Hello, I start by apologizing for my English, I am French and go through google translate...
I don't know if i'm in the right place
So here is my concern, when I put my ASUS RoG Phone3 to charge, it becomes hypersensitive to the touch, when I write an SMS it doubles, see triple, my taps on the screen. But when I unplug it it goes back to normal... This is a big problem for me, because the phone becomes almost unusable while charging ... what can I do?
the phone has been doing this to me since I bought it, the screen is not damaged and has never fallen to the ground.
thank you for your future answers.
Related
My camera led light just started acting funny an hour ago. It turned on and it si now impossible to turn the damn thing off. It still stays on when the phone is turned off. I've tried removing the battery and then put it back again. As soon as the battery is in, the light turns on again. I've tried a soft reset and ultimately a hard reset. Light remains on.
Don't want to have to go to Sony for this because I bought the phone off the bay a month ago and therefore don't have a receipt so it won't fall under warranty. Anyone have any ideas? What a pisser.
hi,same here
I think its a hardware issue where the cables have been short and are giving direct connection. I dont know if this will work but try to tap the phone a little hard on your palm. If its just a loose contact it might get sorted. This is a very crude way.
You guys want help or just venting air?
Great story.... so ?!
If you guys want venting off air, that was it! If you are looking for help however, then KINDLY state some info, like:
what the frak is the phone model, firmware, recently flashed, if so to what. Branded or unbranded, built date, etc.!
After that, perhaps a few answers can be expected
MichaeltheImage: I doubt that in this case this had anything to do with software because of the fact that it remained on after a boot or when the phone is off.
Moleculez: Yesterday it ended up fading by itself after 2 or 3 hours. This morning it started again as I removed the battery. Tapped the led side of the phone on my palm a few times; and it worked. Thanks.
"Anything mechanical, give it a good bash."
Incase someone is still looking for a way to fix this problem:
I managed to pry the plastic covering off of the camera lense/ LED with a needle.
All it took was a slight nudge on the LED cluster to reposition it. It was situated slightly off to one side, causing the short circuit which lead to the LED being constantly lit.
Problem is, in my initial frustration I poked the LED and broke it which, as a result of the short, meant that although the LED was no longer lit it still drew power from the battery.
The only way I know that the later fix worked was by using a power consumption monitoring tool to verify that the LED (and the short circuit) was no longer drawing power.
Awesome.
Hey guys, I was wondering if somebody would be able to maybe help me diagnose the fault\problem part with my non-working diamond...
Basically I went to a club one night and the place was unbelievably steamy / humid. My phone was working one minute and then the next it wouldnt display anything on the LCD. The backlight was working however.
Since then I havent been able to get an image on the screen although when trying to turn it on, it seems to go through its startup sequence (backlight -> vibration -> beep (i think))
I havent had any power to the phone since a day after it broke (a few weeks ago).
I'd like to get it back working again but dont know exactly what part i would need to replace. I'm fairly competent with electronics .
Any help/advite would be appreciated!
Haha, ok that's odd...
I've plugged it into my pc to get some data files off about an hour ago.. forgot about it and just looked at it now and the screen is displaying!
It is displaying and accepting input although it was flickering at first (like pixel shifting). but i pressed the power button to standby the screen and pressed it again and the display is fine with no flickering ?
Ive moved the phone about and shook it quite hard to see if there's any loose connection but the display still seems fine..
Anybody have any ideas as to what it may be?
I'm not going to deem it as fixed until I know what the problem was/is lol
cheers guys
Ok screen actually keeps flickering nonstop, and sometimes 'fades away' to gray/white/black
comes back after a few seconds though
Looks like a faulty connector?
Hello
One night I was using the phone without doing anything special , some video watching . Phone went dark, tried to reboot. Blank Screen and the capacitive buttons flash. Left it to charge all night, in the morning it started but after I pressed the lock button blank screen but phone still working and receiving input.
Took the battery and SD card out left it for 30 seconds then started it again, Stuck at LG logo. Repeat , phone started ... Pressed lock button once then again to unlock , screen wouldn't start.
Used LG Mobile Update recovery tool to restore it ... Didn't solve problem. Sometimes it does not even start , just flashes buttons, other times it does without screen and last all works even the screen until first time goes dark , in the last two cases I can use LG On-Screen Phone without trouble, in doing so I installed a proximity sensor test app to see if it was causing my screen to not come back on , the sensor looked fine.
Facts:
1. Two day old Optimus Black p970, worked like a charm until stated problem
2. The app that checked proximity sensor showed the sensor to be free when my hand wasn't on it
3. The warranty laws in my country are idiotic so I would do or buy anything rather than send it so they can give me a new one in 3 months.
4. Tried another battery from another Optimus, fully charged nothing different.
5. Stock rom.
Do any of you fine people have some ideas on how to fix this? Thanks in advance
Hi there...
Sometime ago [1 year and a half or so~] I worked at a cell refurbishing facility [there were samsung, motorola and palm devices from sprint] and that problem you have was quite usual. Blank screen, still the phone is somehow usable like reciving calls...
There's this thing called "flex" which is the connector between board and display and that is what we fix, most of the time not even "fix it" just getting it in the right place...
This happen because of excesive use in those sliding or clamshell devices, in OB could be for overheating, you could try to fix it yourself or pay $20 usd [that's what it cost here]
Would that connector explain the fact that sometimes it doesn't start at all? hmm I am thinking now and I guess if it moves and somehow the phone feels it has not display connected it could fail to start... Anyhow thank you
actually yes, it could be only for the flex [some devices don't start at all when not having display or keyboard if there's any] but since our OB is not sliding nor clamshell type probably was overheating.
you say you have stock rom, well now I'm using CM7 but when I was at stock and after using the phone a few minutes it felt warm and some more minutes [like playing gunbros where you need to use both hands and a lot of movement] it was really hot and had to stop playing for a while.
what I'm trying to say is that because of overheating flex could have moved, but because of overheating too may have move something else, you couldn't belive the huge number of micro-things that reside in the board.
so if it's only the flex, it's an easy task to do, just unplug and plug again, but if it's something else it's quite hard to know just looking at it, you need to do some electric measures and stuff, the recomendation is to take it to a tech center or something
Hi. I Have same issue. Two times when i press power buton, butons flashing and screen still black. Phone not responding. I must remove baterry.
Sent from my LG-P970 using Tapatalk
Hi there, got the same problem too with my optimus black. Screen goes flickering, shut down don't do any good, and the phone temperature is kinda hot. But in my case it work after I clean some cache and data in the phone storage through LG OSP. After that, the phone temperature back to normal and the phone screen back to normal also. I believe that in my case the phone is overheated.
Hi guys.
Had a galaxy s for 3 months now. Everything seems fine, till yesterday night. The lower part of the screen is not responding. The letter "F" on the keyboard is un-pressable, but went back to normal a few mins later.
Later....
The next morning(Today), had notifications for sms, and this time, the jigsaw notification is un-pressable as well. Its on the same part as the letter "F" in the keyboard. However, its back to normal after a few mins.
I have a hunch that its software error, but might even be a hardware one since its on the same location. Would appreciate any help/experience from other users. Im just afraid this would happen again in a time of need...
Sorry for bad english
Bump for more people to see
i have a similar problem, too
a little part of the touchscreen doesnt work
think about a line from left to right in 0.5cm thickness just below the top of the screen that doesnt respond to touch
i checked with *#*#2664#*#* and that part does not respond
im curious if this will end up in a whole screen replacemnet
did you solve it ?
Hi, I recently dropped my phone and now the screen is blank. When i turn on the phone the whole screen is blank, the phone vibrates when it powers on but nothing is visible. Even when i get calls i cant attend them. There are no scratches or cracks on the screen after the fall. This is the first time i have experienced this and any help is appreciated. Thank you
I think the LCD is connected to the phone's main board by a connector that snaps into place. If you dropped the phone, I think it's a possibility that this connector could have popped out. It would only take a few minutes to open it and check for this. http://www.youtube.com/watch?v=0A4zbBKkcKU Skip to 2 minutes and 50 seconds into the video and you will see this connector.
Unfortunately it's possible that when you dropped it, the LCD screen was damaged even though you can't visibly tell just by looking at it.
thank you very much will try it