Hi
i have a oreo version. I tried to unroot my phone and I got the error. What can I do? i would greatly appreciate it.
error func boot image
Thank you
Related
hi there, i tried to unroot my one today but it stucks at 4 warnings sign. i have read some posts here that i should reflash RUU, but i got message "could not allocate......" "cannot load RUU". anyone can help? any help would be appreciated.
Hey all
Just got a gen 2 2014.Rooted,unlocked bootloader and installed twrp but when I try to install any of the roms for my model xt1068 I get an error "updater process ended with error 7".
Iv tried rerooting,factory restores, reinstalling different versions of twrp and nothing works.Another strange think,I cant power the phone off it just reboots .
Any help with this would be greatly appreciated .If any more info is needed ask away.
Hi, yesterday i tried to install the Dolby Atmos and my P10 get bricked.
Now i get the error:
Error Mode
Attention!
Please update system again
Error!
Func No: 11 (recovery image)
Error No: 2 (load failed!)
I am using the Huawei Multi Tool, but it asks me for the boot image. Does anyone know where i can find the boot image or how can i unbrick it VTR-L29C432B365? I allready tried most of the posts, unbrick, debrand etc, but the result is the same, when i power on i get the same message
And my phone during this situation seems not to be charging!!!
Thanks for any help.
Do a bit of SEARCHING here on P10 thread ...there may be 3-4 thread with fixes for your problem...
iknow cuz i had that problem too .....aaaaaaaand its fixed
Hello I have a VTR-L09 (Australian) with stock Pie on it. I unlocked the bootloader with the code from Huawei. Then I installed the openkirin AOSP 10 Preview 2 on it which led me to not being to connect to the internet and only occasionally being able to make calls, so that was junk...
Then I tried to install TWRP and FutureROM, but something must have gone wrong (pos user error) and now I can't even use the erecovery as it, after getting the last firmware, throws a "can't verify" error. I since tried to install TWRP via fastboot, but even though it reports success, when I try to boot into TWRP recovery all I get is a screen similar to the fastboot screen only with the below message
ERROR MODE
Attention!
Please update system again
Error!
Func NO: 11 (recovery image)
Error NO: 2 (load failed!)
When I try to boot iut just gets me to the FASTBOOT&RESCUE MODE screen
Is the phone bricked? Where to from here to get it back on stock ROM?
Thank you kindly!!!
Perhaps the device cannot verify the recovery image.
If bootloader is still unlocked, try to flash stock recovery and see what happens.
Ive a problem now with my RN9. I unlocked the bootloader but did not immediately flash a custom rom. I made steps to try install PixelPlus but in the process of trying to install TWRP Ive hit a snag. Im not sure what Ive done wrong but Im in a boot loop. The phone either bootloops or I can get to Fastboot logo.
I tried following this video -
- Unbrick Redmi Note 9 or Redmi 10X 4G (merlin) using SPFlash Tool
When I select the DA, Scatter and Authentication file and go to "firmware upgrade" I get the error - "Partition [recovery ] No image file Exist!
My fear is somehow I've wiped the file from the phone. Im going round in circles trying to find a solution but im stuck.
If anybody has any help, Id greatly appreciate it!
Thanks for reading.