[Q] Notebook shut down during update - HD7 Q&A, Help & Troubleshooting

while update my phone my notebook shut down and when I turn on my phone is frozen on the screen of HTC and nothing else. I have sent for assistance but as windows phone arrived in Brazil a little time they do not know what might be happening. The HTC Brazil wants to send my phone to the U.S. but if anyone knows what can be done to reinstall windows phone on my HD7 would be grateful.
Have downloaded several ROMS but all had ERROR 266 and that was the only error that is not found because it is happening.

have you tried flashing a new stock Shipped ROM onto your device?

Put the phone in Update/Recovery mode (turn it off, press and hold the Camera button, turn it on again, keep holding the Camera button until it goes to the black-and-white screen indicating that you should connect the phone to the PC). Connect your phone to the PC using the normal USB cable. Start the Zune software. After a few seconds, Zune should offer to restore your phone to the backup that was created prior to beginning to flash the update.
That will make the phone boot again, without losing any data. Afterward, you can try updating again. Hope that helps, good luck!

GoodDayToDie said:
Put the phone in Update/Recovery mode (turn it off, press and hold the Camera button, turn it on again, keep holding the Camera button until it goes to the black-and-white screen indicating that you should connect the phone to the PC). Connect your phone to the PC using the normal USB cable. Start the Zune software. After a few seconds, Zune should offer to restore your phone to the backup that was created prior to beginning to flash the update.
That will make the phone boot again, without losing any data. Afterward, you can try updating again. Hope that helps, good luck!
Click to expand...
Click to collapse
what if there is no backup???

Related

Phone Trouble

I tried to install one the OTP i think v7.7 to my phone and it accidently disconnected. Is said repair so i did all that but now everytime i turn my phone on it say Open touch project and then it freezes. Is there anyway I can fix this??
anyone??????
It also allows me to do the Hard Reset but it still goes back to the open touch project and freezes
Does the phone connects to ActiveSync via USB before freezing and/or does it remains connected after freezing?
you can put your phone into bootloader mode (hold camera button first then power on the phone while keeping the camera button pressed) once you are in bootloader mode, you can start the RUU again

Please Help! Phone is bricked?

I just woke up to a nightmare. I reached over for my phone and i found it dead unplugged from the charger. I thought to myself... "Alright, let's begin charging it... I probably forgot to put it on the charger last night"
I plugged the phone into the charger and the phone powers on...
After it boots, i it prompts me to connect the phone to my computer... Strange...
I plug in the phone to my computer and Zune pops up with c101002e error code.
Now i did some research and it looked like my phone somehow got bricked... so i found the following link and sure enough, my error code is on the list of known troubles.
The Windows Phone Support Tool is not working on my phone, After following the steps i get the attached screenshot error.
My next step is to reflash... however. Following These instructions, I cant seem to get my phone to boot into the tricolor bootloader screen!
PLEASE HELP! Any input would be greatly appreciated!
You say "After it boots, i it prompts me..." is windows booting before the error pops up?
The phone is off... i plug the charger in, and it boots as in it turns on. Once it turns on, windows does not load. instead it's telling me to connect to computer. I connect to computer and the error appears
already tried an hard reset??
Not able to perform a hard reset... I hold down both volume bottons while the phone is off and press the power/lock button to power it on. while holding on the volume buttons... the phone just goes to the connect to computer screen.
Try taking out the battery. Leave it out for a short while then replace it & check its securely in place. Reboot & see what happens. The phone shouldn't brick when charging or sleeping. Good luck!
Sent from my HD7 using XDA Windows Phone 7 App
Might try this and see if it helps
http://answers.microsoft.com/en-us/winphone/forum/wp7-sync/windows-phone-7-error-code-c101002e/2e7cd10e-4123-46ea-844b-e3aed54eb6bd
may be the camera key is pressed down by the case and stopping it from booting
I do not have a case with the phone but i always did have a problem with that camera buttom... it does seem to be kinda pushed in... I hate this...
what is ur version???
just u can jailbreak the 7004 or 7008 by chevron...

Xperia Z 6603 - Auto Repair Triangle Boot Loop after .244 Update

Hi All,
I have an Xperia Z C6603 UK Unbranded phone and have just updated to the 244 update (direct from 434) using the PC Companion software. Phone is not rooted.
Did the update - all seemed OK, running android 4.2.2 no problems. Then had notification to update Sony apps (Walkman, Album, etc) so I started the process of updating the apps as usual. Then the problems started:
apps were frozen at "installing". System worked fine. Left it for 10 minutes, no progress.
Decided to restart the phone
Phone did not reboot as normal but went into "auto repair" mode with the settings triangle and a status bar at the bottom (+ red LED when plugged in)
The status bar never progressed, it just stayed continuously "moving" as if initialising
Was only able to REBOOT phone off by holding Vol+ and the POWER button. I could never turn it off, it would only reboot to the same state.
PC companion software did not recognise the phone was connected to PC regardless of the various options I tried.
Downloaded the Sony Update Service application and installed on PC
Finally managed to get the phone connected to the PC by doing the following:
-hold down Vol+ and Power till phone goes off
-keep holding Vol+ and Power until phone vibrates once
-keep holding Vol+ and Power until phone vibrates 3 times
-let go and then immediately plug in USB cable (while SUS is running on PC) and simultaneously hold the Vol- button down.
-SUS recognised the phone. Unfortunately the only option I had was to factory reset and lose all data.
Anyway I how have my phone back but it was factory reset. Never mind all my stuff is online anyway so that's not a biggie.
Thought I'd put this out there in case anyone else runs into this problem.
For what its worth I think the 244 update is a huge improvement on the 434 firmware. Better screen visibility and colours and seems a little faster (but that could be the reset). Dont know about the battery life but glad its back.
Cheers.
If you happen to see the repair triangle thing again leave it to do its thing.
It can take a while for it to complete as it's optimising/repairing system files. Just be patient
Drummerjed said:
If you happen to see the repair triangle thing again leave it to do its thing.
It can take a while for it to complete as it's optimising/repairing system files. Just be patient
Click to expand...
Click to collapse
Thanks for the tip . I did wonder if I should leave it but it was unchanged for over two hours so I thought it was properly stuck.
Battery life seems to be pretty good as well so far.
There has beena few incidents where it took people over 24 hours for it to complete.
Just leave it be, and you can keep all your data
Sent from my C6603 using xda premium

Finally killed my Z1

Any ideas how to fix this?
It started with the phone died by itself and wouldn't turn back on at all except it can go to Sony logo when I'm charging the phone.
First thing to do was to hard rest by pressing the orange clip (didn't work) then tried pressing power + vol up button (didn't work).
Second thing was to install via flashtool. Installation was successfully done but I can't turn the bloody thing on (battery is about 60%).
Any idea? I think I just killed it.
Another issue is that the phone is always stuck in fastboot mode when connected via usb.
3r1k said:
Any ideas how to fix this?
It started with the phone died by itself and wouldn't turn back on at all except it can go to Sony logo when I'm charging the phone.
First thing to do was to hard rest by pressing the orange clip (didn't work) then tried pressing power + vol up button (didn't work).
Second thing was to install via flashtool. Installation was successfully done but I can't turn the bloody thing on (battery is about 60%).
Any idea? I think I just killed it.
Another issue is that the phone is always stuck in fastboot mode when connected via usb.
Click to expand...
Click to collapse
Any water damage? Been in water?
Clean USB port with cocktail stick or q tip with alcohol. Try again.
Not bricked. Kernel is booting if Sony logo comes up. It is something else...
EDIT: Hold power and vol up together to hard reboot the phone
hI
to rise your phone again use Sony's PC Companion-support. Follow the instructions of the application. I had the same ptob.
Thank you

OnePlus 3t; Stuck in a endless cycle of restarting

**PHONE SPECS**
OnePlus 3t~ ver. 8.0, storage is only half full, no water damage or any damage of any kind
Like the title says, my phone is just restarting over and over again. This happening out of no where yesterday. I simply put my phone to charge and when I came back it was like someone is holding down the power button.
What I have tried so far is get to screen with the Chinese letters,^sorry ^I ^don't ^know ^what ^this ^screen ^is ^called .^All ^I ^know ^is ^that ^you ^hold ^volume ^down, so I can factory reset it but, the phone quickly restarts so I was not able to.
I also tried using a oneplus3t unbrick program I found while searching for possible answers but that program was unable to work on my computer. Hopefully someone can help with that
The good news is that I was able to back up my phone so I have no problem resetting it.
All help is welcome; Thank you!
If you hold the power button for a long time does it shut off and stay off? If so. That is the time try and enter recovery. While it's restarting it will be difficult. Try with the phone off. If you can get to recovery you should be able to either restore to your backup or flash a diff build. I would also download the latest stable build to your PC first. If you can get to recovery and connect your phone to the pc and have it recognized by the pc, you should be good.
Sent from my ONEPLUS A5000 using Tapatalk
killerskincanoe said:
If you hold the power button for a long time does it shut off and stay off? If so. That is the time try and enter recovery. While it's restarting it will be difficult. Try with the phone off. If you can get to recovery you should be able to either restore to your backup or flash a diff build. I would also download the latest stable build to your PC first. If you can get to recovery and connect your phone to the pc and have it recognized by the pc, you should be good.
Sent from my ONEPLUS A5000 using Tapatalk
Click to expand...
Click to collapse
Sorry for the late reply, I was in class
When i hold the power button it does not turn off it just continues to restart. The only way it "turns off" is when I plug it in to a power source or my computer. But it will turn on and do a bootloop at random intervals and at random times. When it is plugged in my computer, I can not find it in the device manager. And when it appears, it quickly disappears.
Speaking of downloading a build onto my computer, how would I go to do that? Is there a detailed tutorial I can follow.
Can you get into fastboot (power & volume up)?
If you can you could clear the cache via command line to see if something in there is the culprit.
Update
Out of frustration of nothing working, I left my phone to die for 3 days straight( i didn't touch or move it) and on the 3rd day I charged it. And it works now!! Idk if it was hardware or software but it works and I hope it continues do so.
Just as a note this phone as no water damage and very minimal physical damage so I have no idea what happened. Thanks to everyone who pitched in ideas

Categories

Resources