Hi,
My TD2 cannot open. It lock up on boot screen and dont response soft reset or another buttons.
I tried hard reset and its completed successfully but when I push volup button it restart and stop again.
How can I fix this problem or setup a new rom?
Device spec:
WM6.5
4.49.25.91
61.44etc.25.35u
2.53.76952
Sorry my english, I hope you can understand
Related
I am not sure if there is an existing thread here ..
I have just upgrade to the AKU2 ROM on my qtek ... but she is now stuck on the splash screen ...
Active sync doesnt pick up there is a device attached now so i cant run the update again ...
I have been trying to hard reset ... Comm + voice tag button and reset .. but it doesnt seem to work ...
Any ideas ???
Can anyone help me ???
have you tried holding the camera button and pressing the reset button in, this should make device go to awaiting flash status?
Hi,
I have a big problem, today I connected my Diamond to my PC, when activesynch was connected, my Diamond has rebooted automaticly. After rebooting, my Diamond is locked automaticly and I can't unlock it. I have tried to unlock normaly (push, with the stylet, the button unlock) but nothing happens ! The TouchFlow don't work, I can't push the button !
I tried to reboot several times but for to reboot I can't push the power button because it is locked. I need to remove the battery and after my diamond reboot and it relock again.
I tried to HARD RESET (Volume Down and Enter button press + reset) but it's the same because these buttons are locked, it reboot same as soft reset.
My diamond has the ROM 1.37 UK and I have modified the configurations by the post "List of diamond tweaks" (with automatic locking and other performance configuration).
I just want to enter in my diamond but I can't flash again the ROM because it don't want to connect with activsynch because it is not started completly. It lock just when I have the screen "Windows mobile" in green.
Please Help me :-(
Take the battery out
Please read my post -->
"I tried to reboot several times but for to reboot I can't push the power button because it is locked. I need to remove the battery and after my diamond reboot and it relock again."
I know, I can reboot if I Take the battery out but after my Diamond is always locked.
Sounds like the phone is fubar'd...best to send it back seeing as you have tried most of the methods to get it sorted out.
wouldnt waste anymore time on it, id get it sent back to where you bought it from and get them to replace it or send it to HTC and get them to fix it.
Ok, I hope never have the same problem in the futur
Remote registry editing
If you can have the activesync connection working on your diamond, you could try to reset back the autolock feature by using a remote registry editor and the reboot your diamond.
You have to change back the following value:
HKEY_CURRENT_USER\ControlPanel\BackLight\AutoDevic eLockEnable to 0
Hi All!!!
I disabled MUI in hklm\mui\available to switch from russian to english and diamond no longe boot windows.
Hard reset doesn't help - device shows "cannot boot device becase of ..." message and prompts for SEND to hard reset but this does not help.
Please any advice!!!
Regards,
----
Alex
Volume down + Center circle + Soft reset = Hard reset
Hi
my Charmer freezes during the Bootprocedure (IPL SPL GSM OS is showing)
I tried to upgrade to Charmer WM 6.1 by ChrBeck but when the os file is written the connection cuts :-(
what should I do ??
Anywhen I used a safe mode but i don't know how to get there.
Does someone know how ???
Thanks for help
OK i figured i out just press the Camera Button after you pressed the reset button
I installed a Rom ( 23,506 Rom Calkulin's Diamond ROM v4.2 ) and phone froze .... click on the Power button on and remain frozen and the display shows the Touch Diamond and not wake-up is frozen .Hellp me pleaseeee !!!
Sounds like you had a bad flash.
Have you tried removing battery, reinserting it, holding down "VOLUMEDOWN" key, and pressing power? You would enter into a tricolor screen. Try flashing a different ROM from there.
If that doesn't work, try flashing the official ROM for your device from HTC's website.
~codeslicer
use mtty....it solves all the problem
you can find it here http://forum.xda-developers.com/showthread.php?t=540290