Hi everyone
So I have the battery problem-it`s not charging!
at start it showed all the time that it`s charging-eaven when it was unplugged!
so I searched and disabled the usb charging,through registry.
But then started another problem-it shows that it`s connected to wallcharger and so,and it shows it`s charging,and how full the battery is...BUT!
it`s all fake! it shows 100% but after few mins dies!It only charges and holds the power normaly only when i charge it through differient methods-with just ac adapter(just two wires-my brothers electrician so he knews how to..).
but it`s not the batterys fault-I just bought a new one.
So-what could be the problem,any ideas?
thanks and have a nice day
P.S.
I got it used.its G4
the info,that i found in it was:
ROM version:2.17.7.2 WWE
Radio version:02.07.10
So do you think that rom updeite could fix it?
I'm betting on hardware problem; maybe charging IC's or something but it's easier to just try a Hard-reset or flash a new ROM to see if it goes away. Only problem is battery must be over 50% to complete the upgrading
so which rom could be the best to upgrade to?
First get the battery fully charged somehow,it won't complete the rom flash if its below 50%,then download the official stock rom and flash it.
Hi everyone, i have a little problem with my cingular 8125. I am the second owner, so i might not be able to give every details. However, the problem is this: the first owner had wm5 english and decided to put on wm6 italian, so he tried but the wizard brickked. Now, the phone won't turn on, won't go in the bootlader (camera+ power) and won't charge if plugged in the USB. The battery was dead, i charged her but still nothing happens... the wizard act like dead. what can i do?
Plz Help!
Thx
possible fix
This is an "I think" answer.I had a similar problem .I got a new battery.I charged it fully,then I switched batteries charged using usb and wall plugin charger switching around until it worked and charged and wal laa .fixed.
Know I have two batteries one good and one not great but my wizard rocks
I now have a fuze
Hello,
I have bought a new battery (Cameron Sino, Model No: CS-TP4550HL 2800mAh) for my Kaiser. I plugged in the charging-cable, orange LED turned on and my Kaiser started fromself in ca 5-8 seconds. Then I see the bootlogo, the LED is off now, and a few seconds later the Kaiser reboot. With my old original battery the Kaiser is booting fine. I have tried different radio's ( 1.70.18.02 and 1.71.09.01) and i tried this with wm 6.0 and wm 6.1 but there is the same error. I hope someone can help me....
Im looking to find a 2nd battery for my kaiser too.. But as i know original only 1350mh? I think the 2800 is not original on the market. Maybe is the battery problem..
Yes, it's not an original battery. What kind of battery have you tried? I think so too, that only original batterys are working. Is here anyone who tried a different battery for kaiser?
I have searched the Internet and forums for days and can't find a solution to my problem. I have found a few with the same problem, but no solutions. Please help!
I have a Sprint HTC Touch Diamond 6950SP (DIAM500) running the original ROM. A few months ago and for no apparent reason, it stopped recognizing the battery and stopped accepting a charge. I haven't messed with the phone in any way or attempted to load a new ROM. The Power Status screen simply shows, "Main battery: Unknown". Plugging the phone in with the supplied charger will actually discharge the battery and the circular LED does not come on. I tried several soft and hard resets; then I downloaded and flashed the ROM with the one from the Sprint web site (WM 6.1 Professional 5.2.20764/Build 20764.1.4.3), but nothing seemed to help. I found that I could get the battery to charge by removing the battery (with the phone plugged into the charger) and then putting it back in. When the circular LED flashes twice, I remove the battery and wait till it flashes two more times, and then put the battery back in. This takes many attempts, and eventually the LED continues to flash and will charge the battery. I did this for a long time while I searched for a solution, and one day, it just started working again!!! The phone worked great for several months and suddenly, it has started doing the same thing again.
I decided to upgrade to WM 6.5 and downloaded all the necessary applications, (many thanks to XDA and friends). But, when I attempted to flash my ROM, it stopped and indicated that my battery was too weak - even though I new it had a full charge, (see battery status, above). I've checked the battery with a multimeter, therefore, I know it has a full charge. I don't have any other problems with the phone, nor do I have any problems with it sincing to my computer. I have since ordered a new battery, but it hasn't arrived yet. Someone please help.
Thanks.
I have read at other posts that the Diamond's battery has a recognition chip in it. Also, without the battery, it will not run from the charger. Could the chip in the battery be bad? Has anyone else had this problem?
Is there a registry fix (or tweak) for the battery status? Please, one of you must know something about this.
Got my new battery - the phone does not power up, charge or anything else with the new battery. I tried charging the new battery with the method I've tried before, (see above), but it won't even light the circular LED. I checked the new battery with a multimeter, and it shows it has 3.7 volts. Now what? Any ideas would be appreciated.
that happened to me for a little while. idont know what it was but it wouldnt charge using the usb cable to any computer or even the a/c adapter but it would charge with another wall charger i had. after a couple days a friend had his psp over and i charged my phone with his cable on my computer like nothing and after wards it all worked again
Thank you so much for your reply!!!
[/B]
lokoz89 said:
that happened to me for a little while. idont know what it was but it wouldnt charge using the usb cable to any computer or even the a/c adapter but it would charge with another wall charger i had. after a couple days a friend had his psp over and i charged my phone with his cable on my computer like nothing and after wards it all worked again
Click to expand...
Click to collapse
I have tried other cables and chargers, but none have helped. Last time my phone started working properly, I had plugged it in to my computer, but that hasn't happened this time. Thanx for your comments - keep 'em coming.
I purchased a new charger/docking station for my phone and spare battery. It wouldn't charge my phone or the new battery I purchased either. The new battery still will not work in my phone - paper weight! The charger does charge my old battery, though. Does anyone know if you can run a Touch Diamond from the USB/charging cable without the battery installed? Mine won't, but I was wondering if it should.
Hey man
you know that happend to me when i first flashed my diamond for metro i bought a new battery and nuthing changed so what i did was a hard reset and it fixed it for me but i dont know thats just me and if u want to try it make sure u back up ur contacts with PIM backup hope u fixe it
krzynate said:
you know that happend to me when i first flashed my diamond for metro i bought a new battery and nuthing changed so what i did was a hard reset and it fixed it for me but i dont know thats just me and if u want to try it make sure u back up ur contacts with PIM backup hope u fixe it
Click to expand...
Click to collapse
Thanks, Krzynate! I tried that already, many times now, (see my first post in this thread). Thanks anyway and please keep the posts coming.
I had the same problem.. I ended up buying a new battery and it wouldn't charge in my phone. So I ordered an external charger from EBAY for 10$. My new battery is charging so It might be the solution you are looking for.
Thank you so much for posting! As I wrote previously,
(I purchased a new charger/docking station for my phone and spare battery. It wouldn't charge my phone or the new battery I purchased either. The new battery still will not work in my phone - paper weight! The charger does charge my old battery, though.), this did not fix my problem. The vender that sold me the new (bad) battery is sending me another one - hopefully, it will work this time.
It's Fixed!!!
I wrote the Internet store where I purchased the non-working battery. They sent me another battery and now it's fixed!!! The battery indicator and status all recognize the new battery! Apparently, there is a recognition chip in the battery; the original battery's chip's software became corrupted, and the other "new" battery's chip was blank. The original battery still works, (as long as I charge it with the external charger), and still has an unrecognized status in WM 6.1. Please pass this info on to others that have simular problems. Thanx XDA!
Ive just bought a new battery for my Htc Diamond but the phone wont recognise it or charge it. Has anyone any tweaks or ideas on how to get the phone to recognise the new battery..
It will work on a old 1.37 rom but not on any new rom that Ive flashed the phone with. Its driving me crazy
any help would be brilliant
Thanks
RECHARGE Reply
This might not be the same thing, but I have similar problem on my Diamond. After purchasing the machine, I quickly learned of the poor battery life that is inherent with it and proceeded to purchase some cheapo third party batteries on eBay. These worked for about a month, and now they refuse to charge many times. They'll discharge just fine, but it refuses to respond to the USB cable. It never does this on the stock battery, and I have all but given up on the third party ones.
Hopefully you have better luck than I did.
- 2 Bunny
Battery
I found my D-710 will not work with some Battery s try your old batt. and see if will charge
if it will you have a bad batt