I did, but to press the "R" Button I had to use the Keyboard.
So the screen is black again and I don't know if it is still doing a Hard Reset or if it waits for further Input (once you have pressed "R" to reset).
You have a hardware problem, the flex cable is worn out and would have to be replaced.
But to answer your question you have to press space bar after the R.
Thanks! I its't even a year old and the thing broke?!?
Now that's great - I guess i have an Ebay item once it is returned!
So I will have to flash it to a custom firmware back blind but it think that
for flashing the device I have seen tutorials on youtube...
The device powers on. The buttons on the side and button work fine. The animations of the OS are working. I have tried a hard reset, soft reset, and standard power on/off. Does this mean I should try replacing the digitizer? Any ideas that I can get done by the end of the week before I go on vacation.
ddelella said:
The device powers on. The buttons on the side and button work fine. The animations of the OS are working. I have tried a hard reset, soft reset, and standard power on/off. Does this mean I should try replacing the digitizer? Any ideas that I can get done by the end of the week before I go on vacation.
Click to expand...
Click to collapse
I think, You need screen calibration
One easy thing to try: Place the palm of your hand on the screen. Hold it there for 10 seconds. See if it works now. Helps if your hands are warm.
I've had the same problem with screen. It helps if you put your palm over the screen but it's only temporary solution. Does anybody know what is the reason for this and what needs to be done/replaced.
Would appreciate any help.
Hi guys!!!!
My X1acting up.
All of a sudden the screen became non-responsive, i then swicthed it off and tried to reset it by both pressing power button and the reset button at the back.After doing that i rebooted the phone only to find that the screen wont light up but the keyboard does...pls help
what could be wrong? software or hardware?
khakhi said:
Hi guys!!!!
My X1acting up.
All of a sudden the screen became non-responsive, i then swicthed it off and tried to reset it by both pressing power button and the reset button at the back.After doing that i rebooted the phone only to find that the screen wont light up but the keyboard does...pls help
what could be wrong? software or hardware?
Click to expand...
Click to collapse
I think you might have damaged your LCD flex cable.
But first try to hard reset your phone. if it doesn't work try and take it to any mobile shop.
Also have a look at this:
sonyericsson.com/cws/support/mobilephones/troubleshooting/subject/thephonewillnotturnonorthephoneswitchesitselfoffts/xperiax1?cc=is&lc=is
(copy paste the link, they wont let me put outside links...)