Guys, I need help. Where can I order battery for asus tf701? In Internet I did not find original battery for our model. Maybe there is some alterantiv other producer?. In the service center said that they havent it on a storage and do not know when there will be . (the device isnt guarantee)
Related
Hello,
I recently just got my first PPC, the Qtek 2020i (HTC Alpine). I was under the impression that this model has a GPS receiver built-in. Is this true? I have managed to get the GPRS connection working and can browse the internet with it but I am having difficulty getting the GPS side of things working. Can anyone tell me how to get it up and running. I need to know what com port and baud speed the GPS receiver uses. Any advice or help would be greatly appreciated, so thanks in advance.
Stephane
Hi, the IIi has no internal GPS. You would have to use an external or Bluetooth GPS reciever for that .
Thanks, I was suspecting that would be the case. I am looking at getting this one from ebay for quickness.
I also notice you have different rom details from my one. Is that something I should be updating? I am completely new to this PPC and franticly hunting about to get up to speed. Where can I get rom updates and other essential stuff for this HTC Alpine pda?
EDIT: I am reading this thread about Deathnoise's ROM. I am downloading it now and will attempt to install it.
EDIT2: I have also noticed my battery runs out pretty quick. It's a 2000mAh. I've seen 2400mAh on ebay, has anyone had the same issue and found a better battery or is this something I will just have to get used to?
EDIT3: Found a 3600mAh battery on ebay here, think I will be going for this one. It comes with a replacement back cover cause the battery is bigger.
Updated my rom with no problems and ordered my gps receiver and a new battery. Thanks again for confirming this for me.
Hi mate! i have this PPC since 2005, but now starting to use it a bit.
Whenever you have GPS installed and working, tell me, cause i'd like to have it also.
Thx
i installed a wm6 rom in my phone and reset it.but may phon no turn on.an no conect with active sync and no conect with adaptor.
on of my friend say to me that my k-jam flash is damaged and in my country cant service it.
and say to me that i want your forum for solve this problem.
olease help me...............
?????????????????????????????????????????????????????????????
You may be flashing a G3 ROM to a G4 device. If you device can't even charge, then it is the case. It is a brick and not repairable by your own.
You could try buying a device from eBay with a broken LCD and using it's motherboard in your phone. All the Wizard models have the same motherboard. This is what I had to do when I bricked mine!
i need for JTAG
my device ic-flash is full out, and i must JTAG my device.
please help me about JTAG process and describ JTAG with pictures for me.
thank all
JTAG is still not achievable,its not possible yet.many have tried to do it.
Take my advice,sell it for parts and get a new device.
Mods ,plz close this thread.
Double post,deleted
Best way is to buy an broken LCD wizard from ebay or anyother site and then replace its LCD with your Wizards LCD, but try buying a G3 Wizard becoz its "Easy to Cook and Easy to Eat".
Hello,
My touch screen was dead, so i sent my phone to HTC french warehouse...
I received it back yesterday, but now to got wifi ntwork, i ve to be at less than 1 metter from the access point.
I think that people who repaired my phone forget to plug something like the antenna cable ???
Does anybody know how is in the phone ?
Is there somewhere on the web, a page that explain us, how to open diamond without breack it ?
THank you
Emmanuel
2 months ago I disassembled my diamond trying to reach the digitizer / touch panel (eventually I failed to replace it) and when I assembled it back I too lost the wifi signal and I had to be very close to the access point. I re opened it it I found that the wifi antenna was unplugged so I plug it again and wifi is fixed.
Check the service manual here http://www.mediafire.com/?jnh4f2ndyzz
ammar said:
2 months ago I disassembled my diamond trying to reach the digitizer / touch panel (eventually I failed to replace it) and when I assembled it back I too lost the wifi signal and I had to be very close to the access point. I re opened it it I found that the wifi antenna was unplugged so I plug it again and wifi is fixed.
Check the service manual here http://www.mediafire.com/?jnh4f2ndyzz
Click to expand...
Click to collapse
You are a god...
I m not going to tell you that you save my life, but with this documentation is opened my diamond, the antenna was not plugged (****ing french technicien who don't read this kind of documentation)...
So i must not send it back for one week to htc french warehouse...
You remenber me how internet is magical...
Thank you
every diamond user should download this documentation, it could be useless
Emmanuel
Glad i could help
thanks ammar
My phone won't switch on (battery indicator is OK when charging).
Is there any way to retrieve/erase the data from the internal storage so I can transfer it to a new phone / sell it for spares on eBay without the risk of someone repairing and then accessing my personal data ? Thanks
Same problem, need the same answer.
Somebody has a solution?
Hi, I'm trying to repair one Z3C phone, one component is missing (rip-off, chipsize 0201, probably resistor) and probably reason why TS is not working.
Is there anybody that maybe have some damaged non working motherboard for selling, it would help a lot.
Or if anybody have open device, if there is a possibility to measure this component on board (it is probably resistor)?
Images on link below
https://www.dropbox.com/sh/9a6i07y1j9clu66/AABKTK90U8pgIrLYYiKxiuQca?dl=0