Hello,
I just tried flashing the novafusion cyanogenmod onto my S3 mini.
The result was that Odin said "failed" thereafter the phone does not to anything.
I cannot get into recovery-mode and I cannot get into download mode.
The only thing that does happen is that when I reconnect the phone to the laptop running odin it starts vibrating in regular intervals an the screen goes off an on again, while it is on (for about a second or so) it tells me that the firmwareupdate failed an that I should boot into recovery, which is not possible.
Any help is appreciated.
Usb jig
Buy usb jig , when you plugged it on your s3 mini you will see download mode .
Related
Hi.
I have installed Cyanogen in my Galaxy S and i flashed back to froyo 2.2.1 . When Odin restarts the phone it hangs on black sreen before Galaxy S animated logo.
I tried flash it again with odin, but when i plug the USB cable Windows not recognice the device and i can't flash it again with Odin.
I tried it in 3 computers and the error appears again.
I was able to enter on Recovery and Download mode, but now if y try enter on recovery i get the Link error (Phone , Warning Signal and Computer).
I always can enter in download mode, but can't do anything because i can't connect it to odin..
The trouble isn't reflash, the trouble if i can't detect the mobile in ODIN
Solved.
pulling off the battery around half an hour, Windows recognizes the phone whitout problem and i can install Movistar original rom to seek for any Usb problem and send it to the service
My phone is screwed up. I can't go into recovery mode. But I can go into Downloading Mode though. So I decided to flash a stock ROM but I can't cause my computer doesn't recognize my USB. Used to be able to. Restarted computer, re-installed drivers. used different computers but still nothing happened. USB NOT RECOGNIZED
how to get my phone back up
does the phone still work ?
No, it doesn't boot. Stuck in Galaxy S first screen before the boot animation.
Same thing happened to me not so long ago. Once it was in download mode I opened odin and it wouldn't recognise it so I then went straight into download mode again using 3 button combo and it writhed as far as I recall.
Hope this helps
Galaxy S - no point in writing rom or kernel constantly changing!
When I start Galaxy S I only see Clockworkmod text loading something and then it reboots.
When I try to enter Download mode, it does the same.
When I try to recovery, it does the same.
When I take battery off and insert USB cable and then battery, it shows that it starts charging but then it enters the bootloop. This should not be possible?
What to do next? Is the JTAG JIG only option and is it possible that it won't work?
Sort of the same here. My phone will start to the first samsung screen, shut off and reboot, and continue forever.
I tried flashing with odin but the phone shuts off before odin has a chance of flashing, any help? I would like to try out the android too, but the situation is forcing me back to apple phones.
I updated to CM 7.1 (2.3.7) from android 2.2 (stock)
On stock rom the key combinations did not work at first place. I had to go to download mode using: adb reboot download
Is this why I can't get to download mode? Since cyanogenmod does not touch the three-button-combinations?
Build a usb jig, Im confident it will work for you. Google it, you tube it, heres the link on this forum. http://forum.xda-developers.com/showthread.php?t=819551
My buddies phone was doing exactly what your phone is doing and I was able to use the jig to achieve DL mode and flash via odin. GL
Got the JIG.
It went straight to the download mode. Then reflashed to XXJVT.
Factory format and Cyanogenmod reinstall.
Works like a charm!
Thanks guys!
I tried to install sgs3 without root and i bricked my phone. I tried everything to make it work again (download mode while inserting battery, odin, except the usb jig)
The battery still charges and odin can see my device ( the port is yellow) but when i try to put the originial firmware odin loops at setup connection. (i used that rom earlier and it worked but i was abble to enter download mode)
Computer recognizes phone.
Can someone help me plss :crying:
Hello everyone I am sure that there is a lot of this thread going.
But I think mine is even worse.
the problem:
I rooted the device, everything worked fine ( did it with card reader - because my pc can not recognize the device had the problem a long time ago, somehow it worked then, but does not now, giving me the code 10 and 43
I think my USB port on the SAMSUNG might be damaged, because it does recharge but wont connect at all, tried kies, tried all the debugging modes, drivers, turning off the computer, rebooting all that stuff..)
The main problem is I flashed the cwm, rebooted, worked fine, then I clicked the do Backup thing and from then I can only go to yellow "downloading" or samsung logo, cannot even use that "Odin" because my USB is apparently damaged.. Any Ideas at all other than taking the phone and throwing it into the dumpster?
it is gt-s5830
my system is Win7-64bit
any help will be deeply appreciated ...
sincerely Fariel2012
Samsung logo freeze, cant recovery, can download mode (cant join to pc)
try with different usb cable
daniga74
Fariel2012 said:
Hello everyone I am sure that there is a lot of this thread going.
But I think mine is even worse.
the problem:
I rooted the device, everything worked fine ( did it with card reader - because my pc can not recognize the device had the problem a long time ago, somehow it worked then, but does not now, giving me the code 10 and 43
I think my USB port on the SAMSUNG might be damaged, because it does recharge but wont connect at all, tried kies, tried all the debugging modes, drivers, turning off the computer, rebooting all that stuff..)
The main problem is I flashed the cwm, rebooted, worked fine, then I clicked the do Backup thing and from then I can only go to yellow "downloading" or samsung logo, cannot even use that "Odin" because my USB is apparently damaged.. Any Ideas at all other than taking the phone and throwing it into the dumpster?
it is gt-s5830
my system is Win7-64bit
any help will be deeply appreciated ...
sincerely Fariel2012
Click to expand...
Click to collapse
Hi there
you will need to give a usb jigg service to your device and then flsah it back to stock using odin
SGA s5830 stuck @ boot logo
I follwed these steps before it stuck @ boot logo
1 rooted phone through root_S5830.zip file
2 then used 6.0.4.6-cooper_fix.zip cwm recovery
3 decided to flash Touchwiz-Resurrected_ROM_V1.0.zip rom
4 followed all steps to flash thrrough CWM recovery
phone reebots samsung.com logo>> samsung boot animation shows up>>samsung name appears again keeps glowing and phone restarts!!!
after it I tried 6-7 different roms then i tried to flash through odin but wasnt able to do so but failed the device showed up in odin but wasnt able to flash stock rom
then i decided to go for Phil touch recovery I installed Philtouch recovery and tried to flash a custom rom now I'm stuck again at boot name GALAXY ACE s5830 nothing goes further!!!
I searched over XDA and some guy quoted this problem is solvable by using odin and putting phone in downloading mode (vol- button+home button + Power on ) I am able to put my phone in downloading mode, but when i conncet it to PC it says USB device not recognized WTF!!!!!???? 10 mins ago i connected my Phone using same cable same port same odin now this ***** appears ???
I swapped PC's, Cables, ports everything nothings working , phone wont start stuck @ boot logo pls help ASAP :crying:
That's it.. You have hard bricked your phone that's dead recovery and dead download mode. Give your phone the usb jigg service which will force it to go to either the download mode or the recovery mode whatever you want.