Database Develop

[Q] i9000 Completly dead?

So I tried updating to the newest Cyanogenmod Beta1 when it failed to boot repeatedly I went to reflash via Odin using stock JM9 with repartition 803.pit. This is what I got on Odin:
<ID:0/004> Odin v.3 engine (ID:4)..
<ID:0/004> File analysis..
<ID:0/004> SetupConnection..
<ID:0/004> Initialzation..
<ID:0/004> Set PIT file..
<ID:0/004> DO NOT TURN OFF TARGET!!
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> modem.bin
<ID:0/004> modem.bin
<ID:0/004> Removed!!
<ID:0/004> Completed..
<OSM> All threads completed. (succeed 1 / failed 0)
I had selected the modem and rom file that came with the samfirmware.com package.
Now phone will not even turn on, react to button presses, or show that it is charging while plugged in.. Tried taking out battery and putting it back in a few times with no luck.
This is an international version of the phone. Am I screwed? Could the battery have died while flashing or could the bootloader have been messed with?
I am panicing

Did you find a solution?
I have run into the identical issue and was wondering what your solution was?
I flashed the Vibrant firmware by accident onto my GT-i9000m and now the phone is dead, no boot screen, no logo, no reaction to any button combo.
I previously used the usb jig to get into the download mode, and when I reflashed a known to be good rom back on the phone I checked off "update bootloader" assuming the bootloader was at fault. Big mistake.
I've ordered a replacement phone from Bell, but if you have any info it would be greatly appreciated.
Thank you in advance.

[Q] Installing Froyo via Odin

I'm having a bit of trouble flashing froyo with Odin (it sucks that neither Samsung nor AT&T will just release an official build). My phone is rooted, and I have installed the proper Samsung and USB drivers. I run Odin as administrator and connect my phone via USB, putting it in download mode. When I hit "start" Odin gives me a bit of progress, but the phone simply sits there. I've tried multiple times and have had it sitting here for close to 30 minutes, stuck on the downloading screen. Any suggestions?
Here is all I get from Odin:
<ID:0/004> Added!!
<ID:0/004> Odin v.3 engine (ID:4)..
<ID:0/004> File analysis..
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> Completed..
<OSM> All threads completed. (succeed 1 / failed 0)

sammusashi said:
I'm having a bit of trouble flashing froyo with Odin (it sucks that neither Samsung nor AT&T will just release an official build). My phone is rooted, and I have installed the proper Samsung and USB drivers. I run Odin as administrator and connect my phone via USB, putting it in download mode. When I hit "start" Odin gives me a bit of progress, but the phone simply sits there. I've tried multiple times and have had it sitting here for close to 30 minutes, stuck on the downloading screen. Any suggestions?
Here is all I get from Odin:
<ID:0/004> Added!!
<ID:0/004> Odin v.3 engine (ID:4)..
<ID:0/004> File analysis..
<ID:0/004> Get PIT for mapping..
<ID:0/004> Firmware update start..
<ID:0/004> Completed..
<OSM> All threads completed. (succeed 1 / failed 0)
Click to expand...
Click to collapse
Don't waste your time with this, come see us over at Phoenix.
http://forum.xda-developers.com/showthread.php?t=892973
Click the link in my signature to see more.

GT-I9305 - I can't flash any stock samsung roms

Hay gays.
I buy samsung galaxy s3 lte but phone stuck in bootlop (can't go to download mode and recovery mode) well i buy JIG and work but now i
can't flash any stock samsung rom
odin shows me :
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/005> Odin v.3 engine (ID:157)..
<ID:0/005> File analysis..
<ID:0/005> SetupConnection..
<ID:0/005> Initialzation..
<ID:0/005> Get PIT for mapping..
<ID:0/005> Firmware update start..
<ID:0/005> SingleDowanload.
<ID:0/005> boot.bin
<ID:0/005> NAND Write Start!!
<ID:0/005> FAIL
<ID:0/005>
<ID:0/005> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
What does this mean ?

Ask a moderator to move your post to the q&a section for the i9305 for an answer.

pleps123 said:
Hay gays.
I buy samsung galaxy s3 lte and phone stuck in bootlop (can't go to download mode and recovery mode) well i buy JIG and work but now i
can't flash any stock samsung rom
odin shows me :
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/005> Odin v.3 engine (ID:157)..
<ID:0/005> File analysis..
<ID:0/005> SetupConnection..
<ID:0/005> Initialzation..
<ID:0/005> Get PIT for mapping..
<ID:0/005> Firmware update start..
<ID:0/005> SingleDowanload.
<ID:0/005> boot.bin
<ID:0/005> NAND Write Start!!
<ID:0/005> FAIL
<ID:0/005>
<ID:0/005> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
What does this mean ?
Click to expand...
Click to collapse
what are the roms that you tried to install with odin?
what is the installed rom in your device?

"what are the roms that you tried to install with odin?"
I tried flash stock 4.4.4 xeo ,4.3,4.1.2 for GT-I9305
"what is the installed rom in your device?"
I do not know , but probably stock 4.4.4 because from what I see in download mode ,I have knox bootloader.

Try pit file with 4.4.4 stock Ron.

Unfortunately it did not help

Try with mobile Odin pro

I tried using Heimdall but program shows me this error :
Failed to access device. libusb error: -12

pleps123 said:
I tried using Heimdall but program shows me this error :
Failed to access device. libusb error: -12
Click to expand...
Click to collapse
If you have Knox Bootloader you can not go down to 4.1.2 Jellybean.
Choose a Sammy based original Firmware 4.3 or 4.4.
Can you got to Recovery Mode?

I had your same problem
Try to install PHILZZ recovery with odin
then go to mount and storage
select mount usb storage (you must have an sd card inside phone)
connect to your computer
put sammy rom or similar (it take some time) try not to touch usb cable
when finished flash rom!!!!!!!!

[Q] Root Problem

Hello.
I do not know if the title is good. I will explain here what happened.
my Galaxy S was android 2.3.4 jvq. I wanted to intall a newer one, a android 4.4.x
I followed a thread about how to do that.
I tryed to root the phone uing Odin and cf-root, but it failed it. After that when i powered on the phone i get some error with phone to computer and a yellow triangle in the middle.
I founded a program on internet to "unbrick" that, but now i can only enter in download mode using the 3 buttons, and dont start in normal or recovery mode.
I tryed to flah it again uing odin with cf-root but failed every time.
the odin log says this :
<ID:0/005> Get PIT for mapping..
<ID:0/005> Firmware update start..
<ID:0/005> zImage
<ID:0/005> NAND Write Start!!
<ID:0/005>
<ID:0/005> Complete(Write) operation failed.
<ID:0/005> Added!!
<OSM> All threads completed. (succeed 0 / failed 1)
Do you know any solution to my problem?
Thx.

maybe this will help
GabrielAK89 said:
Hello.
I do not know if the title is good. I will explain here what happened.
my Galaxy S was android 2.3.4 jvq. I wanted to intall a newer one, a android 4.4.x
I followed a thread about how to do that.
I tryed to root the phone uing Odin and cf-root, but it failed it. After that when i powered on the phone i get some error with phone to computer and a yellow triangle in the middle.
I founded a program on internet to "unbrick" that, but now i can only enter in download mode using the 3 buttons, and dont start in normal or recovery mode.
I tryed to flah it again uing odin with cf-root but failed every time.
the odin log says this :
<ID:0/005> Get PIT for mapping..
<ID:0/005> Firmware update start..
<ID:0/005> zImage
<ID:0/005> NAND Write Start!!
<ID:0/005>
<ID:0/005> Complete(Write) operation failed.
<ID:0/005> Added!!
<OSM> All threads completed. (succeed 0 / failed 1)
Do you know any solution to my problem?
Thx.
Click to expand...
Click to collapse
Hi
did you already try to get back to 100% stock ROM??
-
-
i can not yet post links but if you google "galaxy s stock rom" and than the first link.

take a look here for the stock ROMS
http://www.sammobile.com/firmwares/database/GT-I9000/

it warked with another version...strange thow.
Thx.
I will try now to put again the 4.4.x

Bricked Galaxy S5 (mmc_read failed)

Hello,
I purchased a Galaxy S5 SM G900A (AT&T) whose previous owner supposedly only wanted to upgrade it to Android 5.0 and then stopped working. According to him, the phone was working properly before trying to upgrade it.
I have tried almost I have found and searched here and other sites, but it seems that anything is working. I think the phone is dead.
As a last resource, I have ordered a JIG, and should have it early next week. Do you think this can help?
Please see attached images for your reference, and would appreciate if someone can help me to confirm if this can be solved or not.
Odin Log (With Repartition Enable)
Code:
<ID:0/005> Odin engine v(ID:3.1100)..
<ID:0/005> File analysis..
<ID:0/005> SetupConnection..
<ID:0/005> Initialzation..
<ID:0/005> Set PIT file..
<ID:0/005> DO NOT TURN OFF TARGET!!
<ID:0/005> FAIL!
<ID:0/005>
<ID:0/005> Re-Partition operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
<ID:0/005> Removed!!
Odin Log (Without Repartition Enable)
Code:
<ID:0/005> Odin engine v(ID:3.1100)..
<ID:0/005> File analysis..
<ID:0/005> SetupConnection..
<ID:0/005> Initialzation..
<ID:0/005> Get PIT for mapping..
<ID:0/005>
<ID:0/005> There is no PIT partition.
<OSM> All threads completed. (succeed 0 / failed 1)
Thank you in advance.

Anyone?

Yep
There's a type of .tar do you need to flash on Odin.. I did the same damn thing that you did ..you could talk to the Samsung and see if they'll replace it since it is a hardware feature .. I'll see if I can find something to help you out ..because I've been looking at this place for like 2 weeks now

Shadowdemized said:
There's a type of .tar do you need to flash on Odin.. I did the same damn thing that you did ..you could talk to the Samsung and see if they'll replace it since it is a hardware feature .. I'll see if I can find something to help you out ..because I've been looking at this place for like 2 weeks now
Click to expand...
Click to collapse
Any help you can provide will be greatly appreciated.
Best regards.

Yep
http://forum.xda-developers.com/att-galaxy-s5/help/tried-downgrading-5-0-to-4-4-2-bricked-t3093826

Do you mean the stock partition thing?
Because I already try to flash that file but still getting the same error.

Yep
On no bull**** lie ur ass off to samsung .. sorry, but thts all i know for now ... or if u got some dough buy a tmobile s5 off ebay and sim unlock it. that's what I heard people been doing these days