One day my gt-i8190 just turned off didn't turn on fore a while (couple of months) left on the shelve and one day after charging it turns on in a Samsung logo boot loop and no recovery access ,when in download mode ,flashing anything besides param or original pit will show this massage in red letters : movi_write card_status:2 (x)start_blk:xxxxxx , I've tried odin and smart switch pc all the same
Related
Day 1
Hard reset my device. After rebooting, my tab stuck at Samsung logo and vibrating. But still can enter download mode
Day 2
The device still stuck at Samsung logo and can enter download mode. Then i tried flashing with dbdata.rfs PDA via Odin to try my luck. After reboot , the same things goes up,stuck at Samsung logo. After few minute , i tried flashing the GT-P1000_PRT_P1000XWJQ9_P1000PRTKL1_P1000XXJPZ ROM.During flashing(i don't know either it's finish already or not or either battery problem.Before flash i noticed the battery has low power about less than 10%) ,the device suddenly shutdown by it self. After the shutdown, the device goes black and try to reboot again,nothing comes up.Then i thought the battery was fully drained out, then i decide to charge up till morning.
Day 3
Trying to power up the device but nothing happen.Holding the power button about 20 sec and nothing happen but the device feel a little bit hot at the back.But when i plugged in to USB, it can detect the device and show the MTP Installation has failed.But at My computer shows 2 removable disk which comes from the device it self.After i pressed it,it say Please insert a disk to removable disk.
Can anyone please help me?Help my Old Tab.
Sounds like you have bricked your device. And I mean a real brick, not a "soft brick" as some people like to call it.
You should never try and flash your device if you have low battery as power could fail and corrupt your bootloader.
If you cant get into recovery or download mode your screwed and need to send it away for JTAG fix or board replacement.
Zelz said:
Day 1
Hard reset my device. After rebooting, my tab stuck at Samsung logo and vibrating. But still can enter download mode
Day 2
The device still stuck at Samsung logo and can enter download mode. Then i tried flashing with dbdata.rfs PDA via Odin to try my luck. After reboot , the same things goes up,stuck at Samsung logo. After few minute , i tried flashing the GT-P1000_PRT_P1000XWJQ9_P1000PRTKL1_P1000XXJPZ ROM.During flashing(i don't know either it's finish already or not or either battery problem.Before flash i noticed the battery has low power about less than 10%) ,the device suddenly shutdown by it self. After the shutdown, the device goes black and try to reboot again,nothing comes up.Then i thought the battery was fully drained out, then i decide to charge up till morning.
Day 3
Trying to power up the device but nothing happen.Holding the power button about 20 sec and nothing happen but the device feel a little bit hot at the back.But when i plugged in to USB, it can detect the device and show the MTP Installation has failed.But at My computer shows 2 removable disk which comes from the device it self.After i pressed it,it say Please insert a disk to removable disk.
Can anyone please help me?Help my Old Tab.
Click to expand...
Click to collapse
Try this:
start odin, and press power + volume down for at least 5 seconds, plug to your computer
Odin should recognize your tab. Flash again. Btw jq8, sithout the correct kernel is not for p1000n/m/l.
What u did on day 3 was ALMOST right. But you didn't press the volume down. Hence you didn't go to download mode.
P.s. if you post this in the Q&Asection, we could hv helped you earlier.
today i wanna flash a 3.2.0(P7100BULB4) rom to my tab , unlock and rooted
1.I open odin V1.8.5, put the bootloader and pda , then odin shows PASS and success ；
2.waiting for the tab rebooting,it tunes to an green android with a triangle and a ！in it；
3.I turn off the power then holding on volume + with power ， that didint comes the digging mode but show some words：Booting recovery kernet image .after 30 seconds it turns to the green andriod again
this almost drive my mad , looking for help, who can help me
175553629 said:
today i wanna flash a 3.2.0(P7100BULB4) rom to my tab , unlock and rooted
1.I open odin V1.8.5, put the bootloader and pda , then odin shows PASS and success ；
2.waiting for the tab rebooting,it tunes to an green android with a triangle and a ！in it；
3.I turn off the power then holding on volume + with power ， that didint comes the digging mode but show some words：Booting recovery kernet image .after 30 seconds it turns to the green andriod again
this almost drive my mad , looking for help, who can help me
Click to expand...
Click to collapse
Its still with stock recovery; wait a while, the tablet will reboot by itself into normal mode
Check the screen showing the tablet name; if it shows an unlocked lockpad, the bootloader is unlocked (if you missed it, do a reboot to check)
If the bootloader has been successively unlocked , go to here, take the p3 package, flash RECOVERY with it using odin, and that green android screen will be gone, you can now reboot to ClockworkMod recovery.
wait
The same happened to me with this version of android, and the key was to wait, now I'm not sure if ten o more minutes, but, like pruano says, you only have to wait and it will boot for itself.
Greetings!
pit file
thx the two nice guys
now who has a correct pit file,if u dont mind to send it to my Email address:[email protected] or just give me a website,i will mange it myself
I have a Galaxy Tab 8.9 GT-P7300, always when i turn it on appears the samsung galaxy tab 8.9 logo and immediately shows a red text in the left top corner that says:
AccessParamData: Fail to NvStorMgrParatitionQueryStat![err:0x1000005]
InitParamData: Fail to AccesParamData_write![err:0x1000005]
OpenParam: Fail to SetDefaultParamData![err:0x1000005]
AccessParamData: Fail to NvStorMgrParatitionQueryStat![err:0x1000005]
SetParam: Fail to AccessParamData?write![err:0x1000005]
Error -> SetParam(ParamIndex_secure)![err:0x1000005]
ReadPartition_odion: Error to NvStorMgrPartitionQueryStat![err:0x1000005]
Check_OTA_MAGIC: Error to ReadPartition?odin![err:0x1000005]
After that goes directly to downloading mode with the following massage:
ODIN3 Download Mode
(Protocol v2.1)
Reason: No Kernal
Secure Mode: Secure
Custom Binary Download: No (0 counts)
Current Binary -> Samsung Official
Waitting USB Cable...
Downloading...
Do not turn off the target!!
And If i try to turn on pressing Power and Vol - button it shuts down. I cant get in to recovery mode to make a factory restore.
I dont know why its happening this but i will really appreciated some help to solve this issue.
I tried flashing the latest firmware with Oden and it failed, when I disconnected the phone and tried to put it back into download mode it comes up with 2 lines of small text in top left of screen then screen goes blank for a few seconeds then comes up with a list of stuff in blue red and green text with a little android in the middle of the screen with Kernal Panic
Upload Mode to the right of the andriod.
I can not turn the note 9 off, or figure out how to get back into recovery mode or download mode now. and the battery was nearly full when this happened , when the screen goes blank again after a few minutes the led flashes, if I press any of the volume keys or the power button the screen comes back on for a few minutes and while the screen is displaying the message the LED doesnt blink, then two minutes or so the screen times out and LED blinks again.
if I hold the btton down to try and go into recovery mode it reboots after about 10 seconds, shows the normal Samsung boot screen then displays the 2 lines of text at the same time which are in pink, then goes to the error screen I mention above
PLEASE HELP
Is going to take forever for this battery to drain and the unit shut off so I can try to boot into recovery or download mode...
HUGE thanks in advance
Hi! I got this problem too!
I was following guideline in this thread https://forum.xda-developers.com/galaxy-note-9/how-to/guide-change-note-9-csc-easy-guide-t3879473
I was following the procedure, but in very last step while flashing new firmware something happened to ODIN, it failed to flash it. I tried to restart the phone, but it entered KERNEL PANIC UPLOAD MODE. I was trying to get of this, but I was only able to enter recovery mode which didn't work properly either. It was indefinitely looping between installing update screen and other screen with error messages.
If I try to Volume down power for some time, I get POWER RESET OR UNKNOWN UPLOAD MODE.
So, no way out to get into download mode again.
Hi ckhaustralia, did you end up getting some help or an answer about the kernel panic mode issue with uour Note 9 problem you listed above? I have the same exact issue, except the reason why the firmware flash failed in my scenario was due to the charging port which I believe had a faulty sensor because I got a message half way through the flash indicating there "moisture" in the port. Now no matter what I have tried, I cannot boot into download mode to try and fix it. I think the only possible way would be to use something like a ZX3 box but it would be great to hear from someone knowledgeable within XDA?
A friend came in with his tablet that will no longer boot, it will just sit at the verizon logo, he says he took it to a repair shop and they could not fix it. Can't enter recovery only download mode, when I press all the buttons to kick it out of download mode sometimes it will boot to a screen with a small robot and yellow letters that say power pressed 7 seconds and "upload". Port numbers in download mode and the weird upload are different. I can only flash eng aboot or pit anything else gives me the "MDM Mode Can't Download" message. I got engineering fw and regular fw none will flash. It does say "Samsung Official" and "FRP Lock Off" in download mode. That's all I got.
Since this seems to be a difficult subject... Does anybody know where the testpoint is?
It sems it is all in the aboot... LOAD:8F682BFC aMdmMode_CanTDo DCB " MDM MODE. CAN'T DOWNLOAD ",0
Any help guys?