Database Develop

Problem .cab installation after flashing

Hello everyone. I wonder if someone can help me on my problem. I recently flashing my HD with ManiaHD ROM (http://forum.xda-developers.com/showthread.php?t=513876) and goes to 1.56 Olinex SPL before. I have 2 problem :
- 1st : a bad screen color when put on my phone (become normal after ON/OFF the screen)
- 2nd : I trying to instal TomTom 7, and the installation (.cab) locked in loading bar (with the hourglass turn and turn again ...). After that, i try to instal another program (always in .cab) and the installation can't run (no error message but the screen is the same with cross in the right upper corner.
Someone have had this problem before? Thanks a lot.
Yogui

yogui said:
Hello everyone. I wonder if someone can help me on my problem. I recently flashing my HD with ManiaHD ROM (http://forum.xda-developers.com/showthread.php?t=513876) and goes to 1.56 Olinex SPL before. I have 2 problem :
- 1st : a bad screen color when put on my phone (become normal after ON/OFF the screen)
- 2nd : I trying to instal TomTom 7, and the installation (.cab) locked in loading bar (with the hourglass turn and turn again ...). After that, i try to instal another program (always in .cab) and the installation can't run (no error message but the screen is the same with cross in the right upper corner.
Someone have had this problem before? Thanks a lot.
Yogui
Click to expand...
Click to collapse
Your bad green screen effect is caused by not following correct procedure to flash rom. You most likely tried to flash rom without using USPL or HSPL. Read cRaCKwHoRe's guide and also section in wiki on green screen which can be found in this page

Thanks for your help. But I'm in 1.56 HSPL Olinex. I try to falshing with the USPL v2.5 and it works find now. Thank a lot
Best regard

yogui said:
Thanks for your help. But I'm in 1.56 HSPL Olinex. I try to falshing with the USPL v2.5 and it works find now. Thank a lot
Best regard
Click to expand...
Click to collapse
You don't need to use both USPL and HSPL. You use one or the other.
Glad you got it fixed though

Cant flash rom any more

Hey
My first post - weee
I been reading and learning from this forum for quite some time now. And I have flash my rom a few times succesfully.
But I upgrade recently to wm 6.5 with the original rom for HTC.
Its not as good as my 6.1 rom, so i have tried to install a different ROM with wm 6.5.
My problem is that it starts ok - the tricolor screen comes and it says USB in the bottom of the screen. The screen then turns white and a status bar is shown (and on the screen of my pc as well). It says 0 % and stays there for 5 minuts or so. Then it says Error 262 and the I have take out the battery and start med phone again.
When i remove the battery and starts the phone im back to my old wm 6.5 original rom - so no harm done.
Why cant i flash my phone ?
I have tried (after reading a lot) to
- unlock the CID ?
- Hard reset
- Soft reset
- using a different rom
Am I missing something or ?

Try flashing from the card rather than PC. or from PC but take out the sdcard. Also make sure you have Hard-SPL still.

Pezzie said:
Hey
My first post - weee
I been reading and learning from this forum for quite some time now. And I have flash my rom a few times succesfully.
But I upgrade recently to wm 6.5 with the original rom for HTC.
Its not as good as my 6.1 rom, so i have tried to install a different ROM with wm 6.5.
My problem is that it starts ok - the tricolor screen comes and it says USB in the bottom of the screen. The screen then turns white and a status bar is shown (and on the screen of my pc as well). It says 0 % and stays there for 5 minuts or so. Then it says Error 262 and the I have take out the battery and start med phone again.
When i remove the battery and starts the phone im back to my old wm 6.5 original rom - so no harm done.
Why cant i flash my phone ?
I have tried (after reading a lot) to
- unlock the CID ?
- Hard reset
- Soft reset
- using a different rom
Am I missing something or ?
Click to expand...
Click to collapse
take out sd card
do hard reset
do wipe data
go to step 0 and begin with unlocker
flash stock rom
now flash rom you would like.
worst case, if you have trouble flashing it - key--combo to bootloader and flash/hardspl from there

Thx
I unlocked the phone using HARD SPL after removing the SD card and flashed it.
It works
Thx for the help.

Do you have a HardSPL? If not, then you won't be able to flash. You need to do some more reading.

shannonknable said:
Do you have a HardSPL? If not, then you won't be able to flash. You need to do some more reading.
Click to expand...
Click to collapse
YOU need to do some more reading. Specifically one post above... the OP had fixed his issue with HardSPL...

I had that problem a couple of times actually. For me, it was that my port isn't quite as tight as it used to be. (That's what she said) So I just have to make double sure that my phone doesn't move during the flashing sequence AT ALL. Otherwise the same problem will occur.
Hope this helps!

whoops same problem to me. I don't read so good when it's friday night. I stand by my advice though for future problems

Battery or Charge / charging LED no turn to Green problem

have every one this problem ?
I have seen this bugfix at the HTC-Support-side for the Diamond2 :
"Update for HTC Diamond2 Power LED Notification"
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
"This update for the HTC Diamond2 allows you to see the battery charging status right from the LED. Now enhanced to illuminate green when fully charged, with a quick look you will know when your phone is powered and ready to go.
Installation Instructions:
Note: This Update only can be applied for ROM version between 1.36.XXX.X to 1.44.XXX.X and 1.66.XXX.X to 1.76.XXX.X "
-------------------------------------------------------------------------------------------------------------------------------------------------------
at my Jade I use the newest official ROM from HTC "2.32.407.2" with radio 41.30.12
i don´t have to try install this bugfix at my Jade, i think don´t works if my Rom version is over this is described for the Diamond2 .
I´ve read here from many users there have a problem with charging the Jade, some different solutions but nothing is a really correct solution to solve this problem.
the different solutions I´ve read is:
a. charge with power on and turn the backlight off (nothing turn to standby)
b. turn the Jade complete POWER OFF not in standby (this works at my Jade)
c. install a third party software for the Icons at the top (especially for the Battery Icon).
d. but the best (ironic) and the coolest solution comes from the HTC support, there I´ve send a mail with a discribe from this problem:
"please call ARVATO-Support to send the Device for Repair" ---- i think the guys from this HTC Support have anyplace in Germany a "one EURO Job" .....
what would this Guys at ARVATO to do with the JADE, they are Sorcerers or have a Cristal-Orb there can see the answere ?
have everyone here another solution ?

Wrong section. Should have been posted under "Jade/Jade".

Hi,
Have you installed any third party software that display a battery icon? If so, that would be the problem. Try to uninstall the third party software and do a soft reset, then try to charge the battery. Thanks.

No, I don´t use 3rdParty Software for the Icons at the Top of the Screen, I use SPB Mobile Shell where I generally don´t see the icons.
I think it´s a bug in the Rom or Radio, it´s the same failure at the Diamond2 and for that Device give it a Bugfix from HTC.

hi
1. if u are using any cooked rom like the Pdaviet rom yes this will happen
2.if ur using only the original rom no this should not happen
u can try doing a hare reset how to do it clik last line of my sign iv explained the same their but remember to backup ur phone as u will lose all data on ur phone when u do it OK
Chris1507 said:
No, I don´t use 3rdParty Software for the Icons at the Top of the Screen, I use SPB Mobile Shell where I generally don´t see the icons.
I think it´s a bug in the Rom or Radio, it´s the same failure at the Diamond2 and for that Device give it a Bugfix from HTC.
Click to expand...
Click to collapse

you read this at my first POST "at my Jade are the newest official ROM from HTC "2.32.407.2" with radio 41.30.12"
this Rom is not from Pdaviet.
after a full new Official Rom upgrade I´ve made, it is a hard reset normal.

I have the same problem.
At my Jade I use the official ROM from HTC "2.32.401.2" with radio 41.30.12. Anybody know the solution for this problem?

I think the Problem is..... "battdrvr.dll"
if everywhere have a JADE with a earlyer ROM where the charging works, can this "battdrvr.dll" copy and upload here.
this .dll was locate ind the Windows directory.
then we can try to change with the current battdrvr.dll
I´ve see it give a "XDADev_BatFix.CAB" , but this works perfect with the HTC Prophet with the same problem.
hmmmm, I don´t want to try this bugfix, i think this brik eventually the Jade...
It seems that HTC have generally a problem with many Devices with the Powermanagement.

I find if I restart my Jade, battery indicator shows me real battery charging status.

Same here! Restart and all's OK. Running stock firmware, newest update from HTC.

Diamond warranty, Flash Problem!

Hi Guys,
I have a great Problem with my XDA Diamond! Since one month my touchsreen didnt response! At the moment runs olinex 1.40 at the pda. I have flashed the newest o2 rom and that work without a problem! But i cant start my device because the first adjust doesent work.... (touchscreen dosent work). I tryed Hard-SPL Unlocker post 39 that i can send my device back to the O2...
but at the process on the screen of my pc i have 0% for a time than came Error 202: connection....
activesync is ok!
I have tryed to update the olinex but the same problem ...
also with other roms...
I hope anyone of you have a idea because i wanna have my pda back ....
sorry for my bad english!
Thanks a lot!!!
L3xX

If Your touchscreen doesnt response, i think it would be a external problem. Did you drop it?Water spill...Maybe try flashing a new rom like Energy Rom 6.5 with maila 2.5(sense 2.5 UI) I just got my CDMA Diamond this Saturday. Great phone with the Windows Phone 6.5 Rom. Sorry but i tried to help but couldn't. If u have a warranty try to e-mail or contact HTC, maybe they might send you back A HTC HD2! Oh the link for Energy Rom is at PPC GEEKS - http://forum.ppcgeeks.com/showthread.php?t=74084

I had the same problem
There are two different ways I fixed mine
1) Press and hold the power button + volume down + enter button (menu) while holding press the rest with the stylist. continuing to hold the buttons until a white screen comes up allowing you to hard rest the device.
2) If 1) doesn't work try try unlocking your phone again then putting a new rom on it. (this will work as long as your phone will connect to the computer, with two beeps)
well I hope this helps

Hi great thank to you! but this steps i´ve allready done!.
Bevor i can give my device into de warranty i musst flash the normal bootloader!!! in my eyes this Hard-SPL Unlocker
But this dosent work!

[Q] Diamond won't update rom (HardSPL)

Hi all,
I'm sorry if it's the wrong section but i'm new here
My question is:
Why does my Htc Touch diamond (1.93.0.0) not update to HardSPL (SPL-1.40.OliNex)?
It all works works fine, the whole installation, but when it's really busy (the progress bar is showed) In once it goes to 100% in like 1 minute.
My diamond reboot and shows a screen like when you hardreset your phone and start it for the first time, but the rom version still is 1.93.0.0
Thanks in advance!
Solved
Solution:
Just download another Rom Update Utility
Solved my problem