After Oreo update of my TA-1004 it completely stacked in system starting, but after lot for tries I found working procedure to start recovery menu and I did factory reset.
Mobile is now working but sometimes when screen is locked, double tap works, but phone cannot be unlocked and after few seconds it restarts. It is more often when SIM card is in.
Any ideas what to try to do?
Related
Hello.
I'm opening this thread because my Diamond seems to be diying and I wanted to know if someone got an idea.
Yesterday, my phone suddendly rebooted without warning after a month.
I thought It was nothing, but the phone started to reboot allthe time. The phone boot, show my operator logo (befor the winmo loading screen), and then reboot again, again and again.
I decided to do a little Mtty maintenance and reflash (from internal memory). The phone reworked for a couple of hours and restarted to do a reboot loop. I thought the rom I was using was in fault.
Re Mtty maintenant and flashing the phone with mu Prange stock rom. Several hours léter, the phone restarted to boot.
So where I am ?
If I let the phone off (like a night), he will launch windows and will works between a couple of minutes from a couple of hours befoor rebooting. If I put the phone in bootloader mode It won't reboot and will wait with his beautiful rainbow screen. But if I leav the bootloader mode, reboot over reboot, yay !
When the phonedecide to boot completly,it's a regular soft reset, not a hard reset.
Did anyone here have an idea ? Thanks !
How often did you flash since you have your diamond ?
Try to reflash a radio. Maybe your flash memory is dead =/
It sounds like the rom image might be corrupted - I had this problem with a 28003 rom I tried in which the phone would take a hard reset - boot fine - reset and reload fine... and then whenever you tried to restart it after that it went into a boot loop that eventually came up with a screen saying "the phone cannot boot because of uncertified software or incorrect shutdown procedure"
I solved it by putting the phone into bootloader (switch on holding both power key and volume down key) - connecting it to my computer and reflashing it. It DOES NOT need a activesync connection in this mode but you do need the Hard-SPL on the phone (im running olinex 1.40)
hope that helps
Jemma
Thx JoOos and Jemmauk.
But I already tried to reflash the Radio and the rom Image.
I Tried 3 different Rom images.
One orange official , aztor re-evo and an another one.
But the phone don't display any errors. It will just never stop to reboot without saying a thing.
Same problem in a different thread
Have a look at http://forum.xda-developers.com/showthread.php?p=5279740.
A couple of days ago, while sitting on the dresser, my XT1053 crashed and has not been able to fully boot and stay alive since. It will give the "bootloader unlocked" message, start all of boot animations, get to the blue-green one and then crash. To get a reboot, I have to hold the power button for 10 seconds, or it just drains the battery. Every once an awhile, the security screen pops up and it will crash, or I can get in, the launcher and services say they have crashed, then the phone shuts off.
I have an unlocked bootloader, but not rooted and was on 4.4.4 before the crash. I can usually get into the bootloader menu, and to recovery. If it crashes, I usually have to restart and do a hard close to get into the menu.
Fastboot works. I've followed this guide: http://forum.xda-developers.com/showpost.php?p=53228057&postcount=148as well as the order in the .xml file that came with the 4.4.4 rom. Everything comes back "OK"
Is there something else that needs to be re-flashed to get it working?
The strange thing is that even though I have erased userdata and cache etc., on the rare occasions that I get beyond the boot animation, it still seems to have my custom message and the security pin. Is it possible that the cache and user data aren't actually getting erased? How do I check?
Any suggestions would be appreciated!
Hi All,
Sorry if this is asked before. I have a new Note 5 unlocked. I turned it on yesterday and started using it. Late at night, its screen froze. I tried pressing Power+Volume_Down buttons to restart the phone. The phone restarted but the the screen was black. Only the notification light was on (blue).
In the morning, the light was still on and the phone was froze. I tried restarting it and I succeeded it. Then I realized the phone was very, I mean veeeery slow. By the time, a firmware update notification popped up. I believe it was Marsmallow update. I hit the yes button. The phone started the update and was stuck at %24. Then it restarted itself. The update process starts over and when it reaches %24, it starts over.
This happened before with my note 4 when I tried to root it. This phone is brand new and is not rooted. However, I transferred my Google profile but I did not select to download my previous apps. So, I don't think it is rooting issue but stucking at the same percentage makes me nervous.
I tried to get into recovery mode but the button combination does not work at all. So I can neither factory reset nor clear the cahe partition. When I press Volume_Down+Home+Power buttons, a custom rom download screen appears but Volume_Up+Home+Power buttons do not work at all. I cannot shut off the phone. It constantly restarts itself, starts the update, fails at %24 and starts the process over again.
What might be the problem? How can I fix this?
Regards
Hi,
Try flashing some stockfirmware via Odin (ideally something of the same android version i.e. lollipop/marshmallow). Once it's installed you should be able to access recovery from which I strongly recommend clearing your cache afterwards as you've already suggested. If you are not worried about loosing any data, then flash new firmware that is inclusive of BL/CP/CSC files too (each one has a category for such in Odin). With the latter, by all means flash marshmallow etc. :good:
Regards
The phone was working fine, I did hard reset from the phone Setup menu, selected the WiFi network and the phone went into never ending (5-10 minutes) screen "Checking for updates... This may take a minute or two". There was no lock of any kind, no rooting, firmware flashing or anything - what could be wrong?
Went to boot reset menu wiped the cache and did one more hard reset - same thing.
just reboot the device. common issue.
Thanks!
Hello. After rebranding my phone from PRA-AL00X to PRA-LX1 it's stuck on the Factory reset screen after it gets to 99%. I don't know what to do. I can't enter fastboot either. But I have a question: why when I plug it in, when the factory reset screen is there, my PC makes a sound effect as it's connected to my phone (you know, the usual sound when you plug something into your PC). Can it still be saved? Thank you.
Probably a system partition size complication. Are you using RecoveryOreoNoCheck?
Read this or this.
Something weird happened. So, last night I left my phone to run out of battery. Today, after booting it again it worked. But it rebooted itself after it got into Android, and now it's stuck again on the factory reset process at 99%.
EDIT: I think I managed to figure it out. So, after my phone runs out of battery it restarts normally, into Android. After that I need to let it charge for some time, because of the low battery it may shutdown. I will update soon if I figure it out completely.
EDIT 2: It seems that after I enter my pin to unlock my device it reboots itself. Why is that?
Is there any way I can enter erecovery mode without enabling developer options and usb debugging? Because once I input my pin, my device restarts.
EDIT: Seems like I managed to enter my pin without my device restarting. I think it was restarting because the battery was low.
I have another question. Why after I manage to boot my phone, when I try to reboot to bootloader, it reboots, and enters again the Factory reset screen?
PoweredLights said:
I have another question. Why after I manage to boot my phone, when I try to reboot to bootloader, it reboots, and enters again the Factory reset screen?
Click to expand...
Click to collapse
Like I said in my previous post
Probably a system partition size complication. Are you using RecoveryOreoNoCheck?
Read this or this.
Click to expand...
Click to collapse
So as stated from the user on that link who solved the problem, try formatting the system partition then try to install the update again.
Regarding your other posts, if the update installation obviously failed or encountered some issues then by some coincidence it boots back, that doesn't mean it got fixed. The problem is still there and will become even a bigger problem, if it's not fixed.
You don't have to enable Developer Options or USB Debugging, to boot into eRecovery.
CrimsonBloodfang said:
Like I said in my previous post
So as stated from the user on that link who solved the problem, try formatting the system partition then try to install the update again.
Regarding your other posts, if the update installation obviously failed or encountered some issues then by some coincidence it boots back, that doesn't mean it got fixed. The problem is still there and will become even a bigger problem, if it's not fixed.
You don't have to enable Developer Options or USB Debugging, to boot into eRecovery.
Click to expand...
Click to collapse
The problem is, I can't enter bootloader nor erecovery. I'll try to factory reset with the phone booted up.
EDIT: After factory resetting from settings, when the phone was booted up, it works now. I tried to reboot it and it reboots fine, without the factory reset screen appearing. And thank you very much for your help. I will now try to install Oreo for PRA-LX1.
The only problem I have now, is: my system version is now named NRD90M test-keys.
EDIT: I fixed my phone. I reinstalled through eRecovery the newest available EMUI version and NRD90M test-keys dissapeared. Now it works fine, even if I am on Nougat. I am waiting for the EMUI 8 update, this time not forcing my phone to install it.
PoweredLights said:
The problem is, I can't enter bootloader nor erecovery. I'll try to factory reset with the phone booted up.
EDIT: After factory resetting from settings, when the phone was booted up, it works now. I tried to reboot it and it reboots fine, without the factory reset screen appearing. And thank you very much for your help. I will now try to install Oreo for PRA-LX1.
The only problem I have now, is: my system version is now named NRD90M test-keys.
EDIT: I fixed my phone. I reinstalled through eRecovery the newest available EMUI version and NRD90M test-keys dissapeared. Now it works fine, even if I am on Nougat. I am waiting for the EMUI 8 update, this time not forcing my phone to install it.
Click to expand...
Click to collapse
Hi,
I have the same issue with Phone Always going to factory reset.
Only draining it makes it boot up normally.
I also did the factory reset from within android. Now it does a factory reset lowlevel and again it hangs on 99%.
Did you also have this?