[SOLVED] I Dun Goofed Can't Odin stock files - AT&T Galaxy Note 3 Q&A, Help & Troubleshooting

So Iwas using a custom ROM on STOCK slot and was about to install a different ROM.
In TWRP, I chose advanced wipe and typed "yes"
wipe started and phone instantly rebooted............
Cannot boot into anything excepy download and stock android recovery.
I tried re-partitioning and flashing stock phone files and odin fails every time.
Phone says sw rev check fails fused1 > binary2
any suggestions?
EDIT: found an all in one odin file and it seems to be flashing fine, will update OP when finished
EDIT 2: that worked.

Related

Help me please

I tried to flash a stock rom but it was on bootloop.
So i went to odin on my pc and selected stock rom for PDA and clicked on start.
Now when i turn my phone on it says:
Firmware upgrade encountered an issue. Please select recovery mode in Kies and try again
Retry the odin flashing of the same stock rom. Next time if you get bootloops then go to recovery and just clear the cache and then reboot.
Make sure your downloaded zip is not corrupted.

[Q] Flashing stock rom using odin

Hello,
I will start with saying that Ive already checked every tutorial in every android website.
here is what I did.
I had Miui (Not the ICS one) I have tried to flash CM9 with the existing recovery. than something somewhere on the flash procedure go wrong and the phone just rebooted and putted in loop with no recovery option but download option. so I tried to flash the stock rom using odin 1.85, and the phone just looping on the image of the mobile operator. I did this procedure with the odin for more stock roms I found.
thanks in advance really I need your help...
http://www.theandroidsoul.com/xxjvu/
maybe you forget ‘Re-Partition’checkbox, it's important.
Hmmm.. perhaps, you have to make sure all the files are properly placed (depending on the ROM you are installing). Also, I'd recommend using a pit file (and don't forget to click on "Re-Partition".. So far, it worked for me. ^.~

Installed TWRP/Philz but nothing changes. Still Stock recovery

N920C with AOK7 Firmware...
When I try to flash any recoveries using ODIN v3.10.6 either v3.10.7, It says that it passed, but when I reboot into recovery (VolUp+Home+Power) it's still Stock Recovery.
If you Odin flashed the recovery .tar, and rebooted normally, indeed there is something wrong. In a normal process, the phone won't reboot until you flash a custom kernel.
So, do the usual -- redownload the Odin .tar file, re-read the instructions, check your USB cable/port/connection.
All computers, all cables.
Also, what should I do again?

Bricked or not?

Hi everybody
Im new here and to flahing new Roms and stuff.
i believe my phone is bricked and im struggling to get it opperational. Here is what happened...
I have a GT-N7000 on 4. 1. 2 Jelly Bean, which i rooted and flashed to custom ROM CynoganenMod 12 on 5. 0 Lollipop. All was going fine, i rooted my phone, installation went accordingly. After a week or so whithout any problems, my phone started to freez, slag and hang which it never did before, so i decided to flash it back on 4. 1. 2 Jelly Bean I did all as is step by step on Odin 3.-v1.8. When my booted, it booted into System Recovery...
reboot system now (I did)
apply update from ADB
apply update from external storage (I did)
wipe data/factory reset
wipe cache partion
apply update from cache
-----------------------------------------------
# MANUAL MODE #
-- Applying Multi-CSC. . .
E : All failed to mount and open in red ( Invalid argument )
Nothing seems to work, so when i pull out the battery but it back and press "Volume down, Menu and Power button it takes me to the screen with the Warning and yellow triangle where i can install a custom ROM...
Volume up : Continue
Volume down : Cancel ( restart ) (I did)
When i Volume up it takes me to...
ODIN MODE
CUSTOM BINARY DOWNLOAD : NO
CURRANT BINARY : SAMSUNG OFFICIAL
My problem is i have no clue what my PDA nor my CSC code is. Im from South Africa and not sure either which of these are correct.... XFV, XFC, XFM, XFA (im not network locked) so i dont know which firmware to flash with Odin to make my phone opperational again? Any help please guys.
Johan
Download Philz kernel in tar.md5 format and flash using Odin... Then try to boot into recovery. You should see cwm. Factory reset and flash a stock rom again.
nokiamodeln91 said:
Download Philz kernel in tar.md5 format and flash using Odin... Then try to boot into recovery. You should see cwm. Factory reset and flash a stock rom again.
Click to expand...
Click to collapse
I have tried Phillz and did as you suggested. Im confident that i dont have the correct firmware. I downloaded this from Sammobile : N7000XXLSZ_N7000OJVLSB_N7000LSO_HOME.tar.md5.
Not sure how to go about this....
Doesn't matter what firmware you had.. Once you do a factory reset you can flash any rom made for the n7000
Were you able to get into Philz cwm recovery after you flashed the kernel?
Hi there.
I am happy to report that my phone is back to its original state. Phew, that wat too close for comfort.
I figured that it was obivously bricked or something close to it.
The problem was that i repartitioned it with the wrong PIT file and wrong kernel. Why i did that, i dont know? So i found firmware i thought would be the correct one! In its bricked state i copied the file superuser to my external, so can unzipit in CWM recovery. I download a file flashprogram Samsung N7000 +Pit. I then unzipped it and found the .Pit file which i flashed onOdin3 v1.85 at the same time with the firmware, have it repartitioned, and install the firmware.
It passed with success. Go Green!!! )
It booted to Philz recovery and installed the zip file superuser, took your advice then rebooted.
My phone switched on but a page came up where i had to give a password decrypting the device storage. Freaked out repeated the same prosesswith Odin and it started up normaly and suprised to see it restored to its original state* *smile*
*Just be carefull not to go flash the wrong stuff on your phone if your not sure what you are doing ( like i did! )*
I took your advice to heart and want to thank you for your expertieze. I learned alot from my phone the past 3days.
Regards.Johan

Cannot instal STOCK ROM after instlling CM12/13

Hi!
I have installed TWRP and CM13 on my S5 mini (G800F), but i got many bugs and restarts, so i decided to go back to Stock ROM, unfortunatelly i cannot do this.
When i open Odin and try to install STOCK Rom from samsungmobile everything is good, till the and, when i got:
Write finished (filed)
<OSM> All threads completed. (succeed 0 / failed 1)
I tried on laptop and deskop using various USB port but everytime i get the same message.
And when i get the battery out and power on i get:
"firmware upgrade enountered an issue. Please select recoery mode in Kies and try again"
I tried to connet it with Kies in recovery odin mode but Kies does not recogenize it.
Then i need my phone so i decided to move back to CM this time i have installed the CM12, after using it, one day and having many restarst i tried one more to move to STOCK ROM. I downloaded the older verios of STOCK ROM then i had before. But i got the same messege.
Then someone tell mi to make full wipe, so using TWRP i done the full wipe, cache, data, system and internal storage/sd.
After wipeing internal storage i get only:
"firmware upgrade enountered an issue. Please select recoery mode in Kies and try again"
and cannot even install recovery via Odin any more, beacouse i get bugs ;/ ;/ ;/
as a result i cannot even use my phone with CM12/13.
1. Do You have any tips or solution of this problem?
2. How can I instal STOCK ROM or even CM?
3. Can I install the CM via Odin?
4. Do You have any other recovery for S5 mini G800F?
He there, sorry to hear you're having troubles with the phone. I experienced a similar problem and found that this worked:
Try and flash your stock firmware, when it fails, take out battery, put it back in and restart into recovery mode (stock recovery). From there, do a factory reset and wipe (not using Team Win Recovery Project, using the stock Recovery).
Now go back to odin and try flashing again.
Hope this helps...it worked for me.
Do this when error occurs after flashing stock firmware!
1. Flash stock firmware
2. Get error message
3. Remove battery and start in Recovery Mode
4. Flash hidden.img that you can extract of the stock file!
Quote from reddit.com:
If you've tried to flash firmware off of Sammobile, and had your heart stop when the flash fails, fear no longer.
To fix the soft brick:
Open the firmware file in winrar and extract the hidden.img. Rename it as hidden.img.tar.
Load the new file into the PDA tab, and flash.
When the phone boots, the displayed image will be touchwiz teal, there will be a little android and GALAXY spelt above it. Don't freak out.
Give it a minute and it should boot.
Hi, jest i did happend after flashing a stock firmware, but fortunatelly now it work.
How do i manage to fix it? I do not know. I just tried to flash it with a stock firmware one more time, and than tried to flash TWRP recovery via Odin. It get a fail. But the phone got power on, and it works till now !!!!
What was the problem? I have read that if you have the other CSC than XEO and want to flash the ROM with XEO CSC on S5 mini this problem occurs on many phone. Espesially on that from UK, so mine was.
thanks!!
Kuba

Categories

Resources